Influence of chelating agents on the tribocorrosion of tungsten in sulphuric acid solution

À propos
Confidentialité
Mentions légales

Graph Chatbot

Publications associées (31)

Frequent new particle formation over the high Arctic pack ice by enhanced iodine emissions

Julia Schmale, Andrea Baccarini

In the central Arctic Ocean the formation of clouds and their properties are sensitive to the availability of cloud condensation nuclei (CCN). The vapors responsible for new particle formation (NPF), potentially leading to CCN, have remained unidentified s ...

Nature Research2020

Data Science Based Mg Corrosion Engineering

Félix Benedito Clément Musil, Robert Horst Meissner

Magnesium exhibits a high potential for a variety of applications in areas such as transport, energy and medicine. However, untreated magnesium alloys are prone to corrosion, restricting their practical application. Therefore, it is necessary to develop ne ...

2019

Corrosion Mechanisms of Diamond-like Carbon Coated Interlayers & Interfaces

Emilija Ilic

Diamond-like carbon (DLC) coatings can improve the wear resistance of articulating implants. However despite successful in-vitro testing, some DLC coated joint replacements had to be revised prematurely, mainly due to coating delamination induced by corros ...

EPFL2019

Silicon Corrosion in Neutral Media: The Influence of Confined Geometries and Crevice Corrosion in Simulated Physiological Solutions

Stefano Mischler, Patrik Schmutz, Roland Hauert, Emilija Ilic

Silicon (Si) based implantable components are widely used to restore functionalities in the human body. However, there have been reported instances of Si corroding after only a few years of implantation. A key parameter often overlooked when assessing Si s ...

2019

The corrosion rate and microstructure of Portland cement and calcium aluminate cement-based concrete mixtures in outfall sewers: A comparative study

Karen Scrivener

This paper presents a comparative study on the corrosion rate and microstructural characteristics of Portland cement (PC) and calcium aluminate cement (CAC)-based concrete mixtures subjected to microbially-induced sulphuric acid (biogenic H2SO4) attack for ...

Pergamon-Elsevier Science Ltd2019

Application of Time Series Methods on Long-Term Structural Monitoring Data for Fatigue Analysis

Eugen Brühwiler, Bartlomiej Wojciech Sawicki, Morteza Ahmadivala

Structural health monitoring (SHM) can be employed to reduce uncertainties in different aspects of structural analysis such as: load modeling, crack development, corrosion rates, etc. Fatigue is one of the main degradation processes of structures that caus ...

2019

H2-fuelled microbial metabolism in Opalinus Clay

Rizlan Bernier-Latmani, Luca Loreggian, Niels Burzan, Aislinn Ann Boylan, Carla Perez Mon

In Switzerland, the Opalinus Clay formation is considered the most likely host rock for a deep geological repository for nuclear waste. In deep geological repositories, H2 is expected to be the most abundant gas formed from the degradation of waste and fro ...

2019

On-Site Purification of Copper-Contaminated Vanadium Electrolytes by using a Vanadium Redox Flow Battery

Hubert Girault, Heron Vrubel, Alberto Battistel, Christopher Raymond Dennison, Danick Reynard

Corrosion of carbon-based electrodes and bipolar plates is a major hurdle and can be a cause of failure in commercial vanadium redox flow batteries (VRFBs). Carbon corrosion was found to occur in a commercial VRFB (10 kW/40 kWh), whereby cracks through bip ...

WILEY-V C H VERLAG GMBH2019

Tribological and tribocorrosion behavior of nickel sliding against oxide ceramics

Stefano Mischler, Anna Neus Igual Muñoz, Shoufan Cao, Junxiao Du

Nickel is widely used as a coating material in electroplating because of its good corrosion and wear resistance even at high temperature. Tribocorrosion has been identified as one of the main degradation mechanisms of nickel. This study evaluated the tribo ...

ELSEVIER SCIENCE SA2019

'Green' Cr(iii)-glycine electrolyte for the production of FeCrNi coatings: electrodeposition mechanisms and role of by-products in terms of coating composition and microstructure

Stefano Mischler, Johann Michler, Enrico Bertero

The electrodeposition of stainless steel-like FeCrNi alloys for miniaturised devices is appealing as it would allow combining excellent material properties (e.g. corrosion resistance, hardness, biocompatibility) at low-cost. However, conventional baths oft ...

2019

Page 3 sur 4