Publications associées à Cubic zirconia

Orientation-dependent two-dimensional magnonic crystal modes in an ultralow-damping ferrimagnetic waveguide containing repositioned hexagonal lattices of Cu disks

Two-dimensional (2D) hexagonal lattices of Cu disks are shown to induce orientation-dependent magnonic crystal (MC) modes for propagating forward volume spin waves in a single-crystal yttrium iron garnet (YIG) film. The width and depth of the magnonic band ...

American Physical Society (APS)2024

Charge multipole correlations and order in Cs2TaCl6

Henrik Moodysson Rønnow, Ivica Zivkovic, Jian Rui Soh, Jana Pásztorová

We examine the role of charge, structural, and spin degrees of freedom in the previously poorly understood phase transition in the 5d1 transition-metal double perovskite Cs2TaCl6 using a combination of computational and experimental techniques. Our heat ca ...

AMER PHYSICAL SOC2023

Site-selective overgrowth of Ag nanocrystals by Polyvinylpyrrolidone-mediated atom deposition by Ostwald ripening

Francesco Stellacci, Paulo Henrique Jacob Silva, Alejandro Lapresta Fernandez

The growth modulation of metal nanocrystals (NCs) by Ostwald ripening (OR) involves control of the relocation of matter by diffusional mass transfer from the dissolution of small nanocrystals (SNCs) towards large nanocrystals whose surface energy is lower. ...

ELSEVIER2022

On the structure of (111) twist grain boundaries in diamond: atomistic simulations with Tersoff-type interatomic potentials

Carolina Baruffi

In nanocrystalline diamond thin films, the high grain boundary density and the associated grain boundary properties may dominate the overall material behavior. In the present work, we systematically investigate (111) twist grain boundaries in diamond carbo ...

PERGAMON-ELSEVIER SCIENCE LTD2021

Biological responses at the interface of Ti-doped diamond-like carbon surfaces for indoor environment application

Sami Rtimi

Diamond-like carbon (DLC) and titanium-doped DLC coatings were prepared by hybrid PECVD/direct current magnetron sputtering (DCMS). In this study, we show that the operating conditions of titanium-doped DLC coatings used for implants in surgical devices si ...

SPRINGER HEIDELBERG2020

Evidence of extensive lunar crust formation in impact melt sheets 4,330 Myr ago

Cyril Cayron

Accurately constraining the formation and evolution of the lunar magnesian suite is key to understanding the earliest periods of magmatic crustal building that followed accretion and primordial differentiation of the Moon. However, the origin and evolution ...

2020

Single crystal diamond gain mirrors for high performance vertical external cavity surface emitting lasers

Niels Quack, Grigore Suruceanu, Gergely Huszka, Alexandru Mereuta, Andrei Caliman, Pascal Gallo, Mehdi Naamoun

We report on the design, fabrication and optical performance of gain mirrors in single crystal diamond substrates for vertical external cavity surface emitting lasers (VECSELs). VECSELs have gained attention recently due to their potential for high emissio ...

2020

Evolution of the Morphology Near Triple-Phase Boundaries in Ni–Yttria Stabilized Zirconia Electrodes Upon Cathodic Polarization

Jan Van Herle, Marco Cantoni, Guillaume Jeanmonod, Lucie Navratilova, Arata Nakajo, Priscilla Caliandro, Giorgio Rinaldi

Microstructural changes in Ni–yttria stabilized zirconia (YSZ) near the YSZ electrolyte were examined by three-dimensional (3D) electron microscopy after electrolysis and fuel cell operation up to 10,700 h and 15,000 h, respectively. The depletion of Ni an ...

2020

Structural and microstructural studies on SiC-SiO2 ceramic composites

Ho-Yun Lee

In this study, SiC ceramic substrates were prepared with 99.5% silicon carbide powders which were came from waste silicon mud during the manufacturing process of solar cells. It is found that a SiO2 layer with 50 nm in thickness is present on the SiC surfa ...

2019

Single crystalline diamond part production method for stand alone single crystalline mechanical and optical component production

Niels Quack, Pascal Gallo, Teodoro Graziosi, Marcell Kristof Kiss

The present invention relates to a free-standing single crystalline diamond part and a single crystalline diamond part production method. The method includes the steps of: - providing a single crystalline diamond substrate or layer; - providing a first adh ...

2019