Solid electrochemical mass spectrometry (SEMS) for investigation of supported metal catalysts under high vacuum

A new experimental set-up, coupling electrochemistry and mass spectroscopic techniques, for the investigation of a solid electrochemical cell under high vacuum conditions (HV) is presented. Two configurations are realized allowing the investigation of both the electrochemical and electrocatalytical behavior of a thin Pt layer on yttria stabilized zirconia (YSZ). We can readily select the atmosphere down to 10(-6) Pa partial pressure and determine the response of the system in less than 1 s. Under HV conditions, YSZ appears electrochemically active and we have identified, in the cathodic potential domain, the reduction/oxidation process of zirconia and in the anodic domain, the platinum oxidation/reduction and the oxygen evolution reactions. In a catalytic active gas mixture, despite the Faradaic enhancement of the CO oxidation observed over Pt/YSZ during an anodic polarization, an intriguing sustainable enhanced Pt/YSZ catalyst activity is achieved after current interruption.

Investigation of the Pt/YSZ interface at low oxygen partial pressure by solid electrochemical mass spectroscopy under high vacuum conditions

Christos Comninellis, Cyril Falgairette, György Foti, Wolfgang Harbich, Chun Xia

The Pt/YSZ interface was investigated at low oxygen partial pressure under high vacuum (HV) conditions at 400 A degrees C. Two different electrochemical techniques were coupled to mass spectrometric gas analysis using a new solid electrochemical mass spectrometric monitoring device. Under cathodic polarization, the lack of oxygen in the gas phase induces the reduction of the YSZ solid electrolyte which acts as oxygen source for the formation of O2- ions migrating to the anode. Under anodic polarization, both platinum oxidation and oxygen evolution reaction are identified. PtO (x) is formed at both the Pt/YSZ and the Pt/gas interface according to two different mechanisms. At the Pt/YSZ interface, PtO (x) formation is an electrochemical process following a parabolic growth law, while the presence of PtO (x) at the Pt/gas interface is related to the diffusion of PtO (x) formed at the triple phase boundary towards the Pt/gas interface. It is proposed that the side oxygen evolution reaction stabilizes thermodynamically the PtO (x) diffusion toward the gas exposed interface during the anodic polarization.

Springer Netherlands2010

Chemical and electrochemical promotion of supported rhodium catalyst

Olena Baranova

The chemical and electrochemical promotion of highly dispersed nanofilm Rh catalysts (dispersion: about 10 %, film thickness: 40 nm) has been investigated for the first time. To this end Rh metal was sputter-deposited, either on a purely ionic conductor (8 % Y2O3-stabilized ZrO2) or on a mixed ionic-electronic conductor (TiO2), the latter being a highly dispersed layer of TiO2 (4 µm) deposited on YSZ. These catalysts are designated as Rh/YSZ and Rh/TiO2/YSZ, respectively. It was established analytically that both in the Rh/YSZ and in the Rh/TiO2/YSZ system, the catalyst films have a nanoparticle-size grain structure. The Rh supported on titania is rather porous, exhibiting a higher dispersion and surface area than Rh on YSZ. Both after reduction (H2, T=400 °C) and after oxidation (O2, T=400 °C), Rh supported on TiO2 was found to be in a more highly reduced state than Rh on YSZ. After reducing treatment, the Rh/TiO2/YSZ samples contain a larger amount of weakly bonded oxygen, which can be attributed to oxygen "backspillover" from the TiO2. A major feature of this research was the electrochemical characterization of the oxygen/Rh/solid electrolyte three-phase boundary by steady-state polarization measurements and by impedance spectroscopy. These are powerful techniques for extracting experimental trends and details that are useful for an understanding of the electrochemical promotion principles. It was shown that the exchange current densities at the Rh/solid electrolyte interface are lower on account of the TiO2 layer. The exchange current densities are more than twice lower at Rh/TiO2(4 µm)/YSZ than at Rh/YSZ, demonstrating that the former interface is much more polarizable. The mechanism of oxygen exchange occurring close to equilibrium (O2/O2- couple) was investigated for the first time at Rh catalyst electrodes interfaced with solid electrolyte. The processes of cathodic oxygen reduction and anodic oxygen evolution are not symmetric, but they are similar in the two systems, Rh/YSZ and Rh/TiO2(4 µm)/YSZ. The cathodic process consists of three steps: dissociative adsorption of oxygen at the gas-exposed Rh surface, atomic oxygen diffusion to the electrochemical reaction sites (ERS), and a two-electron transfer to this oxygen on the ERS. The cathodic process is limited by interfacial diffusion of oxygen atoms from the gas-exposed metal surface to the ERS. The anodic process includes two steps: two-electron transfer reaction, which is the rate-determining step, and oxygen desorption to the gas phase. With data obtained from impedance spectroscopy at the equilibrium potential, it was possible to confirm the reaction scheme proposed. It was demonstrated that Rh nanofilm catalysts interfaced with YSZ or TiO2/YSZ can be electrochemically promoted for the reaction of ethylene oxidation. Small anodic currents cause periodic oscillations in catalytic rate and potential of the Rh/YSZ catalyst, while at Rh/TiO2/YSZ they give rise to a stable and reversible rate enhancement by up to a factor 80. The increase in ethylene oxidation rate is up to 2000 times larger than the electrochemical rate, I/2F, of O2- oxidation. The pronounced electrochemical promotion behavior that has been observed is due to the anodically controlled migration of O2- species from the electrolyte to the Rh/gas interface. At the Rh surface, these species destabilize the formation of rhodium surface oxide (Rh2O3). The existence of backspillover oxygen species has been confirmed by impedance measurements under positive applied potential. Another significant result for heterogeneous catalysis is the finding that thick as well as thin films of Rh/TiO2/YSZ catalyst are open to chemical promotion of ethylene oxidation and partial methane oxidation, ie, they offer a higher catalytic activity and stability than the Rh/YSZ catalysts. The modification of catalytic activity observed for Rh/TiO2/YSZ was attributed to either a "long-range" electronic-type SMSI mechanism or to a self-driven electrochemical promotion mechanism. In both cases, the ultimate cause of promotion are different work functions of catalyst and support. Equilibration of the work functions of two solids in contact induces surface charging, a migration of O2- ions to the catalyst/gas interface, and a weakening of the Rh-O chemisorptive bonds. It facilitates reduction of oxidized surface sites. Another important achievement of the present work was that of exploring and confirming the possibilities of current-assisted activation of Rh/TiO2/YSZ catalysts. In partial methane oxidation using close to stoichiometric gas compositions (CH4 : O2 = 2 : 1) at 550 °C, the inactive (oxidized) Rh/TiO2/YSZ catalyst was successfully activated by applied currents, either positive or negative. This phenomenon is an example of "permanent" electrochemical promotion furnishing a permanent rate enhancement ratio of γ = 11. The activation by negative currents is explained in terms of an electrochemical reduction of rhodium surface oxide, while the activation by positive currents can be explained by the mechanism of electrochemical promotion.

