Microscale chemistry (often referred to as small-scale chemistry, in German: Chemie im Mikromaßstab) is an analytical method and also a teaching method widely used at school and at university levels, working with small quantities of chemical substances. While much of traditional chemistry teaching centers on multi-gramme preparations, milligrammes of substances are sufficient for microscale chemistry. In universities, modern and expensive lab glassware is used and modern methods for detection and characterization of the produced substances are very common. In schools and in many countries of the Southern hemisphere, small-scale working takes place with low-cost and even no-cost material. There has always been a place for small-scale working in qualitative analysis, but the new developments can encompass much of chemistry a student is likely to meet.
There are two main strands of the modern approach.
One is based on the idea that many of the experiments associated with general chemistry (acids and bases, oxidation and reduction, electrochemistry, etc.) can be carried out in equipment much simpler (injection bottles, dropper bottles, syringes, wellplates, plastic pipettes) and therefore cheaper than the traditional glassware in a laboratory, thus enabling the expansion of the laboratory experiences of students in large classes and to introduce laboratory work into institutions too poorly equipped for standard-type work. Pioneering development in this area was carried out by Egerton C. Grey (1928), Mahmoud K. El-Marsafy (1989) in Egypt, Stephen Thompson in the US and others. A further application of these ideas was the devising by Bradley of the Radmaste kits in South Africa, designed to make effective chemical experiments possible in developing countries in schools that lack the technical services (electricity, running water) taken for granted in many places.
The other strand is the introduction of this approach into synthetic work, mainly in organic chemistry.
This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.
DLC coatings are often deposited on Si and Cr based adhesion-promoting interlayers to mitigate stress at the DLC/substrate interface. Interlayers reduce the likelihood of mechanical coating delaminati