Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
The microstructure evolution associated with the cold forming sequence of an Fe-14Cr-1W-0.3Ti-0.3Y2O3 grade ferritic stainless steel strengthened by dispersion of nano oxides (ODS) was investigated. The material, initially hot extruded at 1100 degrees C an ...
To investigate the effect of recrystallization on hot deformation mechanism of TA15 titanium alloy, rolled sheet and laser-welded tubes before and after recrystallization annealing were tested by uniaxial tensile tests and biaxial gas bulging respectively. ...
Pronounced acceleration of recrystallization in cold worked metals is generally observed during annealing with additional high density electric current pulses. In this work, continuous alternating current of low density was applied to heat cold-rolled samp ...
Dynamic and post-dynamic recrystallization kinetics were investigated during hot-working of Inconel 718 as a function of temperature,strain and strain rate in the single phase domain.The post-dynamic evolution was found to be extremely fast and impacting s ...
In this article, the Joule effect heating influence on recrystallization phenomena in the Inconel 718 nickel-based superalloy is investigated in details. On the one hand, static recrystallization kinetic studies at 1020 degrees C after cold deformation up ...
Investigations on the fatigue strength of steel reinforcement bars (rebars) mainly involves fatigue tests with hot rolled (HR) and cold worked (CW) steels. However, in the last few decades, HR and CW rebars were replaced by quenched and selftempered (QST) ...
Annealing of supersaturated AA3xxx alloys at low temperatures usually results in sluggish recrystallization kinetics. This is due to the joint effect of the following factors: low nucleation rate, reduced grain boundary mobility, and large amount of fine p ...
Fluid injection at a pressure below the local minimum principal total stress in a fault may (re)activate shear crack propagation (hydroshearing). Because of the presence of asperities along the fault's surfaces, the fault hydraulic width increase with the ...
For new fast-neutron sodium-cooled Generation IV nuclear reactors, the candidate cladding materials for the very strong burn-up are ferritic and martensitic oxide dispersion strengthened grades. Classically, the cladding tube is cold formed by a sequence o ...
Using different homogenization treatments, different initial microchemistry conditions in terms of solid solution levels of Mn, and number densities and sizes of constituents and dispersoids were achieved in an Al-Mn-Fe-Si model alloy. For each homogenized ...
