Skip to main content

Search

Show all results for

Home

Person

Frédéric Diologent

About
Privacy
Disclaimer

Copyright © 2025 EPFL, all rights reserved

Graph Chatbot

About this result

This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.

Related publications (20)

Please note that this is not a complete list of this person’s publications. It includes only semantically relevant works. For a full list, please refer to Infoscience.

Influence of quench rate and microstructure on bendability of AA6016 aluminum alloys

Andreas Mortensen, Frédéric Diologent, Andreas Rossoll, Jean-François Despois, Cyrille Bezençon

The influence of the quench rate after solution treatment on the bendability of AA6016 aluminum alloy sheets was investigated. Crack initiation during bending tests is found to be independent of quench rate whereas crack propagation is decreased after rapi ...

Elsevier2013

Fracture of convoluted and lamellar α2 + γ TiAl alloys

Andreas Mortensen, Frédéric Diologent, Nicolas Vincent Barbi

Fracture toughness tests are conducted at room temperature and 923 K (650 degrees C) on SENB (Single Edge Notched Bend) specimens of three different (alpha(2) + gamma ) TiAl-based alloys. One alloy is a conventional near fully lamellar Ti-45Al-2Mn-2Nb + 0. ...

Elsevier2012

Activation volume in microcellular aluminium: Size effects in thermally activated plastic flow

Andreas Mortensen, Frédéric Diologent

Open-pore 99.99% pure Al and Al-5 wt.% Mg foam produced by replication, with pores either 400 or 75 gm in average diameter, are tested in compression with repeated relaxation cycles, at room temperature. Similar data are collected on pure aluminium. Estima ...

Elsevier2011