Application of particle-based numerical analysis to the practical design of Pelton turbine
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
This thesis presents a methodology for the design optimization of hydraulic runner blades. The originality of the methodology comes from the geometric definition of the blade shapes, which uses parametric surfaces instead of a set of profiles. The main adv ...
The parallel rotor-stator computation capabilities of Fine Turbo and CFX-TASCflow CFD commercial codes have been investigated within the frame of the European ESPRIT project HPNURSA. Unsteady computations have been performed for simple test cases, where fl ...
International Association For Hydraulic Research2002
An experimental and theoretical investigation of the flow at the outlet of a Francis turbine runner is carried out in order to elucidate the causes of a sudden drop in the draft tube pressure recovery coefficient at a discharge near the best efficiency ope ...
An experimental investigation has been carried out in order to evaluate the detection of cavitation in actual hydraulic turbines. The methodology is based on the analysis of structural vibrations, acoustic emissions and hydrodynamic pressures measured in t ...
GE Energy Hydro has developed a new procedure for the CFD analysis of the unsteady rotor-stator interaction between the wicket gates and runner blades of Francis turbines. The results from the CFD calculations have been successfully validated by means of h ...
A one-dimensional hydroacoustic model is set up to perform the numerical simulation of the rotor-stator interaction of a Francis pump-turbine scaled model. The numerical results enable to identify both rotating diametrical modes in the vaneless gap between ...
This paper deals with 5-axis milling of hydraulic blades. The issue developed is essentially linked to problems due to the transition from 3 to 5 axes. A specific attention is done to the Inverse Kinematics Transformation (IKT) which can be source of incoh ...
Flow visualizations using endoscopes in a 21-bucket single-injector reduced scale Pelton turbine are performed for 2 operating points. 2 types of visualizations are performed with a CMOS high-speed camera: (i) an onboard visualization of the flow in the bu ...
International Association For Hydraulic Research2006
Numerical and Experimental Analysis of Free Surface Flow in a 3D Non-Rotating Pelton Bucket Low frequency fluctuations often occur in hydraulic installations equipped with fixed bladed turbines or pumps operating under off design conditions. Passive measur ...
Regions of positive slope in the pressure-discharge characteristics are one of the major concerns in design and operation of centrifugal pumps, as they are limiting the admissible operating range to values above the critical discharge. The industrial pump ...