Publication

Multi-temperature heat pumps: A literature review

Related publications (115)

Small-scale turbopumps for waste heat recovery applications based on an organic Rankine cycle: a study from pre-design to experimental validation

The organic Rankine cycle (ORC) system is among the technologies applied to exploit waste heat in vehicles. Since common organic fluids have lower latent heat than water, higher mass flow rates are required to convert the same waste heat, considerably incr ...

EPFL2023

EPFL's District Heating Heat Pump - Performance Analysis for DIfferent Working Fluids

Sylvain Clément

The present case study is multi-criteria performance analysis of EPFL’s heat pump for different working fluids. The heat pump is based on a 2-stage vapour compression cycle which is modelled using the software Belsim VALI for 7 low-GWP refrigerants. The si ...

2021

3D-ICE 3.0: efficient nonlinear MPSoC thermal simulation with pluggable heat sink models

David Atienza Alonso, Marina Zapater Sancho, Federico Terraneo

The increasing power density in modern high-performance multi-processor system-on-chip (MPSoC) is fueling a revolution in thermal management. On the one hand, thermal phenomena are becoming a critical concern, making accurate and efficient simulation a nec ...

2021

System for co2 capture from internal combustion engine

François Maréchal, Shivom Sharma

System (2) for CO2 capture from a combustion engine (1) comprising an exhaust gas flow circuit (6) having an inlet end fluidly connected to an exhaust of the combustion engine, a heat exchanger circuit (12), a primary exhaust gas heat exchanger (H1) for tr ...

2020

Influencing factors on flow boiling of carbon dioxide in enhanced tubes and comparison with correlations

John Richard Thome

Carbon dioxide two-phase flow characteristics are different from those of conventional refrigerants, due to the CO2 particular thermodynamic and transport properties obtained by working at high reduced pressures. Moreover, the use of peculiar heat transfer ...

IOP PUBLISHING LTD2020

Heat source and voiding signatures of Mullins damage in filled EPDM

Nicolas Candau, Oguzhan Oguz

The thermomechanical coupling of Mullins damage in filled EPDM has been investigated by analysing the self-heating via Infrared thermography (IR) and the voiding fraction by Digital Image Correlation (DIC). The volumetric strain measured during the rubber ...

ELSEVIER SCI LTD2020

Scale limitations of gas bearing supported turbocompressors for vapor compression cycles

Jürg Alexander Schiffmann

An analysis of single-stage centrifugal compressors supported on dynamic, gas lubricated bearings for driving vapor compression cycles suggests that the maximum feasible compressor power is limited, primarily by the bearing load capacity, in the range from ...

2020

The Role of Reynolds Number Effect and Tip Leakage in Compressor Geometry Scaling at Low Turbulent Reynolds Numbers

Jürg Alexander Schiffmann, Markus Diehl, Christoph Schreiber

In compressor design, a convenient way to save time is to scale an existing geometry to required specifications, rather than developing a new design. The approach works well when scaling compressors of similar size at high Reynolds numbers but becomes more ...

2020

Heat exchanger module and methods of using thereof

Lyesse Laloui, Alessandro Francesco Rotta Loria

The invention provides in one embodiment a heat exchanger module (1) comprising a) a flexible support (100); b) at least one tubular member (200) having its main axis substantially parallel with the plane of the flexible support (100); c) a conductive flex ...

2020

Impact of large tip clearance ratios on the performance of a centrifugal compressor

Jürg Alexander Schiffmann, Markus Diehl

Ultra-compact and fast spinning turbomachinery is a key technology to increase performance of domestic heating applications and to address decentralization of power and heat as a consequence of the rise of renewable energy sources. Recently, a heat pump us ...

2019

Graph Chatbot

Chat with Graph Search

Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.

DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.