Publications associées à Crazing

Supramolecular Modifications of Semicrystalline Polymers

Supramolecular interactions play an important role in defining the structure and the resulting mechanical properties of materials. For instance, interchain hydrogen-bonding in PAs gives them superior strength and stiffness in engineering materials, while t ...

EPFL2023

Inferring the flow properties of epithelial tissues from their geometry

Matthieu Wyart, Marko Popovic, Valentin Camille Druelle

Amorphous materials exhibit complex material properties with strongly nonlinear behaviors. Below a yield stress they behave as plastic solids, while they start to yield above a critical stress sigma(c). A key quantity controlling plasticity which is, howev ...

2021

Unconventional Tough Double-Network Hydrogels with Rapid Mechanical Recovery, Self-Healing, and Self-Gluing Properties

Paul Joseph Dyson, Zhaofu Fei, Zhangjun Huang, Xunhui Wang, Haiyan Jia

Hydrogels are polymeric materials that have a relatively high capacity for holding water. Recently, a double network (DN) technique was developed to fabricate hydrogels with a toughness comparable to rubber. The mechanical properties of DN hydrogels may be ...

Amer Chemical Soc2016

Polymer-theory insights into biomolecular systems

Salvatore Assenza

Boosted by the technological advances in experimental techniques, cellular biology is nowadays facing the need for quantitative approaches in order to rationalize the huge amount of collected data. A particularly succesfull theoretical framework is provide ...

EPFL2015

Influences of polymer concrete surfacing and localised load distribution on behaviour up to failure of an orthotropic FRP bridge deck

Thomas Keller, Wendel Michael Sebastian

This paper presents experimental results which demonstrate the important, but to date little-studied influence of surfacing on the response up to failure of orthotropic GFRP bridge decking local to concentrated loading. Four bonded deck specimens were test ...

Elsevier2013

Low-Stress UV-Curable Hyperbranched Polymer Nanocomposites for High-Precision Devices

Valérie Geiser

The aim of this thesis was to investigate the process-structure-property relationships of UV-curable hyperbranched polymer (HBP)/silica nanocomposites. Special attention was paid to the interplay between photo-conversion, rheological behavior, shrinkage, a ...

EPFL2010

Highly filled polymer nanocomposite films derived from novel nanostructured latexes

Riccardo Ruggerone

The overall aim of this thesis has been to assess the potential of latex-based technologies for the preparation of polymer/clay nanocomposites. The key feature of latex-based technologies is that they offer the possibility of improved control of the final ...

EPFL2010

Fracture mechanisms in polystyrene/laponite nanocomposites prepared by emulsion polymerization

John Christopher Plummer, Riccardo Ruggerone

Transmission electron microscopy (TEM) has been used to investigate the effect of laponite clay on microdeformation in thin latex-based polystyrene (PS) films, in which the laponite was concentrated at the original interfaces between the PS particles. At r ...

2009

Analysis and study of novel terpolymers composed of acrylamide, mono-charged and double-charged cationic monomers

Jutta Christine Wandrey, Peter Käuper, Ricardo Losada Mateo

The composition of novel terpolymers containing acrylamide (A), acryloyloxyethyltrimethylammonium chloride (Q), and bis-1,3(N,N,N-trimethylammonium)-2-propylmethacrylate dichloride (M) was analyzed combining FTIR and potentiometric titration. Calibration w ...

2009

Microdeformation mechanisms in rubber toughened PMMA and PMMA-based copolymers

John Christopher Plummer, Laure Dupuits Lalande

The classical method of toughening polymethylmethacrylate (PMMA) is to incorporate composite rubber particles into the homopolymer matrix. This approach has been extended in the present work by (i) combining rubber toughening with chemical modification of ...

2006