Overview of ASDEX upgrade results

Recent results from the ASDEX Upgrade experimental campaigns 2001 and 2002 are presented. An improved understanding of energy and particle transport emerges in terms of a 'critical gradient' model for the temperature gradients. Coupling this to particle diffusion explains most of the observed behaviour of the density profiles, in particular, the finding that strong central heating reduces the tendency for density profile peaking. Internal transport barriers (ITBs) with electron and ion temperatures in excess of 20 keV (but not simultaneously) have been achieved. By shaping the plasma, a regime with small type 11 edge localized modes (ELMs) has been established. Here, the maximum power deposited on the target plates was greatly reduced at constant average power. Also, an increase of the ELM frequency by injection of shallow pellets was demonstrated., ELM free operation is possible in the quiescent H-mode regime previously found in DIII-D which has also been established on ASDEX Upgrade. Regarding stability, a regime with benign neoclassical tearing modes (NTMs) was found. During electron cyclotron current drive (ECCD) stabilization of NTMs, beta(N) could be increased well above the usual onset level without a reappearance of the NTM. Electron cyclotron resonance heating and ECCD have also been used to control the sawtooth repetition frequency at a moderate fraction of the total heating power. The inner wall of the ASDEX Upgrade vessel has increasingly been covered with tungsten without causing detrimental effects on the plasma performance. Regarding scenario integration, a scenario with a large fraction of noninductively driven current (greater than or equal to50%), but without ITB has been established. It combines improved confinement (tau(E)/tau(ITER98) approximate to 1.2) and stability (beta(N) less than or equal to 3.5) at high Greenwald fraction (n(e)/n(GW) approximate to 0.85) in steady state and with type 11 ELMy edge and would offer the possibility for long pulses with high fusion power at reduced current in ITER.

Bootstrap current compensation with electron-cyclotron waves in 3D reactor-size configurations

Sergi Ferrando I Margalet

In magnetic confinement devices, the inhomogeneity of the confining magnetic field along a magnetic field line generates the trapping of particles (with low ratio of parallel to perpendicular velocities) within local magnetic wells. One of the consequences of the trapped particles is the generation of a current, known as the bootstrap current (BC), whose direction depends on the nature of the magnetic trapping. The BC provides an extra contribution to the poloidal component of the confining magnetic field. The variation of the poloidal component produces the alteration of the winding of the magnetic field lines around the flux surfaces quantified by the rotational transform ι. When ι reaches low rational values, it can trigger the generation of ideal MHD instabilities. Therefore, the BC may be responsible for the destabilisation of the configuration. This thesis is divided into two parts. In the first part, we present a self-consistent method to calculate the BC and assess its effect on equilibrium and stability in general 3D configurations. This procedure is applied to two reactor-size prototypes (both with plasma volumes ∼ 1000m3): a quasi-axisymmetric (QAS) system and a quasi helically symmetric (QHS) system with magnetic structures that develop BC in opposite directions. The BC increases with the plasma pressure, therefore its relevance is enhanced when dealing with reactor-level scenarios. The behaviour of both prototypes at reactor level values of β ≡ (kinetic plasma pressure)/(magnetic pressure) is assessed, as well as its alteration of the equilibrium and stability. In the QAS prototype, BC-consistent equilibria have been computed up to β = 6.7% and the configuration is shown to be stable up to β = 6.4%. Convergence of self-consistent BC calculations for the QHS case is achieved only up to β = 3.5%, but the configuration is unstable for β ≥ 0.6%. The relevance of symmetry breaking modes of the Fourier expansion of the confining magnetic field on the generation of BC is studied for each prototype. This proves the close relationship between magnetic structure and BC. Having established the potentially dangerous implication of the BC, principally, in reactor prototypes, a method to compensate its harmful effects is proposed in the second part of the thesis. It consists of the modelling of the current driven by externally launched ECWs within the plasma to compensate the effects of the BC. This method is flexible enough to allow the identification of the appropriate scenarios in which to generate the required CD depending on the nature of the confining magnetic field and the specific plasma parameters of the configuration. Both the BC and the CD calculations are included in a self-consistent scheme which leads to the computation of a stable BC+CD-consistent MHD equilibrium. This procedure is applied in this thesis to simulate the required CD to stabilise the QAS and QHS prototypes introduced in the first part. The estimation of the input power required and the effect of the driven current on the final equilibrium of the system is performed for several relevant scenarios and wave polarisations providing various options of stabilising driven currents. Several scenarios have been devised for each prototype in order to drive current at the appropriate location and with the desired direction. Different polarisations and launching conditions have been employed to this purpose. In particular, a HFS launched X2 ECW with an input power of 1.5MW has been shown to drive sufficient current to maintain the rotational transform below the critical value 2/3 at β = 6.4% for the QAS reactor. Correspondingly, in the QHS reactor, an X3-mode ECW of 100KW was sufficient to drive the current required to push the rotational transform below unity near the magnetic axis at β = 3%. Thus, stabilisation of BC-driven instabilities with externally launched ECWs has been achieved for both contrasting configurations. The method proposed in this thesis allows also the utilisation of EBW in the generation of CD. The possible advantages of EBCD for compensation studies are described as well as their possible application to the two prototypes under consideration. The BC+CD procedure is particularly interesting to investigate new magnetic geometries as potential candidates for fusion reactors. With this numerical tool, it is possible to assess the implications of their consistent BC when operating at reactor level. It also allows to quantify how much power would be required to maintain the system MHD stable in these circumstances. Nevertheless, this method is flexible enough to be applicable to any configuration.

