Void reactivity coefficient benchmark results for a 10x10 BWR assembly in the full 0-100% void fraction range

Related publications (31)

Page 3 of 4

About
Privacy
Disclaimer

Graph Chatbot

Delayed Hydride Cracking in Irradiated and Unirradiated Zircaloy-2 Cladding

Aaron William Colldeweih

Zirconium alloys used in the nuclear industry are exposed to extreme conditions undergoing high levels of irradiation damage and corrosion. Zircaloy-2 is used as nuclear fuel cladding in boiling water reactors and for the encapsulation of the spallation ta ...

EPFL2022

Thermodynamic modelling of hydrogen production in sorbent-enhanced biochar-direct chemical looping process

Hydrogen (H-2) has been widely considered the clean energy carrier of choice for emerging renewable energy generation technologies. However, H-2 is a secondary fuel mainly derived from natural gas. Over the past decades, research on developing H-2 producti ...

2022

Enhanced Solar-to-Fuel Efficiency of Ceria-Based Thermochemical Cycles via Integrated Electrochemical Oxygen Pumping

Sophia Haussener, Clemens Gregor Suter, Meng Lin

The solar thermochemical cycle based on ceria is a promising route for renewable fuel production. The solar-to-fuel efficiency of a thermochemical reactor is highly dependent on the oxygen removal during the reduction step. Conventional nitrogen sweeping ( ...

AMER CHEMICAL SOC2022

Investigation and Validation of Unstructured Mesh Methodologies for Modeling Experimental Reactors

Andreas Pautz, Mathieu Hursin, Carlo Fiorina, Tom Mager

This paper summarizes a methodology developed at Ecole Polytechnique Federale de Lausanne for the neutronic modeling of the CROCUS experimental reactor and proposes solutions to the challenges one may face while modeling a research reactor with a complex g ...

MDPI2022

On the Capability of Wall-Modeled Large Eddy Simulations to Predict Particle Dispersion in Complex Turbulent Flows

Mohamed Aly Hashem Mohamed Sayed

Predicting particle transport in turbulent flows has a plethora of applications, some of which are: the transport of atmospheric aerosols, the deposition of blood cells in the arteries of human bodies and the atomization of fuel droplets in combustion cham ...

EPFL2022

Construction of Fe3O4 bridged Pt/g-C3N4 heterostructure with enhanced solar to fuel conversion

Michael Graetzel, Shaik Mohammed Zakeeruddin

In this study, we report the effects of co-catalysts of Pt nanoparticles and Fe3O4 clusters on photocatalytic behaviors of g-C3N4 (CN) and the use of the resulting photocatalyst for CO2 photoreduction to solar fuels in a flow reactor operated at room-tempe ...

ELSEVIER2022

Symmetry in design and decoding of polar-like codes

Kirill Ivanov

The beginning of 21st century provided us with many answers about how to reach the channel capacity. Polarization and spatial coupling are two techniques for achieving the capacity of binary memoryless symmetric channels under low-complexity decoding algor ...

EPFL2022

Revisiting the Impact of Morphology and Oxidation State of Cu on CO2 Reduction Using Electrochemical Flow Cell

Michael Graetzel, Shaik Mohammed Zakeeruddin, Jing Gao, Dan Ren

Electroreduction of carbon dioxide (CO2) in a flow electrolyzer represents a promising carbon-neutral technology with efficient production of valuable chemicals. In this work, the catalytic performance of polycrystalline copper (Cu), Cu2O-derived copper (O ...

AMER CHEMICAL SOC2022

A Hybrid Approach to Neutron Transport with Thermal-hydraulic Feedback for Reactor Transient Analysis

Alexander Aures

Understanding the time-dependent behaviour of a nuclear reactor following an intended or unintended change of the reactor conditions is of crucial importance to the safe operation of nuclear reactors. Safety evaluations of nuclear reactors involve the anal ...

EPFL2021

Delayed gamma fraction determination in the zero power reactor CROCUS

Andreas Pautz, Vincent Pierre Lamirand, Oskari Ville Pakari, Pavel Frajtag, Tom Mager

Gamma rays are an inextricable part of a nuclear reactor's radiation field, and as such require characterization for dose rate estimations required for the radiation protection of personnel, material choices, and the design of nuclear facilities. Most comm ...

EDP SCIENCES S A2021

Page 3 of 4