Concept
Power supply
Related courses (30)
EE-361: Electrical machines (for EL)
L'objectif de ce cours est d'acquérir les connaissances de base liées aux machines électriques (conversion électromécanique). Le cours porte sur le circuit magnétique, le transformateur, les machines
EE-320: Analog IC design
Introduction to the design of analog CMOS integrated circuits at the transistor level. Understanding and design of basic structures.
EE-202: Electronics I
Les concepts de base permettant de comprendre, d'analyser et de concevoir les circuits à base d'AmpliOp, dédiés à l'acquisition et conditionnement des signaux analogiques sont traités en théorie et pr
PHYS-452: Radiation detection
The course presents the detection of ionizing radiation in the keV and MeV energy ranges. Physical processes of radiation/matter interaction are introduced. All steps of detection are covered, as well
MICRO-709: Power management
The objective of this course is to discuss the state-of-the-art in low-power analog and digital system design, with special emphasis on transistor level measures to limit and to control the power diss
MICRO-705: Low-voltage analog CMOS IC design
The course is covering following aspects: MOS Transistor Modeling for Low-Voltage and Low-Power Circuit Design, Noise Performance of Elementary Transistor Stages, Stability of Operational Amplifiers,
MICRO-211: Analog circuits and systems
This course introduces the analysis and design of linear analog circuits based on operational amplifiers. A Laplace early approach is chosen to treat important concepts such as time and frequency resp
EE-423: Low power electronics: analog mixed signal design
This course deals with the analyze, design and optimization of CMOS analog circuits, emphasizing low-power solutions required in a broad range of applications (e.g. IoT, wearables, Biosensors ...). S
EE-520: Low-power analog IC design
This course presents the design of low-power analog CMOS integrated circuits. The techniques are based on the concept of inversion coefficient that can be used as the main design parameter for the opt