Separation of platelets from other blood cells in continuous-flow by dielectrophoresis field-flow-fractionation

Niccolo Piacentini, Philippe Renaud, Raphaël Tornay
American Institute of Physics, 2011
Journal paper

Abstract

We present a microfluidic device capable of separating platelets from other blood cells in continuous flow using dielectrophoresis field-flow-fractionation. The use of hydrodynamic focusing in combination with the application of a dielectrophoretic force allows the separation of platelets from red blood cells due to their size difference. The theoretical cell trajectory has been calculated by numerical simulations of the electrical field and flow speed, and is in agreement with the experimental results. The proposed device uses the so-called "liquid electrodes" design and can be used with low applied voltages, as low as 10 V(pp). The obtained separation is very efficient, the device being able to achieve a very high purity of platelets of 98.8% with less than 2% cell loss. Its low-voltage operation makes it particularly suitable for point-of-care applications. It could further be used for the separation of other cell types based on their size difference, as well as in combination with other sorting techniques to separate multiple cell populations from each other. (C) 2011 American Institute of Physics.

Official source

https://infoscience.epfl.ch/record/170386?ln=en

About this result

This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.

Related concepts

Related publications

, , ,

The isolation, analysis, and enumeration of circulating tumor cells (CTCs) from cancer patient blood samples are a paradigm shift for cancer patient diagnosis, prognosis, and treatment monitoring. Most methods used to isolate and enumerate these target cells rely on the expression of cell surface markers, which varies between patients, cancer types, tumors, and stages. Here, we propose a label-free high-throughput platform to isolate, enumerate, and size CTCs on two coupled microfluidic devices. Cancer cells were purified through a Vortex chip and subsequently flowed in-line to an impedance chip, where a pair of electrodes measured fluctuations of an applied electric field generated by cells passing through. A proof-of-concept of the coupling of those two devices was demonstrated with beads and cells. First, the impedance chip was tested as a stand-alone device: (1) with beads (mean counting error of 1.0%, sizing information clearly separated three clusters for 8, 15, and 20 um beads, respectively) as well as (2) with cancer cells (mean counting error of 3.5%). Second, the combined setup was tested with beads, then with cells in phosphate-buffered saline, and finally with cancer cells spiked in healthy blood. Experiments demonstrated that the Vortex HT chip enriched the cancer cells, which then could be counted and differentiated from smaller blood cells by the impedance chip based on size information. Further discrimination was shown with dual high-frequency measurements using electric opacity, highlighting the potential application of this combined setup for a fully integrated label-free isolation and enumeration of CTCs from cancer patient samples. (c) 2019 International Society for Advancement of Cytometry

WILEY2019

Continuous-flow electrical lysis device with integrated control by dielectrophoretic cell sorting

Thomas Michael Braschler, Nicolas Demierre, Niccolo Piacentini, Philippe Renaud

We present a device capable of electrical cell lysis and evaluation of lysis efficiency in continuous flow using dielectrophoretic cell sorting. We use a combination of AC electrical fields and so-called liquid electrodes to avoid bubble creation at the electrode surface. The electrical field distribution is calculated in different electrode configurations by numerical simulations. Cell sorting shows high lysis efficiency, 99% of yeast cells sorted after lysis featuring dielectric properties similar to dead cells. A study of the potential device throughput is performed.

Royal Society of Chemistry2010

Cell viability assessment by flow cytometry using yeast as cell model

Nina Buffi, Niccolo Piacentini, Philippe Renaud, Raphaël Tornay

This paper reports the new combination of cell sorting and counting capabilities on a single device. Most state-of-the-art devices combining these technologies use optical techniques requiring complicated experimental setups and labeled samples. The use of a label-free, electrical device significantly decreases the system complexity and makes it more appropriate for use in point-of-care diagnostics. Living and dead yeast cells are separated by dielectrophoretic forces and counted using coulter counters. The combination of these two methods allows the determination of the percentage of living and dead cells for viability studies of cell samples. The device could further be used for sorting and counting of blood cells in applications such as diagnosis of insufficient cell concentrations, identification of cell deficiencies or bacterial contamination. The use of dielectrophoresis (DEP) as sorting principle allows to separate cells based on their dielectric properties in the place of size-based separation, enabling sorting of large panels of cells and separation of infected and non-infected cells of the same type.

2011