Electrochemical oxidation of p -chlorophenol on SnO2–Sb2O5 based anodes for wastewater treatment
Related publications (87)
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
The tribocorrosion behavior of tungsten sliding against an alumina ball was evaluated in sulfuric acid under applied electrode potential. Surface chemistry of worn and unworn surfaces was evaluated using XPS and AES. Quasi-potentiostatic polarization curve ...
Real-time X-ray microscopy was used to study the influence of hydrogen-bubble formation on the morphology of ramified zinc electrodeposit. The experimental results show that when intense hydrogen bubbling occurs at high potential, the morphology of the ram ...
As conventional fabrication techniques reach their limits novel techniques are needed for fabrication of structures in the nanometer range. This thesis investigates new methods to create metal nanostructures or nanoparticles with an STM tip or a sharp meta ...
On-column conductivity detection in capillary-chip electrophoresis was achieved by actively coupling the high electric field with two sensing electrodes connected to the main capillary channel through two side detection channels. The principle of this conc ...
The electrochemical oxidation of ammonia was investigated on a Ni/Ni(OH)(2) electrode prepared by potential cycling of a Ni electrode in 1 M NaClO4. It was found that oxidation of ammonia is strongly pH dependent and proceeds mainly at pH values above 7. T ...
The chemical-mechanical polishing process (CMP) is an essential part of the production of integrated circuits. Metal to be polished in the CMP reacts with the oxidants from the aqueous suspension (slurry) and the passive film is formed on the metal surface ...
This work presents an investigation of the tribocorrosion of ruthenium in sulphuric acid solutions. The study was focused on the effect of the electrode potential on wear of ruthenium during sliding against an inert alumina ball in a reciprocating sliding ...
A minidevice for performing gel-free proteome prefractionation via conventional IEF in soluble carrier ampholyte buffers is reported here. It consists of a compact block of poly-oxymethylene in which eight samples and two electrode chambers are machined. E ...
The electrochemical oxidation of 3,4-(methylenedioxy)phenylmethanol (piperonyl alcohol) was characterized by cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS). Two electrochemical oxidation signals were found for piperonyl alcohol. T ...
DNA functionalised semiconductor metallic oxide electrodes have been developed for the direct electrochemical detection of DNA hybridization, without labelling or the introduction of a redox couple. Conductive CdIn2O4 thin films with controlled properties ...