A gel probe equilibrium sampler for measuring arsenic porewater profiles and sorption gradients in sediments: II. Field application to Haiwee reservoir sediment

Arsenic (As) geochemistry and sorption behavior were measured in As- and iron (Fe)-rich sediments of Haiwee Reservoir by deploying undoped (clear) polyacrylamide gels and hydrous ferric oxide (HFO)-doped gels in a gel probe equilibrium sampler, which is a novel technique for directly measuring the effects of porewater composition on As adsorption to Fe oxides phases in situ. Arsenic is deposited at the sediment surface as As(V) and is reduced to As(III) in the upper layers of the sediment (0-8 cm), but the reduction of As(V) does not cause mobilization into the porewater. Dissolved As and Fe concentrations increased at depth in the sediment column driven by the reductive dissolution of amorphous Fe(III) oxyhydroxides and conversion to a mixed Fe(II, III) green rust-type phase. Adsorption of As and phosphorous (P) onto HFO-doped gels was inhibited at intermediate depths (10-20 cm), possibly due to dissolved organic or inorganic carbon, indicating that dissolved As concentrations were at least partially controlled by porewater composition rather than surface site availability. In sediments that had been recently exposed to air, the region of sorption inhibition was not observed, suggesting that prior exposure to air affected the extent of reductive dissolution, porewater chemistry, and As adsorption behavior. Arsenic adsorption onto the HFO-doped gels increased at depths >20 cm, and the extent of adsorption was most likely controlled by the competitive effects of dissolved phosphate. Sediment As adsorption capacity appeared to be controlled by changes in porewater composition and competitive effects at shallower depths, and by reductive dissolution and availability of sorption sites at greater burial depths. © 2008 American Chemical Society.

Natural attenuation of arsenic by sediment sorption and oxidation

Janet Gordon Hering

Arsenic sorption onto aquifer sediments was investigated in anaerobic laboratory batch and column uptake experiments and characterized by As, Fe, and Mn X-ray absorption spectroscopy (XAS) to estimate the extent and mechanism of abiotic sorption and oxidation of As(III). Batch experiments at pH 6 showed that the amount of As(III) or As(V) sorption from synthetic background porewater to sediments was similar as a function of total As concentration, but slightly more As(V) was sorbed than As(III) with increasing As concentrations. Column experiments with As(III) solutions in the absence and presence of dissolved Fe2+ showed more As uptake in the presence of Fe but also more Fe desorption during flushout with As-free solutions such that net As uptake was similar to, or less than that of, the Fe-free experiment. Fits to bulk Fe X-ray absorption near-edge spectroscopy (XANES) spectra showed no change between unreacted and reacted sediments. Manganese XANES revealed small increases in absorption in the spectral region associated with Mn(II) after reaction, indicating sediment Mn reduction. However, XANES spectra showed that Mn is not present as MnIVO2(s) but is probably substituted into other sediment minerals as a mixture of Mn(II,III). Quantitative analyses of As XANES spectra, which indicated mixtures of As(III) and As(V) after reaction with As(III) solutions, were used to estimate a fraction of As(V) in excess of native As(V) in the sediment (0.2 mmol kg-1) that corresponds to sorbed As(III) oxidized to As(V). The spectroscopic and solution data indicate that the aquifer sediments have a limited abiotic capacity to oxidize As(III), which did not exceed 30% of the total amount of As sorbed and was estimated in the range of 0.025-0.4 mmol kg-1 sediment. In the presence of dissolved Fe2+, the precipitation of Fe(III) hydrous oxide phases will be an effective mechanism for As scavenging only if there exists sufficient dissolved oxygen in groundwater to oxidize Fe. Once the aqueous oxidative capacity is exhausted, dissolved Fe2+ may compete with As(III) for the limited abiotic oxidation supplied by sediment Mn-bearing phases. © 2009 American Chemical Society.

