Two-Phase Heat Transfer Mechanisms within Plate Heat Exchangers
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
This study examines experimentally the effect of stators on the performance and heat transfer characteristics of small axial cooling fans. A single fan impeller, followed by nine stator blades in the case of a complete stage, was used for all the experimen ...
A new concept of polyimide electrical insulation for superconducting cables of accelerator magnets was developed in the last years. Its enhanced He II permeability allows a significant improvement of the heat extraction from the coil. This cable insulation ...
Improving the energy efficiency of cooling systems can contribute to reduce the emission of greenhouse gases. Currently, most microelectronic applications are air-cooled. Switching to two-phase cooling systems would decrease power consumption and allow for ...
The consequences of climate change are clearly visible in the Swiss Alps. In the past decades, increasing air temperatures have induced pronounced glacier retreat and permafrost thawing. Thawing permafrost in steep terrain is a potential natural hazard, as ...
The present study focuses on an experimental investigation of two-phase flow boiling in a silicon multi-microchannel evaporator, which emulates a single layer of a 3D stacked computer chip. The micro-evaporator is comprised of 67 parallel channels, each ha ...
This paper presents experimental results for flow boiling heat transfer coefficient and critical heat flux (CHF) in small flattened tubes. The tested flattened tubes have the same equivalent internal diameter of 2.2 mm, but different aspect height/width ra ...
For falling film evaporation, the most important thermal design parameters that need to be predicted are the onset of dryout, after which a severe degradation in the evaporator performance is found, and the local heat transfer performance in fully wet and ...
In previous research we have demonstrated a micro thermomechanical pyroelectric generator (mu TMPG) as an alternative to thermoelectric generators to harvest ambient heat energy. In such a device, a thermal mass oscillates between a hot and a cold side by ...
This project aims to improve the technique of self-cleaning stencil based on heated membranes and minimize the clogging of stencil’s apertures. To this end, theory on vapor condensation has been developed for Aluminum, Chromium, Titanium, Gold and Platinum ...
In the first part of this article (Silva Lima and Thome 2012b), new experimental frictional pressure drop data in U-bends were presented and discussed. The experimental data were obtained for R410A and R134a at two saturation temperatures (5 degrees C and ...
