Radial-Force-Based Swirling Actuator with Surface-Permanent-Magnet Structure for Low-Speed High-Torque Applications
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
This paper describes a new method to estimate the standstill position of Permanent Magnet Synchronous Motors (PMSM). The method is based on the anisotropic properties of permanent magnets and is therefore referred to as Magnetic Anisotropy Method (MAM). Th ...
A complete characterization, based on fs pump-probe spectroscopy and mol. dynamics simulations, is presented of the ultrafast dynamics of electronic bubble formation in solid para-H2 upon impulsive excitation of impurity-doped sites, which correlate with t ...
Sensorless control of PMSM's (Permanent Magnet Synchronous Motors) has occupied scientists for a long time. The result of this research is becoming widely accepted by the industry due to its low cost and reliability. However, the majority of today's motor ...
In a recent paper [R. Finn, Phys. Fluids 18, 047102 (2006)] the attention has been drawn on the tension component perpendicular to the solid surface that results from Young's law. Considering the problem of a solid sphere floating in zero gravity, it has b ...
This paper presents an analytical formula for the permanent magnet (PM) magnetomotive force (MMF) in a slotted PM rotating motor. To derive this formula, an analytical 2D solution of Poisson's equation for the equivalent slotless configuration using the Fo ...
Institute of Mechatronics and Information Systems2004
Motor parts produced by casting are subjected to particularly high local stresses and must be reinforced by high-strength inserts. The insertion is normally made mechanically after casting, but, if good adhesion could be obtained, it would be preferable to ...
NOVELTY - For control mono-phase or multiphase machines in motor or generating mode with or without pulse width modulation. USE - Control of electrical rotating machines. ADVANTAGE - Can be used for control of single phase and three phase machines. DETAILE ...
The paper proposes a new method to determine the tooth cogging force in a brushless DC (BLDC) motor which is used in a hard-disk application. This force might be a source of tooth vibrations and motor noise. In the new method, the permanent-magnet (PM) pol ...
Usually, each phase of the direct reluctance motor is fed separately by its own inverter producing a squarewave phase current depending on the rotor position. In the present work, a star-connection of the three stator phases is used and the direct reluctan ...
