Falling film evaporation on a single tube and on a tube bundle
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
Micro or mini heat spreaders are used in the interest of providing higher cooling capability for microtechnologies. Heat spreaders using micro or mini channels are not yet well studied, for this the fundamentals of two-phase heat transfer in microchannels ...
This paper presents a state-of-the-art review of two-phase flow and flow boiling across horizontal tube bundles. The review covers studies related to the dynamic aspects of two-phase flow on the shell side of staggered and in-line tube bundles for upward, ...
A new falling film heat transfer test facility has been built for the measurement of local heat transfer coefficients on a vertical array of horizontal tubes, including flow visualization capabilities, for use with refrigerants. Presently, the facility has ...
Remarkably different behaviors are found when comparing micro-scale flow boiling heat transfer data by distinct authors, even under similar experimental conditions. Such differences are almost certainly related to the complexity of confined forced-flow boi ...
The tubes in shell-and-tube condensers, widely used in refrigeration and chemical process industries, are subjected to condensate inundation from the neighboring tubes. The aim of the present investigation is to study the effect of condensate inundation on ...
In tune with the falling film evaporation heat transfer test results described in Part 1, flow visualization of the boiling process and intertube flow mode transitions from droplet to column and sheet flows have been observed, and the onset of dryout resul ...
Experimental studies were performed to investigate the flow patterns of liquid films of R-134a on vertical arrays of horizontal tubes under adiabatic test conditions at room temperature and during condensation at a saturation temperature of 304 K. Three ar ...
The substitution of CFC refrigerants in refrigeration systems, heat pumps and organic Rankine cycles, requests a good knowledge of the heat transfer and pressure drop properties of substitute fluids. A contribution to this international effort is proposed ...
This thesis presents a system approach with the aim to develop improved concepts for small capacity, high temperature lift air-water heat pumps. These are intended to replace fuel fired heating systems in the residential sector, which leads to a major redu ...
An improved two-phase flow pattern map is proposed for evaporation in horizontal tubes. Based on new flow pattern data for three different refrigerants covering a wide range of mass velocities, vapor qualities and heat fluxes. The new flow pattern map incl ...
