Heat transfer through cable insulation of Nb-Ti superconducting magnets operating in He II

Pier Paolo Granieri
Elsevier, 2013
Journal paper

Abstract

The operation of Nb–Ti superconducting magnets in He II relies on superfluidity to overcome the severe thermal barrier represented by the cable electrical insulation. In wrapped cable insulations, like those used for the main magnets of the Large Hadron Collider (LHC) particle accelerator, the micro-channels network created by the insulation wrappings allows to efficiently transfer the heat deposited or generated in the cable to the He bath. In this paper, available experimental data of heat transfer through polyimide electrical insulation schemes are analyzed. A steady-state thermal model is developed to describe the insulation of the LHC main dipole magnets and the Enhanced Insulation proposed for the High Luminosity LHC upgrade (HLLHC), according to the relevant geometric parameters. The model is based on the coupled mechanisms of heat transfer through the bulk of the dielectric insulation and through micro-channels between the insulation tapes. A good agreement is found between calculations and tests performed at different applied pressures and heating configurations. The model allows identifying the heat fluxes in the cable cross-section as well as the dimensions of the micro-channels. These dimensions are confirmed by microscope images of the two insulations schemes.

Official source

https://infoscience.epfl.ch/record/180839?ln=en

About this result

This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.

Related concepts

Related publications

In this thesis work we investigate the heat transfer through the electrical insulation of superconducting cables cooled by super fluid helium. The cable insulation constitutes the most severe barrier for heat extraction from the superconducting magnets of the CERN Large Hadron Collider (LHC). We performed an experimental analysis, a theoretical modeling and a fundamental research to characterize the present LHC insulation and to develop new ideas of thermally enhanced insulations. The outcome of these studies allowed to determine the thermal stability of the magnets for the LHC and its future upgrades. An innovative measurement technique was developed to experimentally analyze the heat transfer between the cables and the super fluid helium bath. It allowed to describe the LHC coil behavior using the real cable structure, an appropriate thermometry and controlling the applied pressure. We developed a new thermally enhanced insulation scheme based on an increased porosity to super uid helium. It aims at withstanding large heat loads, as needed for the High Luminosity LHC upgrade (HL-LHC). Experimental measurements of the new insulation showed a major improvement of heat extraction compared to the present state-of-the-art used in the LHC. We developed a theoretical heat transfer model quantitatively explaining the experimental results of the LHC and HL-LHC insulations. We identified the heat extraction mechanisms, mainly occurring through super fluid helium micro-channels. The average micro-channels dimensions were estimated to vary between few and dozens of µm, depending on the insulation scheme. In the model we considered the known laws describing the dynamic regimes of super fluid helium. However such laws were never demonstrated to be valid in the narrow channels typical of the cable insulation. We developed a new experimental device to investigate heat transport through microchannels. Micro-fabrication techniques were used to etch the channels down to a depth of 16 µm. We measured the classical laminar and turbulent regimes, thus demonstrating the validity of such heat transport laws independently from the channel geometrical shape and size down to these dimensions. To conclude, we used the obtained experimental and theoretical heat transfer results to determine the LHC and HL-LHC magnets stability. We estimated their quench margin and compared it to the beam induced heat deposit. The resulting difference allows a safe operation of the magnets.

EPFL2012

Heat Transfer in an Enhanced Cable Insulation Scheme for the Superconducting Magnets of the LHC Luminosity Upgrade

Pier Paolo Granieri, Davide Tommasini

The next generation of superconducting magnets for the interaction regions of particle colliders, as well as for fast cycled accelerators, will be confronted with large heat loads. In order to improve the evacuation of heat from the Nb-Ti coil towards He-II bath, a porous (enhanced) all-polyimide cable insulation scheme was proposed recently. The first results were promising, featuring a larger permeability to helium with respect to existing schemes under low compressive stress. In this paper we present an extended experimental study of heat transfer through the Enhanced Insulation into He-II bath, and comparison to the standard LHC insulation, at different levels of applied pressure. The thermal coupling between adjacent cables was investigated, as well as the impact of a localized heat deposition versus a distributed one. The results of this study show that, up to high pressure levels, the enhanced insulation scheme can provide a major improvement of heat transfer compared to the standard scheme used in the main LHC magnets.

2010

Heat Transfer in the LHC Main Superconducting Bus Bars

Pier Paolo Granieri

CERN is performing a systematic analysis of the interconnecting bus bars of the Large Hadron Collider (LHC) main magnets. Their thermal, electrical, mechanical and hydraulic performances are addressed. In the frame of these studies, the heat transfer between the main superconducting (SC) bus bars and the surrounding He bath is investigated. It represents a key parameter in the comprehension of the bus bars stability and quench propagation mechanisms, thus crucial for the analysis of the 2008 incident which was triggered by a defective bus bars joint. This paper reports on the experimental tests and relative analysis aiming at describing the thermal behavior of the LHC main bus bars.

2010

EPFL2012