In routing, the forwarding plane, sometimes called the data plane or user plane, defines the part of the router architecture that decides what to do with packets arriving on an inbound interface. Most commonly, it refers to a table in which the router looks up the destination address of the incoming packet and retrieves the information necessary to determine the path from the receiving element, through the internal forwarding fabric of the router, and to the proper outgoing interface(s).
In certain cases the table may specify that a packet is to be discarded. In such cases, the router may return an ICMP "destination unreachable" or other appropriate code. Some security policies, however, dictate that the router should drop the packet silently, in order that a potential attacker does not become aware that a target is being protected.
The incoming forwarding element will also decrement the time-to-live (TTL) field of the packet, and, if the new value is zero, discard the packet. While the Internet Protocol (IP) specification indicates that an Internet Control Message Protocol (ICMP) time exceeded message should be sent to the originator of the packet (i.e. the node indicated by the source address), the router may be configured to drop the packet silently (again according to security policies).
Depending on the specific router implementation, the table in which the destination address is looked up could be the routing table (also known as the routing information base, RIB), or a separate forwarding information base (FIB) that is populated (i.e., loaded) by the routing control plane, but used by the forwarding plane for look-ups at much higher speeds. Before or after examining the destination, other tables may be consulted to make decisions to drop the packet based on other characteristics, such as the source address, the IP protocol identifier field, or Transmission Control Protocol (TCP) or User Datagram Protocol (UDP) port number.
Forwarding plane functions run in the forwarding element.
This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.
In network routing, the control plane is the part of the router architecture that is concerned with drawing the network topology, or the information in a routing table that defines what to do with incoming packets. Control plane functions, such as participating in routing protocols, run in the architectural control element. In most cases, the routing table contains a list of destination addresses and the outgoing interface(s) associated with each.
A network processor is an integrated circuit which has a feature set specifically targeted at the networking application domain. Network processors are typically software programmable devices and would have generic characteristics similar to general purpose central processing units that are commonly used in many different types of equipment and products.
We present a tool for measuring network service latency times under high network load. This tool is a proof-of-concept application designed to show the viability of using programmable network data planes as a basis for both generating a high rate of networ ...
In large scale data centers, network infrastructure is becoming a major cost component; as a result, operators are trying to reduce expenses, and in particular lower the amount of hardware needed to achieve their performance goals (or to improve the perfor ...
Realizing a hydrogen economy strongly requires alkaline water electrolysis to achieve large-scale generation of H2, but lacks stable and efficient catalysts. The insufficient active sites in Ni(OH)2 impair the catalytic performance of alkaline HER. Herein, ...