Single Crystal Growth of Constantan by Vertical Bridgman Method

This project deals with aspects involved in the growth of single-crystals of Constantan. Constantan is an alloy of Nickel in Copper, whose technological interest is that resistance is independent of temperature over a very large range of temperatures (hence the name Constantan). This, along with other suitable properties such as high strain sensitivity, high resistivity and low coefficient of thermal expansion makes it the principal component of all modern strain gauges used. However, Constantan also represents exactly the critical composition of Nickel in Copper (45% by weight Ni in Cu), which is the border between ferromagnetism and paramagnetism at low temperature. Such a transition in magnetic states at low (zero) temperature is called a quantum phase transition, and results in a uniquely scaling excitation spectrum. The eventual purpose of growing these single crystals is to validate our hypothesis that in fact the technologically relevant properties of Constantan are the result of quantum critical fluctuations. This can be investigated by a technique called inelastic neutron scattering.

Thermopower as a Unique Tool to Probe Quantum Phase Transitions

Stevan Arsenijevic

In my thesis, transport measurements such as resistivity and, more importantly, thermopower S, were used to explore the phase diagram of bad metals. Bad metals are electronically correlated systems whose ground state lies close to a quantum phase transition. By tuning the control parameters, such as temperature (T ), magnetic field (B), hydrostatic pressure (p) or chemical substitution (x), we can induce phase transitions between the various electronic, magnetic and structural phases. Here, the thermopower is presented as a unique tool for probing quantum phase transition because it is a measure of the entropy of conducting electrons. The main part of the thesis is dedicated to the study of Fe-based superconductors (FeSC) discovered in 2008. Their parent compound has an antiferromagnetic (AF) ground state, where the itinerant electrons form a spin-density wave (SDW), a periodic modulation of spin density. This coincides or is preceded by a structural, tetragonal-to-orthorhombic transition. The nesting between the electron and hole Fermi surface is believed to be the driving mechanism for the SDW state. By changing the structural or chemical properties the AF ground state of FeSC is suppressed, giving way to superconductivity (SC). The remaining antiferromagnetic fluctuations above the transition can provide a glue for SC pairing. Here, the analysis of the thermopower S/T of BaFe1−xCoxAs2 (BFCA) in the x-T phase diagram shows the signatures of the spin fluctuation which have a dome-like dependence and follow the trend of superconducting Tc . The logarithmic increase of S/T upon decreasing T is ascribed to the proximity of the spin-density-wave quantum critical point. It can be understood as an increase of entropy due to the incommensurate AF spin fluctuations. We can ascribe the high values of thermopower in BFCA at intermediate- and room-temperatures to the influence of low-T quantum criticality. To probe the response of the electronic system in FeSC to structural changes, we performed measurements under pressure of the parent compound BaFe2As2 (BFA), the SC electron-doped BFCA, and hole-doped Ba1−xKxFe2As2 (BKFA). In the parent compound pressure suppresses the structural/SDW transition, similar to the effect of doping. For doped systems, in order to describe the behavior of thermopower in the high-T range (above 100K) we used a semi-metallic two-band model which was fitted to the data in order to extract the pressure dependence of the band parameters. In both doping cases the effect of pressure was similar, an increase of the band overlap and of the effective number of charge carriers. With this model we can explain the high-T , x and p dependence of thermopower in both electron- and hole-doped BFA. In a structurally simpler Fe-chalcogenide Fe1+yTe1−xSex compound, the excess of Fe has a Kondo-like influence on the charge carriers which dramatically changes the physics of the normal state. To probe the normal state, pressure, doping, magnetic Fe-excess concentration (y) and temperature were used as control parameters. At low-T a characteristic upturn of resistivity (ρmag ) is observed, followed by an increase of thermopower (Smag ), which we identify as the magnetic contribution caused by the spin-flip scattering events. Increasing the y resulted in an increase of ρmag , and a decrease of Smag , which is in agreement with the behavior of canonical Kondo-systems. Pressure suppresses the magnetic contribution to transport, thus increasing the itinerancy of the system. MnSi is another system in which the sensitivity of thermopower to entropy brings new information related to the complex magnetic structure. Pressure was used to drive the system from a helically ordered, canonical Fermi-liquid (FL) phase with T 2-resistivity to the intrinsically disordered, non-Fermi-liquid (NFL) phase above pc with T3/2-dependence. Our contour plot of S/T demonstrated how powerful the thermopower technique is, by reproducing the whole previously established T -p phase diagram. At the phase transition from the magnetically-ordered FL phase to the disordered NFL, the thermopower is dramatically enhanced. We bring useful information about the mysterious partial order (PO) phase inside the NFL phase, previously detected only by neutron scattering. The fluctuating helices scenario can describe the observed increase of entropy/thermopower in the PO phase. At ambient pressure, close to the helical transition of MnSi, a moderate magnetic field can stabilize the skyrmion lattice - the lattice of topological magnetic whirls, vortices. We observe a signature of the skyrmion lattice as a minute drop in thermopower. It is located exactly in the same region of the T − B phase diagram where an increase in magnetoresistance and Hall effect was reported previously. This feature originates from the additional scattering of conducting electrons on magnetic vortices, while the change in S is dominated by the decrease of entropy as the stable skyrmion lattice is formed. Overall, resistivity was used to confirm the established phase diagram, while thermopower, as an interesting and not sufficiently understood technique, was used to probe the sensitive changes of the charge carriers at the Fermi surface. We explored various phases showing how useful thermopower is to probe the entropy of electronic system on the verge of quantum phase transition.

