Audio system measurements

Audio system measurements are a means of quantifying system performance. These measurements are made for several purposes. Designers take measurements so that they can specify the performance of a piece of equipment. Maintenance engineers make them to ensure equipment is still working to specification, or to ensure that the cumulative defects of an audio path are within limits considered acceptable. Audio system measurements often accommodate psychoacoustic principles to measure the system in a way that relates to human hearing. Subjectively valid methods came to prominence in consumer audio in the UK and Europe in the 1970s, when the introduction of compact cassette tape, dbx and Dolby noise reduction techniques revealed the unsatisfactory nature of many basic engineering measurements. The specification of weighted CCIR-468 quasi-peak noise, and weighted quasi-peak wow and flutter became particularly widely used and attempts were made to find more valid methods for distortion measurement. Measurements based on psychoacoustics, such as the measurement of noise, often use a weighting filter. It is well established that human hearing is more sensitive to some frequencies than others, as demonstrated by equal-loudness contours, but it is not well appreciated that these contours vary depending on the type of sound. The measured curves for pure tones, for instance, are different from those for random noise. The ear also responds less well to short bursts, below 100 to 200 ms, than to continuous sounds such that a quasi-peak detector has been found to give the most representative results when noise contains click or bursts, as is often the case for noise in digital systems. For these reasons, a set of subjectively valid measurement techniques have been devised and incorporated into BS, IEC, EBU and ITU standards. These methods of audio quality measurement are used by broadcast engineers throughout most of the world, as well as by some audio professionals, though the older A-weighting standard for continuous tones is still commonly used by others.