Spectroscopic needs for imaging dark energy experiments

Ongoing and near-future imaging-based dark energy experiments are critically dependent upon photometric redshifts (a.k.a. photo-z's): i.e., estimates of the redshifts of objects based only on flux information obtained through broad filters. Higher-quality, lower-scatter photo-z's will result in smaller random errors on cosmological parameters; while systematic errors in photometric redshift estimates, if not constrained, may dominate all other uncertainties from these experiments. The desired optimization and calibration is dependent upon spectroscopic measurements for secure redshift information; this is the key application of galaxy spectroscopy for imaging-based dark energy experiments. Hence, to achieve their full potential, imaging-based experiments will require large sets of objects with spectroscopically-determined redshifts, for two purposes: Training: Objects with known redshift are needed to map out the relationship between object color and z (or, equivalently, to determine empirically-calibrated templates describing the rest-frame spectra of the full range of galaxies, which may be used to predict the color-z relation). The ultimate goal of training is to minimize each moment of the distribution of differences between photometric redshift estimates and the true redshifts of objects, making the relationship between them as tight as possible. The larger and more complete our "training set" of spectroscopic redshifts is, the smaller the RMS photo-z errors should be, increasing the constraining power of imaging experiments. Requirements: Spectroscopic redshift measurements for similar to 30,000 objects over >similar to 15 widely-separated regions, each at least similar to 20 arcmin in diameter, and reaching the faintest objects used in a given experiment, will likely be necessary if photometric redshifts are to be trained and calibrated with conventional techniques. Larger, more complete samples (i.e., with longer exposure times) can improve photo-z algorithms and reduce scatter further, enhancing the science return from planned experiments greatly (increasing the Dark Energy Task Force figure of merit by up to similar to 50%). Options: This spectroscopy will most efficiently be done by covering as much of the optical and near-infrared spectrum as possible at modestly high spectral resolution (lambda/Delta lambda > similar to 3000), while maximizing the telescope collecting area, field of view on the sky, and multiplexing of simultaneous spectra. The most efficient instrument for this would likely be either the proposed GMACS/MANIFEST spectrograph for the Giant Magellan Telescope or the OPTIMOS spectrograph for the European Extremely Large Telescope, depending on actual properties when built. The PFS spectrograph at Subaru would be next best and available considerably earlier, c. 2018; the proposed ngCFHT and SSST telescopes would have similar capabilities but start later. Other key options, in order of increasing total time required, are the WFOS spectrograph at TMT, MOONS at the VLT, and DESI at the Mayall 4 m telescope (or the similar 4MOST and WEAVE projects); of these, only DESI, MOONS, and PFS are expected to be available before 2020. Table 2-3 of this white paper summarizes the observation time required at each facility for strawman training samples. To attain secure redshift measurements for a high fraction of targeted objects and cover the full redshift span of future experiments, additional near-infrared spectroscopy will also be required; this is best done from space, particularly with WFIRST-2.4 and JWST. Calibration: The first several moments of redshift distributions (the mean, RMS redshift dispersion, etc.), must be known to high accuracy for cosmological constraints not to be systematics-dominated (equivalently, the moments of the distribution of differences between photometric and true redshifts could be determined instead). The ultimate goal of calibration is to characterize these moments for every subsample used in analyses - i.e., to minimize the uncertainty in their mean redshift, RMS dispersion, etc. - rather than to make the moments themselves small. Calibration may be done with the same spectroscopic dataset used for training if that dataset is extremely high in redshift completeness (i.e., no populations of galaxies to be used in analyses are systematically missed). Accurate photo-z calibration is necessary for all imaging experiments. Requirements: If extremely low levels of systematic incompleteness (

NEAR-ULTRAVIOLET SPECTROSCOPY OF STAR-FORMING GALAXIES FROM eBOSS: SIGNATURES OF UBIQUITOUS GALACTIC-SCALE OUTFLOWS

Johan Comparat, Timothée Guy Olivier Delubac, Jean-Paul Richard Kneib, Jeffrey Newman, Anand Stéphane Raichoor

