AM Modulation-based CMOS Readout Circuit for High-density Microelectrode Arrays
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
In this paper, a new methodology for the automated design of one-bit internal quantizer Sigma Delta-modulators is presented. The core of the method is an NTF prototype generation in the DT-domain based on the quasilinear quantizer modeling, that maximizes ...
Ieee Service Center, 445 Hoes Lane, Po Box 1331, Piscataway, Nj 08855-1331 Usa2008
An implementation of a dynamic supply RF power amplifier (PA) in 0.11 mu m CMOS technology occupying a total area of 1.35mm(2) is presented. Two-tone measurement results at 2.4 and 5.2GHz show that the system can deliver over 16dBm linear output power with ...
We report on the low-frequency electronic noise properties of individual multi-walled carbon nanotubes (CNTs). We present experimental evidence of the key role played by the structural quality of the tube and its gaseous environment on the excess noise lev ...
We present a shot-noise based model for a large family of ultrawide bandwidth (UWB) signals. These include time-hopping and direct-sequence signaling with pulse position, interval and amplitude modulations. Each specific signal is constructed by adding fea ...
After years of intensive research effort, the design of RF integrated circuits in CMOS has now reached a wide acceptance for industrial designs. This is due to the high unity gain frequency and low-noise performance of today's deep sub micrometer MOS trans ...
In this paper, we present an analytical noise modeling methodology for lateral nonuniform MOSFET. We demonstrate that the noise properties of lateral nonuniform MOSFETs are considerably different from the prediction obtained with the conventional Klaassen- ...
Abstract—A platform based on an active-pixel-sensor electrode array (APS-MEA) for high-resolution imaging of invitro electrogenic cell cultures is presented, characterized and validated under culture conditions. The system enables full frame acquisition at ...
A photoacoustic sensor using a laser diode emitting near 1532 nm in combination with an erbium-doped fibre amplifier has been developed for ammonia trace gas analysis at atmospheric pressure. NH3 concentration measurements down to 6 ppb and a noise-equival ...
We present a shot noise based model for a large family of ultrawide bandwidth (UWB) signals. These include time-hopping and direct-sequence signaling with pulse position, interval, and amplitude modulations. Each specific signal is constructed by adding fe ...
Institute of Electrical and Electronics Engineers2006
A Hall sensor comprises a Hall element (1; 30; 31; 60) and an amplifier (2; 32; 33). The Hall element is placed inside the amplifier so that the current flowing through the Hall element also flows through the transistors of an amplifier stage of the amplif ...
