An air burst or airburst is the detonation of an explosive device such as an anti-personnel artillery shell or a nuclear weapon in the air instead of on contact with the ground or target. The principal military advantage of an air burst over a ground burst is that the energy from the explosion (as well as any shell fragments) is distributed more evenly over a wider area; however, the peak energy is lower at ground zero.
Air burst artillery has a long history. The shrapnel shell was invented by Henry Shrapnel of the British Army in about 1780 to increase the effectiveness of canister shot. It was used in the later Napoleonic wars and stayed in use until superseded in Artillery of World War I. Modern shells, though sometimes called "shrapnel shells", actually produce fragments and splinters, not shrapnel.
Air bursts were used in the First World War to shower enemy positions and men with shrapnel balls to kill the largest possible number with a single burst. When infantry moved into deep trenches, shrapnel shells were rendered useless and high-explosive shells were used to attack field fortifications and troops in the open. The time fuses for the shells could be set to function on contact or in the air, or at a certain time after contact.
Early anti-aircraft warfare used time fuses to function when they reached the estimated altitude of the target. During World War II a "proximity fuze" was developed for antiaircraft use, controlled by a Doppler radar device within the shell that caused it to explode when near the target. The idea was later adapted for use against ground targets.
During the Vietnam War, air bursting shells were used to great effect to defend bases. This tactic was known as "Killer Junior" when referring to 105 mm or 155 mm shells, and "Killer Senior" when employed with larger howitzers.
Some anti-personnel bounding mines such as Germany's World War II "Bouncing Betty" fire a grenade into the air, which detonates at waist level, increasing the blast radius and harm inflicted by detonation, shock wave, and flying splinters.
This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.
The explosive yield of a nuclear weapon is the amount of energy released such as blast, thermal, and nuclear radiation, when that particular nuclear weapon is detonated, usually expressed as a TNT equivalent (the standardized equivalent mass of trinitrotoluene which, if detonated, would produce the same energy discharge), either in kilotonnes (kt—thousands of tonnes of TNT), in megatonnes (Mt—millions of tonnes of TNT), or sometimes in terajoules (TJ). An explosive yield of one terajoule is equal to .
The effects of a nuclear explosion on its immediate vicinity are typically much more destructive and multifaceted than those caused by conventional explosives. In most cases, the energy released from a nuclear weapon detonated within the lower atmosphere can be approximately divided into four basic categories: the blast and shockwave: 50% of total energy thermal radiation: 35% of total energy ionizing radiation: 5% of total energy (more in a neutron bomb) residual radiation: 5–10% of total energy with the mass of the explosion.
A hypocenter or hypocentre (), also called ground zero or surface zero, is the point on the Earth's surface directly below a nuclear explosion, meteor air burst, or other mid-air explosion. In seismology, a hypocenter of an earthquake is its point of origin below ground; a synonym is the focus of an earthquake. Generally, the terms ground zero and surface zero are also used in relation to epidemics, and other disasters to mark the point of the most severe damage or destruction.
We introduce a new low-temperature (280 °C) parylene-to-SiO2 bonding process with high device yield (>90%) for the fabrication and integration of high-pressure-rated microfluidic chips. Pull tests demonstrate a parylene-to-SiO2 bonding strength of 10 ± 3 M ...