Advanced Techniques in Optical Diffraction Tomography

In this thesis, we study the 3 challenges described above. First, we study different reconstruction techniques and assess the fidelity of each reconstruction results by means of structured illumination and phase conjugation. By reconstructing the 3D refractive index of the sample using different algorithms (i.e. Born, Rytov, and Radon) and then perform a numerical back-propagation of experimentally measured structured illumination pattern we are able to assess the fidelity of each reconstruction algorithms without prior information about the 3D RI distribution of the sample.The second part of the thesis is concerned with the 3D reconstruction of samples using intensity-only measurements which the need to holographically acquire them. We show that using intensity-only measurements, we could still be able to reconstruct the 3D volume of the sample with edge-enhanced effects which was proven useful for drug delivery applications in which nano-particles were identified on the cell membrane of immune T-cells in a drug delivery studies. Such reconstruction technique would result in more robust imaging system where the commercial imaging microscope systems can be incorporated with LEDs for high-quality speckle noise-free imaging systems. In addition, we show that under certain conditions, we can be able to reconstruct the 3D refractive index distribution of different samples.The third part of the thesis is contributing to high-speed complex wave-front shaping using DMDs. In that part, new modulation technique is demonstrated that can boost the speed of the current time-multiplexing techniques by a factor of 32. The modulation technique is based on amplitude modulation where an amplitude modulator is synchronized withvthe DMD to modulate the intensity of each bit-plane of an 8-bit image and then all the modulated bit-planes are linearly added on the detector. Such modulation technique can be used not only for structured illumination microscopy but also for high-speed 3D printing applications as well as projectors.The last part is concerned with using deep learning approaches to solve the missing cone problem usually accompanied with optical imaging due to the limited numerical aperture of the imaging system. Two techniques are discussed; the first is based on using a physical model to enhance the quality of the 3D RI reconstruction and the second is based on using deep neural network to solve the missing cone problem.