EPFL2012

Conductivity, dielectric and piezoelectric properties of SrBi4Ti4O15

Strontium Bismuth Titanate is a very promising material for high temperature piezoelectric applications, its elevated ferroelectric phase transition (530°C), linear piezoelectric properties under low field and relatively low room temperature conductivity (compared to others Bismuth Titanates) make it very attractive for precision sensors. However, under severe conditions (low frequency, high field, high temperature or low oxygen partial pressure) some of those advantages disappear. Piezoelectric response is dominated by charge drift in general becomes unstable. Above all, at high temperature and low oxygen partial pressure, a large conductivity increase reduces the piezoelectric efficiency of the material, in this work, electrical conductivity, piezoelectric properties and dielectric permittivity of SrBIT ceramic have been investigated in conditions of high temperature, low oxygen partial pressure, low to moderate driving field and frequency. As a result of this research, a better understanding of SrBIT properties was achieved. Thanks to a careful study of SrBIT processing as a bulk ceramic, a reproducible route was established. Many basic mechanisms leading to both SrBIT crystallization and sintering have been identified. It was demonstrated that a detailed knowledge of the exact processing conditions is required in order to achieve high quality material. DC conductivity measurements were carried out as a function of temperature, oxygen partial pressure and dopant concentration. It was found that the apparent activation energy for conduction for undoped SrBIT was 1 eV between 140 and 220°C and 1.5 eV between 450 and 700°C. Decrease of the activation energy in the lower temperature range has been discussed considering grain boundary conductivity, as a transition from electronic to ionic conduction or as consequence of small polarons conduction. It was shown that lower activation energy resulted from Manganese doping (0.5 eV), this was interpreted as either growing influence of grain boundary conductivity as dopant concentration increases or as shallow hole trap formation. DC conductivity measurements and acceptor/donor doping experiments demonstrated p-type conductivity in the low temperature range (up to 220°C) as donor doping decreases conductivity, while oxygen partial pressure controlled measurements indicated n-type conductivity at higher temperature (above 700°C). An electrical impedance analysis was performed with several equivalent circuits. The aim of these models was to simulate the impedance of SrBIT. The best approximation was found with a distributed element of Havriliak-Negami type. However, as the physical justification for this circuit was not clear, the investigation of the grain, grain boundary and electrode impedances was performed with multiple discrete parallel RC elements. With temperature, grain size and oxygen activity variations, the identification of three separate contributions as grain, grain boundary and electrode was realized. The anisotropy of conductivity and permittivity was demonstrated with textured material and both DC and AC analysis. With the master curves built for the electrical modulus, it was found that the impedance probably related to Bismuth oxide layers produces an additional high frequency are. From this finding and by comparing characteristic relaxation frequencies of undoped, 2 mol.% Mn and 4 mol.% Nb SrBIT, it was determined that conductivity is higher in the ab plane direction than in the c direction within both perovskite units and Bismuth oxide layers. With conductivity measurements under controlled oxygen partial pressure, it was found that an acceptor-based (intrinsic or extrinsic) model could be used to describe the electrical conductivity under controlled oxygen partial pressure of both undoped and 2 mol.% Mn doped SrBIT. However, as neither a pO2-1/6 region (intrinsic oxygen vacancies compensated by electrons) for undoped SrBIT nor a pO2-1/4 region (oxygen vacancies compensated by singly ionized acceptors) for Mn doped SrBIT were seen, it was concluded that the acceptorcontrolled model is not sufficient for a complete description of SrBIT. For this reason and in order to include the low oxygen partial pressure behavior of undoped SrBIT, a donor-based (intrinsic) model was also considered. The source of intrinsic donors would be in that case Bi3+ cations sitting on Sr2+ sites in the perovskite sublattice. Considering Bismuth vacancies as the negative compensating species, both pO2-1/4 and pO2-independent regions could be predicted with the model. However, even if the donor-controlled model seems to better match conductivity measurements in the full PO2) range, rejecting the acceptor-based model would be an error. It is actually not demonstrated that in SrBIT the concentration of exchanged Bismuth cations is always (all temperature, pressure) larger than the natural acceptor impurity concentration. It is very likely that the cation exchange is dependent of the oxygen partial pressure. It is also not proved as suggested in the literature that direct compensation between exchanged Strontium and Bismuth exists, reducing the net donor-excess. With the acceptor-controlled model, the mass-action constants for reduction and for ionization of intrinsic carriers across the band gap were determined. The band gap of SrBIT was estimated to be 3.5 eV. The ionic conductivity of SrBIT was determined at high temperature with measurements under controlled oxygen partial pressure. It was found that the electrical conductivity of SrBIT is probably mixed (electronic and ionic) as the estimation of the transference number provided quite large values (t=0.8 at 800°C). From electronic and ionic conductivity data, mixed conduction can actually be predicted in a large temperature range (above room temperature). The piezoelectric measurements using direct effect demonstrated that it is actually possible to unlock piezoelectrically active ferroelectric domain walls and create non-linear piezoelectric properties in undoped SrBIT. This occurs above a threshold elastic field, which is thermally activated. With a piezoelectric composite, it was demonstrated that the electromechanical coupling between two different phases creates a piezoelectric relaxation. This one could be positive or negative depending on the respective properties of each composite's component. It was shown experimentally that a small temperature change is sufficient to transform a positive relaxation into a negative one. While these experiments did not provide a detailed microstructural explanation for the piezoelectric relaxation observed in 2 mol.% Mn doped SrBIT, they gave a first insight into an original phenomenological approach. Microstructure and piezoelectric properties were related with the calculation of a piezoelectric relaxation composite made of two textured samples. This demonstrated that a piezoelectric relaxation may occur just because of anisotropy. Microstructural reproduction of this coupling is actually an important feature of Aurivillius phases.

