Plasma cleaning

Summary

Plasma cleaning is the removal of impurities and contaminants from surfaces through the use of an energetic plasma or dielectric barrier discharge (DBD) plasma created from gaseous species. Gases such as argon and oxygen, as well as mixtures such as air and hydrogen/nitrogen are used. The plasma is created by using high frequency voltages (typically kHz to >MHz) to ionise the low pressure gas (typically around 1/1000 atmospheric pressure), although atmospheric pressure plasmas are now also common. Methods In plasma, gas atoms are excited to higher energy states and also ionized. As the atoms and molecules 'relax' to their normal, lower energy states they release a photon of light, this results in the characteristic “glow” or light associated with plasma. Different gases give different colors. For example, oxygen plasma emits a light blue color. A plasma’s activated species include atoms, molecules, ions, electrons, free radicals, metastables, and photons in the short wave

Official source

https://en.wikipedia.org/wiki/Plasma_cleaning

About this result

This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.

Related publications (33)

Related publications

Related people (26)

Related people

Related units (12)

Related units

Related concepts (1)

Related concepts

Related courses (5)

Ce cours d'introduction à la microscopie a pour but de donner un apperçu des différentes techniques d'analyse de la microstructure et de la composition des matériaux, en particulier celles liées aux microscopies électronique et optique. Le cours comprend des cours ainsi que des démonstrations.

This course completes the knowledge in plasma physics that students have acquired in the previous two courses, with a discussion of different applications, in the fields of magnetic confinement and controlled fusion, astrophysical and space plasmas, and societal and industrial applications.

This intensive course is intended for researchers who envisage to use scanning electron microscopy techniques for their research or who want to understand how to interpret SEM images and analytical results presented in scientific publications.

Related courses

Related lectures (14)

Related lectures

RNA Sequencing of Arabidopsis thaliana Seedlings after Non-Thermal Plasma-Seed Treatment Reveals Upregulation in Plant Stress and Defense Pathways

Ivo Furno, Alan Howling, Alexandra Waskow

Not all agricultural practices are sustainable; however, non-thermal plasma treatment of seeds may be an eco-friendly alternative to improve macroscopic plant growth parameters. Despite the numerous successful results of plasma-seed treatments reported in the literature, there is a large gap in our understanding of how non-thermal plasma treatments affect seeds, especially due to the plethora of physical, chemical, and biological variables. This study uses RNA sequencing to characterize the changes in gene transcription in Arabidopsis thaliana (L.) Heynh. seeds 6 days after exposure to surface dielectric barrier discharge plasma treatment. Here, we provide an overview of all pathways that are differentially expressed where few genes are upregulated and many genes are downregulated. Our results reveal that plasma treatment time is a parameter that can activate different pathways in plant defense. An 80 s treatment upregulates the glucosinolate pathway, a defense response to insects and herbivores to deter feeding, whereas a shorter treatment of 60 s upregulates the phenylpropanoid pathway, which reinforces the cell wall with lignin and produces antimicrobial compounds, a defense response to bacterial or fungal plant pathogens. It seems that plasma elicits a wounding response from the seed in addition to redox changes. This suggests that plasma treatment can be potentially applied in agriculture to protect plants against abiotic and biotic stresses without discharging residues into the environment.

MDPI2022

In the frame of this thesis, two similar high current DC arc (HCDCA) plasma sources were investigated in a low gas pressure regime (10-3-10-2 mbar). One of them was initially designed for the epitaxial growth of silicon and silicon germanium (LEP), the other for the industrial deposition of diamond (BAI). The LEP source was analysed using pure argon plasmas. Measurements of the ion saturation current were performed with a custom-built multi-Langmuir probe to analyse plasma density homogeneity. Plasma instabilities at 50 Hz were observed and studied by different means. One source of the instability is the AC current used for the filament heating, whereas lower frequency instabilities are due to the use of a ring shaped anode. A sensitive Hall sensor was used to measure the magnetic field induced by the discharge current. It was found that depending on the plasma parameters gas pressure and external magnetic field the current tends to attach at different points on the anode, leading to a complete loss of reactor symmetry. The installation of an additional cusp field around the reactor chamber lead to an increase of the overall homogeneity of the plasma density, but it could not resolve the problems of current attachment. In the following the ring anode was replaced by a point anode and the maximum external magnetic field strength was increased by a factor of ten. With a novel multi-Hall probe the current density of the now columnar shaped plasma was measured, showing a strongly peaked current density profile, when an external magnetic field is applied. Together with ion saturation current measurements made with a Langmuir probe, the electron temperature inside the plasma column was estimated to be about 4 eV. In earlier works made on the BAI reactor the high dissociation efficiency of the HCDCA plasma source has already been shown. Optical emission spectra were compared between RF plasmas, low pressure (1.5mbar) HCDCA plasmas and our very low pressure (10-3-10-2 mbar) HCDCA plasmas. The dominating species found in RF plasma spectra are molecular, the spectra of low pressure HCDCA plasmas are dominated by atomic species and the spectra of very low pressure HCDCA plasmas are dominated by ions, emphasising the high dissociation efficiency of this system. Silane and Methane was used as precursor gases in the BAI reactor for the deposition of silicon carbide films. Promising high deposition rates up to 9 nm/s were found, but FTIR spectroscopy showed high hydrogen and oxygen concentrations in the porous films, making the not optimised deposited material useless for the application of wear-resistant coatings. Microcrystalline hydrogenated silicon (µc-Si:H) is viewed as a cost- and energy-effective alternative to crystalline silicon for the production of solar cells. A detailed analysis of the deposition rate and the Raman crystallinity of µc-Si:H films deposited in the BAI reactor showed deposition rates up to 6.5 nm/s and a wide range of crystallinity from 0-80%. Film thickness inhomogeneity in silicon solar cells has to be less than 5%. To meet this standard a first substantial improvement was achieved with the installation of a linear gas injection along the plasma column. Tests on large surface glasses (47 × 37 cm2) revealed strong diffusive effects, which could be reproduced with a simple gas diffusion model. The model showed the necessity to reduce the dead volume around the plasma and to set the substrates as close as possible to the plasma column in order to minimise film thickness inhomogeneity due to diffusion. Deposition rate measurements made in these conditions assured the results of the model. The development of a method to estimate the dissociation efficiency of the plasma by simple pressure measurements showed also an important increase of the silane dissociation from 75-92% when the plasma is confined in a smaller volume. Therefore, compared to the reactor with a large dead volume, only a third of the initial silane is lost to the pumps.

EPFL2008

An In Situ FTIR Study of DBD Plasma Parameters for Accelerated Germination of Arabidopsis thaliana Seeds

Ivo Furno, Alan Howling, Lorenzo Ibba, Alexandra Waskow

Current agricultural practices are not sustainable; however, the non-thermal plasma treatment of seeds may be an eco-friendly alternative to alter macroscopic plant growth parameters. Despite numerous successful results of plasma-seed treatments reported in the literature, the plasma-treatment parameters required to improve plant growth remain elusive due to the plethora of physical, chemical, and biological variables. In this study, we investigate the optimal conditions in our surface dielectric barrier discharge (SDBD) setup, using a parametric study, and attempt to understand relevant species in the plasma treatment using in situ Fourier transform infrared (FTIR) absorption spectroscopy. Our results suggest that treatment time and voltage are key parameters for accelerated germination; however, no clear conclusion on causative agents can be drawn.

MDPI2021

EPFL2008