We present rest-frame near-ultraviolet (NUV) spectroscopy of star-forming galaxies (SFGs) at 0.6 < z < 1.2 from the Extended Baryon Oscillation Spectroscopic Survey (eBOSS) in SDSS-IV. One of the eBOSS programs is to obtain 2 ''. (about 15 kpc) fiber spectra of about 200,000 emission-line galaxies (ELGs) at redshift z greater than or similar to 0.6. We use the data from the pilot observations of this program, including 8620 spectra of SFGs at 0.6 < z < 1.2. The median composite spectra of these SFGs at 2200 angstrom < lambda < 4000 angstrom feature asymmetric, preferentially blueshifted non-resonant emission, Fe II*, and blueshifted resonant absorption, e.g., Fe II and Mg II, indicating ubiquitous outflows driven by star formation at these redshifts. For the absorption lines, we find a variety of velocity profiles with different degrees of blueshift. Comparing our new observations with the literature, we do not observe the non-resonant emission in the small-aperture (< 40 pc) spectra of local star-forming regions with the Hubble Space Telescope, and find the observed line ratios in the SFG spectra to be different from those in the spectra of local star-forming regions, as well as those of quasar absorption-line systems in the same redshift range. We introduce an outflow model that can simultaneously explain the multiple observed properties and suggest that the variety of absorption velocity profiles and the line ratio differences are caused by scattered fluorescent emission filling in on top of the absorption in the large-aperture eBOSS spectra. We develop an observation-driven, model-independent method to correct the emission infill to reveal the true absorption profiles. Finally, we show that the strengths of both the non-resonant emission and the emission-corrected resonant absorption increase with [O II] lambda lambda 3727, 3730 rest equivalent width and luminosity, with a slightly larger dependence on the former. Our results show that the eBOSS and future dark-energy surveys (e.g., Dark Energy Spectroscopic Instrument survey and Prime Focus Spectrograph survey) will provide rich data sets of rest-frame NUV spectroscopy for astrophysical applications.

