Modelling oriented investigations of primary radiation damage in ultra high purity Fe and FeCr alloys

In the quest of the structural materials for the future fusion reactor, it has been shown that ferritic/martensitic (F/M) steels are very promising candidates, with a good radiation resistance in terms of damage accumulation in the microstructure relative to for example austenitic steels. However, our ability to predict their response to irradiation in such harsh conditions is still not satisfactory. In this view, there is a critical need for information on the primary damage occuring in this materials class, as input to the multiscale modelling of the irradiation effects, including the impact of He and H. Despite numerous studies in the last 50 years, there is still lack of knowledge in many areas of the irradiation response of the microstructure of ferritic steels. This is due to the complexity of these materials, for they contain numerous alloying elements, grains boundaries and precipitates. The strategy nowadays to identify basic mechanisms of primary damage is to investigate so-called model alloys of those, which allows parametric studies in simplified structures. In this work ultra high purity Fe and Fe(Cr) model alloys were investigated in a transmission electron microscope (TEM) under ion irradiation in an attempt to better understand the fundamental mechanisms of radiation damage starting from the lowest doses, and the dependence on Cr content. Attention is also paid to the effects of He and H. Radiation induced dislocation loops and cavities were quantified. This study provides data for validation of the modelling efforts. Single, dual and triple beam ion irradiations were performed in JANNuS facility located on two sites, in Orsay and in Saclay in France. In Orsay, electron transparent thin foils of UHP Fe, Fe -5, -10 and -14Cr were irradiated in situ in TEM as a single beam experiment with 500 keV Fe+ ions and as a dual beam experiment with 500 keV Fe+ and 10 keV He+ ion beams, to a dose of 1 dpa with and without 1000 appm/dpa He at room and liquid nitrogen temperatures in order to observe the very first defects, desirably before their thermal evolution. Effects of dose rate on the produced damage were assessed in UHP Fe. The impact of He and Cr on defect accumulation was scrutinized in terms of the number density, size and Burgers vector of the visible defects. Special care was taken in the analysis of the TEM micrographs, for which new techniques were developed, with a particular one to determine the Burgers vector of a dense dispersion of fine nanometric defects. Emphasis was put on the identification of the loops Burgers vector, which is considered to be either a0〈100〉 or 1/2 a0〈111〉 in ferritic materials. 2 In order to study the effect of the free surfaces of the electron transparent thin specimens on the irradiation induced microstructure, the results obtained for TEM thin foils were compared to bulk samples that were irradiated ex situ in Saclay in single beam experiments with 24 MeV Fe8+ ions, and dual beam ones with 24 MeV F