5 cm Pak 38

The 5 cm Pak 38 (L/60) (5 cm Panzerabwehrkanone 38 (L/60)) was a German anti-tank gun of 50 mm calibre. It was developed in 1938 by Rheinmetall-Borsig AG as a successor to the 3.7 cm Pak 36, and was in turn followed by the 7.5 cm Pak 40. Note the unique curved gun-shield design which differs from most WWII anti-tank guns which have either one flat or two angled and one flat gun-shield plates for ease of manufacturing. After the Spanish Civil War, the German authorities started to think that a new anti-tank gun would be needed, even though the 3.7 cm Pak 36 had proven to be very successful. They asked Rheinmetall-Borsig to produce a new and more capable AT-gun. They first designed the Pak 37 in 1935, but the German authorities did not approve it because of its low capabilities. Rheinmetall-Borsig were forced to create a new gun with a longer - L/60 - barrel which was approved for mass production in 1939 under the designation Pak 38. The original tank gun for the Panzer III was the 5 cm KwK 38, which despite being the same 5 cm caliber had a lower muzzle velocity due to the shorter barrel length (L/42 calibers) and smaller cartridge. When a more powerful gun with greater penetration was needed for the Panzer III the longer barrel 5 cm KwK 39 gun (L/60 calibers) was developed as a variant of the 5 cm Pak 38 towed anti-tank gun. The Pak 38 was first used by the German forces during the Second World War in April 1941. When the Germans faced Soviet tanks in 1941 during Operation Barbarossa starting June 1941, the Pak 38 was one of the few guns capable of penetrating the sloped armor of the T-34 medium tank at close range. The gun was also equipped with Panzergranate 40 APCR shots with a hard tungsten carbide core, in an attempt to penetrate the armor of the heavier KV-1 tank. Although it was replaced by more powerful weapons, it remained a useful weapon and remained in service with the Wehrmacht until the end of the war. The Pak 38 carriage was also used for the 7.5 cm Pak 97/38 and the 7.5 cm Pak 50 guns.