Flow Boiling of R134a in a Multi-Microchannel Heat Sink with Hotspot Heaters for Energy-Efficient Microelectronic CPU Cooling Applications
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
Xu et al. have recently published a set of results for boiling heat transfer measurements in a multi- channel micro- scale evaporator for flow boiling of acetone in triangular cross- section channels ( hydraulic diameter of 155.4 mm). In the present collab ...
This article presents experimental results of heat transfer from two different studies [1, 2] for horizontal flow boiling inside smooth copper tubes with different refrigerants. The main goal of this study was to verify the influence of the saturation temp ...
A comprehensive review of flow boiling characteristics and flow pattern visualization of refrigerant/lubricant oil mixtures is presented in this paper. First, various parameters influenced by the lubricant oil in convective boiling of refrigerants, such as ...
The current industrial need for compact high heat density cooling devices has conveyed an increasing interest on convective boiling in micro-channels. Although there is general agreement that these systems may be able to dissipate potentially very high hea ...
This article investigates the effect of inlet orifices on saturated critical heat flux (CHF) in multi-microchannel heat sinks. Two different multi-microchannel heat sinks made in copper were tested with three low pressure refrigerants (R134a, R236fa, R245f ...
Ieee Service Center, 445 Hoes Lane, Po Box 1331, Piscataway, Nj 08855-1331 Usa2009
Experimental pressure drop results on boiling water flow through three helical coils of tube inner diameter of 4.03 mm and 4.98 mm and coil diameter to tube diameter ratio of 26.1, 64.1 and 93.3 are presented. Both subcooled and saturated flow boiling are ...
An electrically heated foil glued on top of an acrylic wall is employed to measure convective heat transfer on turbine vane platforms. The use of a heater foil requires specific filtering techniques to obtain the searched quantities – heat transfer coeffic ...
New saturated critical heat flux (CHF) data have been obtained experimentally in two different multi-microchannel heat sinks made in copper with three low pressure refrigerants (R134a, R236fa, R245fa). One of the test sections had 20 parallel rectangular c ...
Single pan thermal analyses (SPTA) have been performed on Cu–14.5 wt.% Sn, Cu–21.3 wt.% Sn and Cu–26.8 wt.% Sn peritectic alloys. For this purpose, a SPTA assembly has been built and calibrated. As the latent heat is a function of temperature and compositi ...
A new falling film heat transfer test facility has been built for the measurement of local heat transfer coefficients on a vertical array of horizontal tubes, including flow visualization capabilities, for use with refrigerants. Presently, the facility has ...
