Common-mode signal is the voltage common to both input terminals of an electrical device. In telecommunication, the common-mode signal on a transmission line is also known as longitudinal voltage.
In most electrical circuits the signal is transferred by a differential voltage between two conductors. If the voltages on these conductors are U1 and U2, the common-mode signal is the average of the voltages:
When referenced to the local common or ground, a common-mode signal appears on both lines of a two-wire cable, in phase and with equal amplitudes. Technically, a common-mode voltage is one-half the vector sum of the voltages from each conductor of a balanced circuit to local ground or common. Such signals can arise from one or more of the following sources:
Radiated signals coupled equally to both lines,
An offset from signal common created in the driver circuit, or
A ground differential between the transmitting and receiving locations.
Noise induced into a cable, or transmitted from a cable, usually occurs in the common mode, as the same signal tends to be picked up by both conductors in a two-wire cable. Likewise, RF noise transmitted from a cable tends to emanate from both conductors. Elimination of common-mode signals on cables entering or leaving electronic equipment is important to ensure electromagnetic compatibility. Unless the intention is to transmit or receive radio signals, an electronic designer generally designs electronic circuits to minimise or eliminate common-mode effects.
Differential amplifiers or receivers that respond only to voltage differences, e.g. those between the wires that constitute a pair. This method is particularly suited for instrumentation where signals are transmitted through DC bias. For sensors with very high output impedance that require very high common-mode rejection ratio, a differential amplifier is combined with input buffers to form an instrumentation amplifier.
An inductor where a pair of signaling wires follow the same path through the inductor, e.g.
This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.
Ce cours vise à transférer les concepts théoriques et les savoir-faire nécessaires à la réalisation de mesures de bonne qualité. Les contenus méthodologiques et technologiques seront exposés sous form
Electromagnetic interference (EMI), also called radio-frequency interference (RFI) when in the radio frequency spectrum, is a disturbance generated by an external source that affects an electrical circuit by electromagnetic induction, electrostatic coupling, or conduction. The disturbance may degrade the performance of the circuit or even stop it from functioning. In the case of a data path, these effects can range from an increase in error rate to a total loss of the data.
A transformer is a passive component that transfers electrical energy from one electrical circuit to another circuit, or multiple circuits. A varying current in any coil of the transformer produces a varying magnetic flux in the transformer's core, which induces a varying electromotive force (EMF) across any other coils wound around the same core. Electrical energy can be transferred between separate coils without a metallic (conductive) connection between the two circuits.
The ever-growing global internet traffic has increased demand for higher speed data transmission. As the bandwidth requirements of wireline links increase, extensive digital equalization techniques are required to compensate for the high-frequency channel ...
Resonant and non-resonant effects in few-mode fibers have found use in versatile devices. From sensing perspective, extensive research has been done on fringe sensitivity of nonresonant two-mode interference. Resonant mode converter gratings are promising ...
This paper presents a low-power single-channel 8-bit loop-unrolled (LU) successive approximation register (SAR) analog-to-digital-converter (ADC) with a novel common-mode adaptive background comparator offset calibration scheme. LU-SAR ADCs use multiple co ...