Telecommand

A telecommand or telecontrol is a command sent to control a remote system or systems not directly connected (e.g. via wires) to the place from which the telecommand is sent. The word is derived from tele = remote (Greek), and command = to entrust/order (Latin). Systems that need remote measurement and reporting of information of interest to the system designer or operator require the counterpart of telecommand, telemetry. The telecommand can be done in real time or not depending on the circumstances (in space, delay may be of days), as was the case of Marsokhod. Control of a TV from the sofa Remote guidance of weapons or missiles Control of a satellite from a ground station Flying a radio-controlled airplane For a Telecommand (TC) to be effective, it must be compiled into a pre-arranged format (which may follow a standard structure), modulated onto a carrier wave which is then transmitted with adequate power to the remote system. The remote system will then demodulate the digital signal from the carrier, decode the TC, and execute it. Transmission of the carrier wave can be by ultrasound, infra-red or other electromagnetic means. Infrared light makes up the invisible section of the electromagnetic spectrum. This light, also classified as heat, transmits signals between the transmitter and receiver of the remote system. Telecommand systems usually include a physical remote, which contains four key parts: buttons, integrated circuit, button contacts, and a light-emitting diode. When the buttons on a remote are pressed they touch and close their corresponding contacts below them within the remote. This completes the necessary circuit on the circuit board along with a change in electrical resistance, which is detected by the integrated circuit. Based on the change in electrical resistance, the integrated circuit distinguishes which button was pushed and sends a corresponding binary code to the light-emitting diode (LED) usually located at the front of the remote.