EPFL2006

Chauffage de plasma par ondes électromagnétiques à la troisième harmonique de la fréquence cyclotron des électrons dans le tokamak TCV

Gilles Arnoux

The Tokamak à Configuration Variable (TCV) programme is based on flexible plasma shaping capabilities together with a powerful electron cyclotron wave (ECW) additional heating for studies of stability, confinement, transport, control and power exhaust. In particular, ECW heating system allows an extended study of the β limit, defined as the ratio between the plasma kinetic pressure and the magnetic pressure, which is attributed to MHD (MagnetoHydroDynamic) instabilities. The ECW heating (ECH) is based on the resonant interaction between the electrons and an electromagnetic (EM) wave in a region of the plasma where the wave frequency is an harmonic of the electron cyclotron frequency. The TCV ECH system is composed of 6 gyrotrons (high power radio frequency sources), at the frequency of 82.7 GHz for second harmonic X-mode heating (X2) and 3 gyrotrons at the frequency of 118 GHz for third harmonic X-mode heating (X3), providing each a nominal power of 0.5 MW. In the moderate magnetic field of TCV (1.45 T), the X2 system is able to heat plasmas up to the X2 cutoff density (4.2 · 1019 m-3) above which the wave cannot propagate. The X3 system extends the accessible density range for ECH up to the X3 cutoff density (11.2 · 1019 m-3) and allows in particular the heating of plasmas in high confinement regime (H mode), most appropriate candidates to reach the β limit. The X2 wave is totally absorbed (plasma optically thick) being launched from the lateral side of TCV and crossing the vertical resonance layer. With this launching configuration, the X2 wave can also be used for non-inductive generation of the plasma current. Since the X3 absorption coefficient is weaker than the X2 absorption coefficient, the X3 wave is injected vertically in order to increase the beam path within the resonance layer, therefore maximizing the X3 optical depth. The present work, based on experiments and simulation, is the first detailed study of the X3 absorption properties in a top-launch configuration. The X3 absorption is shown to mainly depend on the wave injection conditions and the electron temperature. Full single-pass absorption is measured increasing nearly threefold the central electron temperature (1 keV –> 2.7 keV) when 1.35 MW of RF power is injected in low confinement regime plasmas (L-mode) with a central density of 4.0·1019 m-3. Experimental evidences show that a fraction of the power is absorbed on suprathermal electrons generated by the X3 wave itself. An absorption level of 85% is measured increasing threefold the central temperature by injecting 1.35 MW of X3 in H-mode plasmas with a central density of 8.2 · 1019 m-3. A new plasma dynamics is observed for the first time on TCV in these experiments. The X3 absorption is shown to depend strongly on the wave injection angle. In order to maximize the absorption during a plasma discharge by optimizing the injection angle, a real time feedback control has been developed and used. The system is based on the synchronous demodulation technique and uses a PI controller. In order to simulate the X3 wave propagation and absorption, the linear ray-tracing code TORAY-GA is used. These simulations predict an absorption dependence on the temperature and the injection conditions in agreement with the experimental results. Since TORAY-GA does not take into account the diffraction effects on the beam propagation, a comparison with the beam tracing code ECWGB which includes diffraction is discussed. The present results on X3 absorption properties demonstrate the efficiency of the X3 heating system on TCV, therefore extending the β limits study capabilities in elongated plasmas.