Iop Publishing Ltd2015

Astrophysical applications of gravitationally lensed quasars

Alexander Eigenbrod

Gravitational lensing describes how light is deflected as it passes in the vicinity of a mass distribution. The amplitude of the deflection is proportional to the mass of the deflector, called "gravitational lens", and is generally weak, even for large masses. The faintness of this phenomenon explains why gravitational lensing remained essentially unobserved until the late 1970s (only gravitational lensing by the Sun has been observed during the solar eclipse of 1919). Before that time, gravitational lensing was considered merely as a theoretical curiosity. However, the situation dramatically changed with the discovery of the first extragalactic gravitational lens in 1979. Since then, together with the technological progress of astronomical instruments, gravitational lensing has turned from a curiosity into a powerful tool to address important astrophysical and cosmological questions. The present thesis focuses on applications related to gravitationally lensed quasars. Quasars are active galactic nuclei, where matter is heated up as it spirals down onto the central supermassive black hole. When a galaxy is located on the line of sight to a distant quasar, it acts as a gravitational lens and produces multiple images of this background source. The light of the quasar follows different paths for each of its images. Thus, variations of the intrinsic quasar luminosity are observed at different times in each image. The time delays between the images can be used to determine the Hubble constant H0, because they are inversely proportional to H0. This constant describes the current expansion rate of the Universe, and is one of the fundamental parameters of cosmological models. Many efforts have been spent over the years to determine H0, but its value is still poorly constrained. Gravitational lensing has the potential to noticeably decrease the uncertainty of H0. In practice, this requires regular and long-term monitoring of lensed quasars. We have run a series of numerical simulations to both optimize the available telescope time, and measure the time delays with an accuracy of a few percent. The results of these simulations are presented in the form of compact plots to be used to optimize the observational strategy of present and future monitoring programs. Once the time delays are measured, one can infer estimates of H0, provided several other observational constraints are available. A key element to accurately convert time delays into H0 is the redshift of the lensing galaxy. These redshift measurements are difficult because lensing galaxies are generally hidden in the glare of the much brighter quasar images. As a consequence, lens redshifts are often poorly constrained or even completely unknown. We have acquired spectroscopic data of sixteen lensing galaxies with the Very Large Telescope located in Chile. In combination with a powerful deconvolution algorithm, we determine the redshift of these sixteen lensing galaxies, which represents about 25% of all currently known quasar lensing galaxies. These results are useful for both H0 determinations and statistical studies of gravitational lenses, which can be used to provide new constraints on cosmological parameters. While the first part of this thesis focuses on the acquisition of observational constraints for the lens models, the main part consists in using the phenomenon of microlensing to determine the energy profile (or spatial structure) of quasar accretion disks. Microlensing is produced by the stars located in the lensing galaxy. These stars act as secondary lenses, and are called microlenses. Since the stars are moving in the galaxy, they induce flux and color variations in the images of the lensed quasar. These effects can be used as a natural telescope to probe the still mysterious inner structures of quasars with a spatial resolution about ten thousand times better than the capacities of current astronomical instruments, including the Very Large Telescope Interferometer. We present a three-year long spectrophotometric monitoring of the lensed quasar QSO 2237+0305, also known as the Einstein Cross, conducted at the Very Large Telescope. This monitoring reveals significant microlensing-induced variations in the spectra of the quasar images. In a subsequent analysis, we find that the source responsible for the optical and ultraviolet continuum has an energy profile well reproduced by a power-law R α λζ with ζ = 1.2 ± 0.3, where R is the size of the source emitting at wavelength λ. This agrees with the predictions of the standard thin accretion disk model and is, so far, the most accurate determination of a quasar energy profile. As a complement to our microlensing study, we have obtained high spectral and spatial resolution observations of the lensing galaxy of QSO 2237+0305. Our spectroscopic data are acquired with the SINFONI, FLAMES, and FORS2 spectrographs of the Very Large Telescope. We describe the reduction of these data, and provide the currently best and most complete determination of the kinematics of a gravitational lens. The comparison of our data with previously published dynamical models suggests that those may have overestimated the mass of the galaxy bulge. Thus, new and more sophisticated models are required. These models, combined with gravitational lensing, will provide two independent constraints on the mass distribution. This will allow to better determine the quantity and distribution of dark matter in this lensing galaxy, and especially in its extended halo.

EPFL2008

The distribution of dark matter and gas spanning 6 Mpc around the post-merger galaxy cluster MS0451-03

David Richard Harvey, Mathilde Jauzac, Baptiste Philippe Klein, Jean-Paul Richard Kneib, Richard Massey

Using the largestmosaic of Hubble Space Telescope images around a galaxy cluster, we map the distribution of darkmatter throughout an similar to 6 x 6 Mpc(2) area centred on the clusterMS 0451-03 (z = 0.54, M-200 = 1.65 x 10(15) M-circle dot). Our joint strong- and weak-lensing analysis shows three possible filaments extending from the cluster, encompassing six group-scale substructures. The dark matter distribution in the cluster core is elongated, consists of two distinct components, and is characterized by a concentration parameter of c(200) = 3.79 +/- 0.36. By contrast, XMM-Newton observations show the gas distribution to be more spherical, with excess entropy near the core, and a lower concentration of c(200) = 2.35(-0.70)(+0.89) (assuming hydrostatic equilibrium). Such a configuration is predicted in simulations of major mergers 2-7 Gyr after the first core passage, when the two dark matter haloes approach second turnaround, and before their gas has relaxed. This post-merger scenario finds further support in optical spectroscopy of the cluster's member galaxies, which shows that star formation was abruptly quenched 5Gyr ago. MS0451-03 will be an ideal target for future studies of the growth of structure along filaments, star formation processes after a major merger, and the late-stage evolution of cluster collisions.