EPFL2000

Pulsed laser deposition of (SrBa)Nb2O6 thin films and their properties

Anna Infortuna

Strontium barium niobate (SrxBa1-xNb2O6, shortly SBN) is a solid solution system with tetragonal tungsten bronze crystal structure. It exhibits a ferroelectric phase with only one polar axis and a transition temperature depending on the Sr/Ba ratio. This thesis studies the growth of SBN thin films, in order to obtain a ferroelectric thin film model system for the study of 180° domain switching close to the ferroelectric phase transition. SBN has been chosen not only because uniaxial, but because it is possible to tune the temperature of phase transition varying the Sr/Ba ratio. It is thus possible to study electric properties of the phase transition close to room temperature, where conduction phenomena related to defects are normally lower. Thin films of SBN were grown by Pulsed Laser Deposition in a vacuum system constructed during this thesis work. For the formulation of a model it is desirable to have a system as close as possible to a single crystal. Therefore deposition parameters have been optimized to grow SBN thin films with the polar axis oriented perpendicular to the film plane. The films are integrated in parallel plate capacitor structures, in order to measure dielectric properties. The stability of the ferroelectric phase is found to be sensitive to impurities; contaminants with concentration below 1% induce a lowering of the transition temperature of about 100°C. Strain as well has influence on the phase transition; in the case of substrate with thermal expansion coefficients different from the SBN ones, the SBN film is under stress. A 0.6% tensile strain induces a lowering of the transition temperature of about 100°C, this is the case of silicon single crystal substrate. Grown on strontium titanate single crystals (STO), whose thermo-mechanical properties are close to the one of SBN, the films exhibit a phase transition temperature compatible with the one measured on single crystals. The obtained films suffer from leakage that is reduced by thermal treatment in oxygen rich atmosphere. The oxygen vacancies, created during the deposition process, are considered to be responsible of leakage. Vacancies recovery upon annealing does not eliminate the problem, and measurement of polarization at room temperature is difficult. However, piezoelectric measurements performed on individual grains, with atomic force microscope, prove that these have ferroelectric properties; by these experiment has been proved that it is possible to switch the polarization. Films with a disordered structure of grains are much less leaky than the ones with columnar grains spanning the whole cross section. These observations lead to the conclusion that conduction goes trough the grain boundaries. On STO single crystals, SBN grows epitaxial in Volmer-Weber mode. With a suitable preparation of the substrate surface, it is possible to induce the growth of films with different orientations of the polar axis: in the film plane, perpendicular to it or inclined of 45°. A model is proposed, explaining the epitaxial relation with the substrate on the basis of the perovskite kernel contained in the unit cell of the tetragonal tungsten bronze structure. The film grows from the nucleation of the perovskite structure that rules the orientation of the film; the high temperature at which the substrate is kept during the deposition, assure the necessary mobility for the arriving atoms to organize in the SBN structure around these nuclei. The study of literature data allows to state that such a model is valid not only for substrates with perovskite structure, but can be extended to substrates with a cubic crystal structure, like magnesium oxide.

EPFL2005