EPFL2005

MHD stability limits in the TCV tokamak

Holger Reimerdes

Magnetohydrodynamic (MHD) instabilities can limit the performance and degrade the confinement of tokamak plasmas. The Tokamak à Configuration Variable (TCV), unique for its capability to produce a variety of poloidal plasma shapes, has been used to analyse various instabilities and compare their behaviour with theoretical predictions. These instabilities are perturbations of the magnetic field which usually extend to the plasma edge where they can be detected with magnetic pick-up coils as magnetic fluctuations. A spatially dense set of magnetic probes, installed inside the TCV vacuum vessel, allows for a fast observation of these fluctuations. The structure and temporal evolution of coherent modes is extracted using several numerical methods. In addition to the setup of the magnetic diagnostic and the implementation of analysis methods, the subject matter of this thesis focuses on four instabilities which impose local and global stability limits. Al1 of these instabilities are relevant for the operation of a fusion reactor and a profound understanding of their behaviour is required in order to optimise the performance of such a reactor. Sawteeth, which are central relaxation oscillations common to most standard tokamak scenarios, have a significant effect on central plasma parameters. In TCV, systematic scans of the plasma shape have revealed a strong dependence of their behaviour on elongation κ, and triangularity δ, with high κ and low δ leading to shorter sawteeth with smaller crashes. This shape dependence is increased by applying central electron cyclotron heating (ECH), which increases or decreases the sawtooth period, depending on the plasma shape. The response to additional heating power is determined by the role of ideal or resistive MHD in triggering the sawtooth crash. For plasma shapes where additional heating and consequently, a faster increase of the central pressure shortens the sawteeth, the low experimental limit of the pressure gradient within the q = 1 surface is consistent with ideal MHD predictions. The observed decrease of this limit with elongation is also in qualitative agreement with ideal MHD theory. Edge localised modes (ELMs), occurring in TCV Ohmic high-confinement mode discharges, were observed to be preceded by coherent magnetic oscillations. The precursors prior to small ELMs, believed to be of type III, and prior to larger ELMs, previously referred to as TCV large ELMs, show the same characteristics, which allows for an identification of both ELMs to be of type III according to the usual classification scheme. The detected poloidal and toroidal mode structures are consistent with a resonant flux surface close to the plasma edge. Unlike conventional MHD modes, these precursors start at a random toroidal location and then grow in amplitude and toroidal extent until they encompass the whole toroidal circumference. Thus, the asymmetry causing and maintaining the toroidal localisation of the ELM precursor, must be intrinsic to the plasma. Soft X-ray measurements show that the localised precursor always coincides with a central m = 1 mode, which can usually be associated with the sawtooth pre- or postcursor mode. A comparison of the phases indicates a correlation with the maximum of the central mode preceding the toroidal location of the ELM precursor and, therefore, a hitherto unobserved coupling between central modes and ELMs. Highly elongated plasmas promise several advantages, among them higher current and beta limits. During TCV experiments dedicated to an increasing of the plasma elongation, a new disruptive current limit, at values well below the conventional current limit corresponding to qa >2, was encountered for κ >2.3. This limit, which is preceded by a kink-type mode, is found to be consistent with ideal MHD stability calculations. The TCV observations, therefore, provide the first experimental confirmation of a deviation of the linear Troyon-scaling of the ideal beta limit with normalised current at high elongation, which was predicted over 10 years ago. In addition to the ideal beta limit, several other MHD events are observed in highly elongated plasmas. The axisymmetric mode causes vertical displacement events and thereby, imposes a lower current limit. This operational limit is in good agreement with theoretical predictions of the growth rate of the axisymmetric mode. Furthermore, minor disruption are occasionally observed. They are caused by bursts of tearing modes located close to the q = 1 surface, which are destabilised by flat central current profiles, typical for highly elongated plasmas. Neoclassical tearing modes (NTMs), which have been observed to limit the achievable beta in a number of tokamaks, arise from a helical perturbation of the bootstrap current caused by an existing seed island. Neoclassical m/n = 2/1 tearing modes have been identified in TCV discharges which are characterised by a low electron collisionality νe*, a medium ion collisionality ν*, a medium value of beta and strongly peaked pressure and current profiles. In contrast to other tokamak experiments, where sawteeth, fishbones or ELMs generate the seed island, the required seed island is provided by a conventional tearing mode. The island clearly shows a conventional and a neoclassical growth phase. The TCV results provide the first clear observations of such a trigger mechanism which could also explain the occurrence of "triggerless" NTMs observed in other experiments. The slowly growing seed island also allows a measurement of the critical seed island width ωcrit, which is observed to increase with increasing density. In conclusion, several local and a global stability limits are analysed. These instabilities can limit the pressure gradient and thereby, the performance of the plasma. The presented results reveal several previously unobserved features of commonly observed instabilities. Since the most of the new observations can be explained by theory, they improve the predictive capabilities with respect to new experiments. The experiments have also shown some new interactions among different instabilities, which add to the already crowded complexities of MHD phenomena in fusion plasmas.

EPFL2001