EPFL2005

Two-Dimensional Metal-Organic Networks as a New Class of Electrocatalysts

Benjamin Wurster

This thesis deals with the electrocatalytic properties of two-dimensional metal organic coordination networks (2D-MOCNs) self-assembled on electrode surfaces and catalytic activity of 2D-MOCNs is demonstrated for the first time. The low-coordinated metal centers within these supramolecular structures resemble the catalytically active sites of metallo-enzymes. The activity of the metal centers is determined by the type of the metal and the coordination environment; both parameters can be carefully adjusted in 2D-MOCNs. In order to study and correlate electrocatalytic properties with the atomic structure of 2D-MOCNs, a scanning tunnelling microscope operating in ultra-high vacuum (UHV) was combined with an electrochemical (EC) setup. Sample preparation and scanning tunneling microscopy (STM) were conducted under UHV conditions. By STM the composition and structure of the networks were controlled and characterized prior to EC experiments. A transfer system between UHV and EC instrumentation was constructed to keep the sample at all times in a clean and controlled environment. It is demonstrated that the mechanism of the oxygen reduction reaction (ORR) can be influenced by the type of the metal center in the network. The networks formed by benzene-tricarboxylic acid (TMA) with either Fe or Mn atoms are structurally identical, but their electrochemical signal differs significantly. Both networks catalyze the reduction of O2 to H2O, but on different pathways. These results emphasize the key role of the unsaturated metal centers in the electrocatalytic reduction. The electrocatalytic response in the ORR can also altered by the distinct coordination environment; this is shown for Fe atoms nitrogen-coordinated by either tetracyanoquinodimethane (TCNQ), bis-pyridyl-bipyrimidine (PBP) or phythalocyanine (Pc). Depending on the specific coordination environment formed by the different ligands the the final product (H2O2 or H2O) and the mechanism of the ORR is changed. In the last part of this thesis the two metal binding sites of 5,10,15,20-tetra(4-pyridyl)porphyrin (TPyP) are used to selectively incorporate different metal centers in a fixed organic environment and create homo- and hetero-bimetallic networks. The coupling of the two metals centers promoted by the organic environment modifies the electrocatalytic response. The correct combination of two metal centers in the right positioning makes an efficient catalyst. In the ORR the peak and onset potential is varied depending on the metal combination. In the case of the oxygen evolution reaction a non-linearly increased catalytic activity by the cooperative bimetallic effect is obtained. The results presented in this thesis demonstrate the high potential of 2D-MOCNs for heterogeneous catalytic chemical conversions. Engineering of the network structure and the distinct coordination environment of the metal centers offers the possibility to tune their catalytic activity. This opens up a new route for the design of a new class of nanocatalyst materials.