2009

A gel probe equilibrium sampler for measuring arsenic porewater profiles and sorption gradients in sediments: I. Laboratory development

Janet Gordon Hering

A gel probe equilibrium sampler has been developed to study arsenic (As) geochemistry and sorption behavior in sediment porewater. The gels consist of a hydrated polyacrylamide polymer, which has a 92% water content. Two types of gels were used in this study. Undoped (clear) gels were used to measure concentrations of As and other elements in sediment porewater. The polyacrylamide gel was also doped with hydrous ferric oxide (HFO), an amorphous iron (Fe) oxyhydroxide. When deployed in the field, HFO-doped gels introduce a fresh sorbent into the subsurface thus allowing assessment of in situ sorption. In this study, clear and HFO-doped gels were tested under laboratory conditions to constrain the gel behavior prior to field deployment. Both types of gels were allowed to equilibrate with solutions of varying composition and re-equilibrated in acid for analysis. Clear gels accurately measured solution concentrations (±1%), and As was completely recovered from HFO-doped gels (±4%). Arsenic speciation was determined in clear gels through chromatographic separation of the re-equilibrated solution. For comparison to speciation in solution, mixtures of As(III) and As(V) adsorbed on HFO embedded in gel were measured in situ using X-ray absorption spectroscopy (XAS). Sorption densities for As(III) and As(V) on HFO embedded in gel were obtained from sorption isotherms at pH 7.1. When As and phosphate were simultaneously equilibrated (in up to 50-fold excess of As) with HFO-doped gels, phosphate inhibited As sorption by up to 85% and had a stronger inhibitory effect on As(V) than As(III). Natural organic matter (>200 ppm) decreased As adsorption by up to 50%, and had similar effects on As(V) and As(III). The laboratory results provide a basis for interpreting results obtained by deploying the gel probe in the field and elucidating the mechanisms controlling As partitioning between solid and dissolved phases in the environment. © 2008 American Chemical Society.

2008

Arsenic sequestration by sorption processes in high-iron sediments

Janet Gordon Hering

High-iron sediments in North Haiwee Reservoir (Olancha, CA), resulting from water treatment for removal of elevated dissolved arsenic in the Los Angeles Aqueduct system, were studied to examine arsenic partitioning between solid phases and porewaters undergoing shallow burial. To reduce arsenic in drinking water supplies, ferric chloride and a cationic polymer coagulant are added to the aqueduct upstream of Haiwee Reservoir, forming an iron-rich floc that scavenges arsenic from the water. Analysis by synchrotron X-ray absorption spectroscopy (XAS) showed that the aqueduct precipitate is an amorphous hydrous ferric oxide (HFO) similar to ferrihydrite, and that arsenic is associated with the floc as adsorbed and/or coprecipitated As(V). Arsenic-rich floc and sediments are deposited along the inlet channel as aqueduct waters enter the reservoir. Sediment core samples were collected in two consecutive years from the edge of the reservoir along the inlet channel using 30- or 90-cm push cores. Cores were analyzed for total and extractable arsenic and iron concentrations. Arsenic and iron speciation and mineralogy in sediments were examined at selected depths by synchrotron XAS and X-ray diffraction (XRD). Sediment-porewater measurements were made adjacent to the core sample sites using polyacrylamide gel probe samplers. Results showed that sediment As(V) is reduced to As(III) in all cores at or near the sediment-water interface (0-4 cm), and only As(III) was observed in deeper sediments. Analyses of EXAFS spectra indicated that arsenic is present in the sediments mostly as a bidentate-binuclear, inner-sphere sorption complex with local atomic geometries similar to those found in laboratory studies. Below about 10 cm depth, XAS indicated that the HFO floc had been reduced to a mixed Fe(II, III) solid with a local structure similar to that of synthetic green rust (GR) but with a slightly contracted average interatomic Fe-Fe distance in the hydroxide layer. There was no evidence from XRD for the formation of a crystalline GR phase. The release of dissolved iron (presumably Fe2+) and arsenic to solution, as monitored by in situ gel probes, was variable but, in general, occurred at greater depths than arsenic reduction in the sediments by spectroscopic observations and appears to be near or below the depth at which sediment GR was identified. These data point to reductive dissolution of the sorbent iron phase as the primary mechanism of release of sorbed arsenic to solution. © 2007 Elsevier Ltd. All rights reserved.

2007

Arsenic sequestration by sorption processes in high-iron sediments

Janet Gordon Hering

2007

A gel probe equilibrium sampler for measuring arsenic porewater profiles and sorption gradients in sediments: I. Laboratory development

Janet Gordon Hering

2008

Natural attenuation of arsenic by sediment sorption and oxidation

Janet Gordon Hering

2009