Multiscale enhancement of refrigerant falling film boiling by combining commercially enhanced tubes with nanostructures
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
This article presents experimental results of heat transfer from two different studies [1, 2] for horizontal flow boiling inside smooth copper tubes with different refrigerants. The main goal of this study was to verify the influence of the saturation temp ...
Experiments of diabatic two-phase pressure drops in flow boiling were conducted in four horizontal flattened smooth copper tubes with two different heights of 2 and 3 mm. The equivalent diameters of the flat tubes are 8.6, 7.17. 6.25, and 5.3 mm. The worki ...
The current industrial need for compact high heat density cooling devices has conveyed an increasing interest on convective boiling in micro-channels. Although there is general agreement that these systems may be able to dissipate potentially very high hea ...
In tune with the falling film evaporation heat transfer test results described in Part 1, flow visualization of the boiling process and intertube flow mode transitions from droplet to column and sheet flows have been observed, and the onset of dryout resul ...
This thesis presents a system approach with the aim to develop improved concepts for small capacity, high temperature lift air-water heat pumps. These are intended to replace fuel fired heating systems in the residential sector, which leads to a major redu ...
Maglev (>400 km/h) refer to Maglev such as the Japanese JR-Maglev MLX, the German Transrapid and the USA Inductrack. The Swissmetro Project, presenting a unique aspect of Maglev, is designed to work under partial vacuum (
This study is a contribution for the improvement of horizontal falling film heat exchangers. This type of evaporator has the potential to be widely used in the petrochemical industry, for the sea water desalination, or in the large refrigeration systems. A ...
The tubes in shell-and-tube condensers, widely used in refrigeration and chemical process industries, are subjected to condensate inundation from the neighboring tubes. The aim of the present investigation is to study the effect of condensate inundation on ...
An electrically heated foil glued on top of an acrylic wall is employed to measure convective heat transfer on turbine vane platforms. The use of a heater foil requires specific filtering techniques to obtain the searched quantities – heat transfer coeffic ...
Experimental studies were performed to investigate the flow patterns of liquid films of R-134a on vertical arrays of horizontal tubes under adiabatic test conditions at room temperature and during condensation at a saturation temperature of 304 K. Three ar ...
