Home

Person

Fabian Jatuff

About
Privacy
Disclaimer

Graph Chatbot

Related publications (23)

Investigations of238U captures to total fissions in a Westinghouse SVEA-96+ assembly

The reaction-rate ratio C8/Ftot, neutron captures in 238U to total fissions, has been measured in 80 out of 96 fuel rods of a Westinghouse SVEA-96+ boiling water reactor fuel assembly. High-resolution gamma spectroscopy was performed on individual fuel rod ...

American Nuclear Society2007

Radial and azimuthal 235U fission and 238U capture distributions in BWR UO2 pins: CASMO-4 and MCNP4C versus activation foil measurements

Rakesh Chawla, Fabian Jatuff, Michaël Plaschy

In the context of the LWR-PROTEUS program, radial and azimuthal 235U fission (F5) and 238U capture (C8) rate distributions have been calculated for zero-burnup pins of a Westinghouse SVEA-96 Optima2 boiling water reactor fuel assembly using the stochastic ...

ANS2007

Validation of 134Cs, 137Cs and 154Eu single ratios as burnup monitors for ultra-high burnup UO2 fuel

Rakesh Chawla, Stefano Caruso, Fabian Jatuff

A measurement station has been built for the non-destructive investigation of burnt fuel rod segments through high-resolution gamma spectrometry. Four UO2 pressurised water reactor fuel rod segments with different burnup levels between 50 and 100GWd/t and ...

Elsevier2007

Optimised non-invasive method to determine 238U-captures-to-total-fissions in reactor fuel

Rakesh Chawla, Fabian Jatuff

High-resolution gamma spectroscopy was performed on individual fuel rods of a fresh, highly heterogeneous Boiling Water Reactor (BWR) fuel assembly, after irradiation at low power in the PROTEUS reactor at PSI, to determine the ratio of neutron captures in ...

Elsevier2006

Reactivity and neutron emission measurements of highly burnt PWR fuel rod samples

Rakesh Chawla, Fabian Jatuff

Fuel rods with burnup values beyond 50GWd/t are characterised by relatively large amounts of fission products and a high abundance of major and minor actinides. Of particular interest is the change in the reactivity of the fuel as a function of burnup and ...

Elsevier2006

Comparisons of deterministic neutronic calculations with Monte Carlo results for an advanced BWR fuel assembly with hafnium control blades

Rakesh Chawla, Filippo Tani, Fabian Jatuff, Michaël Plaschy, Flavio Dante Giust

From the neutronic viewpoint, the optimization of BWR core designs is strongly related to the accurate determination of flux variations inside and around fuel assemblies. These fluctuations, which are mainly due to the high heterogeneity of the fuel and mo ...

Atomic Energy Society of Japan2006

On the accuracy of reactor physics calculations for square HPLWR fuel assemblies

Rakesh Chawla, Fabian Jatuff

Although the supercritical-pressure or high-performance light water reactor (HPLWR) concept is largely based on the well-established technological experience available with conventional light water reactors, there is still no consensus on various key desig ...

Elsevier2006

Effects of void uncertainties on the void reactivity coefficient and pin power distributions for a 1010 BWR assembly

Rakesh Chawla, Fabian Jatuff, Flavio Dante Giust

An important source of uncertainty in boiling water reactor physics is associated with the precise characterisation of the moderation properties of the coolant and by-pass regions, with significant impact on reactor physics parameters such as the lattice n ...

Elsevier2006

Experimental validation of channel bowing effects on pin power distributions in a Westinghouse SVEA-96+ assembly

Rakesh Chawla, Fabian Jatuff, Tony Williams

Effects of channel bowing on the pin power and 238U capture rate distributions have been studied experimentally and analytically in a test zone consisting of 9 full-size Westinghouse Atom SVEA-96+ fuel assemblies in the PRO-TEUS critical facility. A very s ...

Atomic Energy Society of Japan2006

Study of spectral heterogeneities for the interpretation of calculational trends in predicting pin power distributions in a SVEA-96+ BWR assembly

Rakesh Chawla, Filippo Tani, Fabian Jatuff

Detailed energy spectra have been calculated with the codes CASMO-4 and BOXER for neutron reaction rates in individual regions of a Westinghouse SVEA-96+ BWR fuel assembly immersed in water at room temperature, as investigated in Core 1A of the LWR-PROTEUS ...

Elsevier2006

Page 2 of 3

Radial and azimuthal 235U fission and 238U capture distributions in BWR UO2 pins: CASMO-4 and MCNP4C versus activation foil measurements

Rakesh Chawla, Fabian Jatuff, Michaël Plaschy

ANS2007

Comparisons of deterministic neutronic calculations with Monte Carlo results for an advanced BWR fuel assembly with hafnium control blades

Rakesh Chawla, Filippo Tani, Fabian Jatuff, Michaël Plaschy, Flavio Dante Giust

Atomic Energy Society of Japan2006

Study of spectral heterogeneities for the interpretation of calculational trends in predicting pin power distributions in a SVEA-96+ BWR assembly

Rakesh Chawla, Filippo Tani, Fabian Jatuff

Elsevier2006

On the accuracy of reactor physics calculations for square HPLWR fuel assemblies

Rakesh Chawla, Fabian Jatuff

Elsevier2006

Experimental validation of channel bowing effects on pin power distributions in a Westinghouse SVEA-96+ assembly

Rakesh Chawla, Fabian Jatuff, Tony Williams

Atomic Energy Society of Japan2006