Delta-sigma (ΔΣ; or sigma-delta, ΣΔ) modulation is an oversampling method for encoding signals into low bit depth digital signals at a very high sample-frequency as part of the process of delta-sigma analog-to-digital converter (ADCs) and digital-to-analog converters (DACs). Delta-sigma modulation achieves high quality by utilizing a negative feedback loop during quantization to the lower bit depth that continuously corrects quantization errors and moves quantization noise to higher frequencies well above the original signal's bandwidth. Subsequent low-pass filtering for demodulation easily removes this high frequency noise and time averages to achieve high accuracy in amplitude.
Both ADCs and DACs can employ delta-sigma modulation. A delta-sigma ADC (e.g. Figure 1 top) encodes an analog signal using high-frequency delta-sigma modulation and then applies a digital filter to demodulate it to a high-bit digital output at a lower sampling-frequency. A delta-sigma DAC (e.g. Figure 1 bottom) encodes a high-resolution digital input signal into a lower-resolution but higher sample-frequency signal that may then be mapped to voltages and smoothed with an analog filter for demodulation. In both cases, the temporary use of a low bit depth signal at a higher sampling frequency simplifies circuit design and takes advantage of the efficiency and high accuracy in time of digital electronics.
Primarily because of its cost efficiency and reduced circuit complexity, this technique has found increasing use in modern electronic components such as DACs, ADCs, frequency synthesizers, switched-mode power supplies and motor controllers. The coarsely-quantized output of a delta-sigma ADC is occasionally used directly in signal processing or as a representation for signal storage (e.g., Super Audio CD stores the raw output of a 1-bit delta-sigma modulator).
When transmitting an analog signal directly, all noise in the system and transmission is added to the analog signal, reducing its quality. Digitizing it enables noise-free transmission, storage, and processing.
This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.
This course is aimed at providing engineers with up-to-date information on important current issues of design in analog and mixed-mode integrated circuits. In general, the content of the lectures cove
Comparaison entre les systèmes à composants discrets et les systèmes intégrés. Introduction aux systèmes électroniques numériques et analogiques et à leur interfaçage. Analyse sous forme d'un projet
The course is covering following aspects: MOS Transistor Modeling for Low-Voltage and Low-Power Circuit Design, Noise Performance of Elementary Transistor Stages, Stability of Operational Amplifiers,
A novel frequency synthesizer with a strong emphasis on low-power consumption (2mW) was developed for this thesis. A BAW-resonator was used for the design of the high-frequency oscillator. The BAW's h
In this note we provide an alternative way of defining the self-adjoint Hamiltonian of the harmonic oscillator perturbed by an attractive delta'-interaction, of strength beta, centred at 0 (the bottom
This paper describes an all-digital backscatter modulation approach leveraging delta-sigma modulation (DSM) to improve the in-channel spectral characteristics of orthogonal frequency division multiple