Flux de brasage

Applied sciences
Génie chimique
Science des matériaux
Alliage

Publications associées (25)

À propos
Confidentialité
Mentions légales

Graph Chatbot

Optimisation of industrial production of low-force sensors – adhesive bonding of force-centring ball

Peter Ryser, Thomas Maeder, Caroline Jacq, Maxime Blot

This work addresses the issue of attaching the force-centring part (a round ball) to the load cell of a force sensor, a piezoresistive thick-film Wheatstone bridge deposited onto a ceramic cantilever. As the current soldering process requires expensive met ...

IOP2015

Alkali Activation of AOD Stainless Steel Slag Under Steam Curing Conditions

Muhammad Salman, Ruben Anton Snellings

Crystalline argon oxygen decarburization slag, in powdery form, was investigated for its hydration potential by alkali activation and curing at 80 degrees C. Na-silicate and K-silicate of the same modulus were used as activators. Isothermal calorimetry at ...

Wiley-Blackwell2015

Isothermal Ageing of SnAgCu Solder Alloys: Three-Dimensional Morphometry Analysis of Microstructural Evolution and Its Effects on Mechanical Response

John Botsis, Joël Cugnoni, Milad Maleki

Due to the high homologous temperature and fast cooling rates, the microstructures of SnAgCu (SAC) solders are in a meta-stable state in most applications, which is the cause of significant microstructural evolution and continuous variation in the mechanic ...

Springer2014

Intermittent dewetting and dryout of annular flows

John Richard Thome, Navid Borhani

Flow visualisation of saturated flow boiling of refrigerant R245fa in a silicon parallel multi-microchannel evaporator, at low mass flux and moderate uniform heat flux, has been carried out with a high-speed digital camera. Using the time-strip technique t ...

Pergamon-Elsevier Science Ltd2014

The Effect of Mg on Slag Reactivity in Blended Cements

Karen Scrivener, Ruben Anton Snellings

Blast-furnace slags are widely used as supplementary cementitious materials in blended cements because of their relatively high reactivity. This study describes the effect of substituting Ca by Mg on the reactivity of synthetic glass with similar compositi ...

Springer2014

Page 3 sur 3

Optimisation of industrial production of low-force sensors – adhesive bonding of force-centring ball

Peter Ryser, Thomas Maeder, Caroline Jacq, Maxime Blot

IOP2015

Alkali Activation of AOD Stainless Steel Slag Under Steam Curing Conditions

Muhammad Salman, Ruben Anton Snellings

Wiley-Blackwell2015

Isothermal Ageing of SnAgCu Solder Alloys: Three-Dimensional Morphometry Analysis of Microstructural Evolution and Its Effects on Mechanical Response

John Botsis, Joël Cugnoni, Milad Maleki

Springer2014

Intermittent dewetting and dryout of annular flows

John Richard Thome, Navid Borhani

Pergamon-Elsevier Science Ltd2014

The Effect of Mg on Slag Reactivity in Blended Cements

Karen Scrivener, Ruben Anton Snellings

Springer2014