Publications associées à Porcelaine

Clay calcination technology: state-of-the-art review by the RILEM TC 282-CCL

Karen Scrivener, Franco Alberto Zunino Sommariva, François Henri Avet, Alastair Thomas Matthew Marsh, Mohsen Ben Haha, Shashank Bishnoi, Adrian Alujas Diaz, Anuj Parashar

The use of calcined clays as supplementary cementitious materials provides the opportunity to significantly reduce the cement industry's carbon burden; however, use at a global scale requires a deep understanding of the extraction and processing of the cla ...

SPRINGER2022

Oxidation of pyrite (FeS2) and troilite (FeS) impurities in kaolinitic clays after calcination

Karen Scrivener, Franco Alberto Zunino Sommariva

Valorisation of locally available clays for producing blended cements is crucial for a widespread adoption of sustainable binders incorporating these materials. In some places, clays can be intermixed with small amounts of iron sulfides, which could eventu ...

SPRINGER2022

The effect of pore microstructure on strength and chloride ingress in blended cement based on low kaolin clay

Karen Scrivener, Diana Londoño Zuluaga

The objective of this study is to analyse the mechanical and durability properties of a high-performance mortars based on low grade kaolin clay and the effect of electrical conductivity and pore microstructure on the chloride penetration resistance. A tota ...

ELSEVIER2022

Paper of RILEM TC 282-CCL: mineralogical characterization methods for clay resources intended for use as supplementary cementitious material

Franco Alberto Zunino Sommariva, Ruben Anton Snellings, Alastair Thomas Matthew Marsh, Adrian Alujas Diaz

To respond to the rapid introduction and development of calcined clays as supplementary cementitious material (SCM), the toolbox of characterization methods for cementitious materials requires extension to raw clay characterization. Borrowing concepts and ...

SPRINGER2022

The Influence of some calcined clays from Nigeria as clinker substitute in cementitious systems

Karen Scrivener, François Henri Avet, Akindehinde Ayotunde Akindahunsi

This paper examines the possibility of the use of some clays calcined from Nigeria as partial substitutes for clinker in the production of Limestone Calcined Clay Cement (LC3). The clays were calcined in the oven at a temperature of 800 degrees C and for o ...

2020

Basic creep and autogenous shrinkage of Limestone Calcined Clay Cement (LC3)

Julien Ston

The use of supplementary cementitious materials (SCM) to lower the clinker factor of cements is now commonplace, for it benefits performance, economics and ecology. This thesis focuses on ternary blends of limestone and calcined kaolinitic clays, two very ...

EPFL2019

Hydration Study of Limestone Calcined Clay Cement (LC3) Using Various Grades of Calcined Kaolinitic Clays

Karen Scrivener, François Henri Avet

In this study, the influence of the calcined kaolinite content of calcined clay on the hydration of Limestone Calcined Clay Cement (LC3-50) is investigated. It is shown that with the increase of the calcined kaolinite content of the calcined clay, the clin ...

SPRINGER2018

Assessing the Effect of Calcite Impurities in Clay on Optimal Dehydroxylation Parameters for Enhanced Reactivity

Karen Scrivener, Franco Alberto Zunino Sommariva

This study focused on understanding the influence of different amounts of calcite impurities (0 to 10% by mass) on the optimal parameters for clay dehydroxylation and the reactivity of the final calcined clay. A surface response experimental design was use ...

SPRINGER2018

Autogenous Shrinkage and Creep of Limestone and Calcined Clay Based Binders

Karen Scrivener, Julien Ston, Adrien Jean Régis Maurice Hilaire

This study explored the delayed strains in limestone and calcined clay ternary blends. Autogenous shrinkage measurements are carried out over 2 months and compressive basic creep tests during 28 days after one month of curing. All tests are done using mixe ...

SPRINGER2018

Investigation of the grade of calcined clays used as clinker substitute in Limestone Calcined Clay Cement (LC3)

François Henri Avet

The combination of calcined kaolinitic clays and limestone in Limestone Calcined Clay Cement (LC3) is a promising approach to reduce the cost and the CO2 emissions of cement production by reducing the clinker content of cement. This thesis investigates the ...

EPFL2017