Effect of inhomogeneities on backward and forward Brillouin scattering in Photonic Crystal Fibers

Photonic Crystal Fibers (PCF) play a crucial role for fundamental investigations such as acousto-optical interactions as well as for applications, such as distributed sensors. One limiting factor for these experiments is the fiber inhomogeneity owing to the drawing process. In this paper we study the effect of structural irregularities on both the backward and forward Brillouin scattering by comparing two PCFs drawn with different parameters, in order to minimize diameter fluctuations. We fully characterize their Brillouin properties including the backward Brillouin spectrum, the Brillouin threshold, a distributed measurement along the fibers and polarized Guided Acoustic Wave Brillouin Scattering (GAWBS). In the Brillouin spectrum we observe a single peak as in a single-mode fiber whereas former investigations have often shown a multiple peak spectrum in PCFs with small core. The theoretical and experimental values for the Brillouin threshold are in good agreement, which results from the single peak spectrum. By using a Brillouin echoes distributed sensing system (BEDS), we also investigate the Brillouin spectrum along the fiber with a high spatial resolution of 30 cm. Our results reveal a clear-cut difference between the distributed measurements in the two fibers and confirm the previous experiments. In the same way the GAWBS allows us to estimate the uniformity of the fibers. The spectra show a main peak at about 750 MHz, in accordance with theoretical simulations of the acoustic mode and of the elasto-optical coefficient. The fiber inhomogeneity impacts on the stability and the quality factor of the measured GAWBS spectra. We finally show that the peak frequency of the trapped acoustic mode is more related to the optical effective area rather than the core diameter of the PCF. Thus measuring the main GAWBS peak can be applied for the precise measurement of the effective area of PCFs. © 2010 SPIE.

Large evanescently-induced Brillouin scattering at the surrounding of a nanofibre

Flavien Gyger, Luc Thévenaz, Fan Yang, Li Zhang

Brillouin scattering has been widely exploited for advanced photonics functionalities such as microwave photonics, signal processing, sensing, lasing, and more recently in micro- and nano-photonic waveguides. Most of the works have focused on the opto-acoustic interaction driven from the core region of micro- and nano-waveguides. Here we observe, for the first time, an efficient Brillouin scattering generated by an evanescent field nearby a single-pass sub-wavelength waveguide embedded in a pressurised gas cell, with a maximum gain coefficient of 18.90 ± 0.17 m−1W−1. This gain is 11 times larger than the highest Brillouin gain obtained in a hollow-core fibre and 79 times larger than in a standard single-mode fibre. The realisation of strong free-space Brillouin scattering from a waveguide benefits from the flexibility of confined light while providing a direct access to the opto-acoustic interaction, as required in free-space optoacoustics such as Brillouin spectroscopy and microscopy. Therefore, our work creates an important bridge between Brillouin scattering in waveguides, Brillouin spectroscopy and microscopy, and opens new avenues in light-sound interactions, optomechanics, sensing, lasing and imaging.

2022

Brillouin Echoes for Advanced Distributed Sensing in Optical Fibres

Stella Foaleng Mafang

Brillouin scattering is particularly efficient and attractive for the implementation of strain and temperature distributed sensing in optical fibres. Recently a trend has been observed that modern advanced applications require a substantial step towards better spatial resolution, while preserving temperature/strain precision over a long range. For this purpose the state of the art does not satisfy all these requirements. In this thesis we present a radically new approach named Brillouin Echoes distributed sensing (BEDS) that allows covering these requirements. In the first part, we propose an updated configuration of the classical existing Brillouin sensor for time domain analysis allowing drastic noise reduction. Then we investigate the limitations (due to non-linear effects) of the classical Brillouin sensor in terms of long distance range measurements. The identified nonlinear effects are pump depletion due to SBS itself, self-phase modulation (SPM), modulation instability (MI), which occurs only in fibres presenting an anomalous dispersion at the pump wavelength and Raman scattering (RS). We propose the modeling of the pump depletion effect to obtain analytical expressions that are useful for the proper design of a BOTDA sensor and for the determination of a very small depletion. The model confirmed by experimental measurements is informative on the conditions maximizing the depletion effect; therefore a standard configuration can be defined to test the value of the depletion in the set-up. Furthermore, we demonstrate that SPM-induced spectral broadening can have a significant effect on the measured effective gain linewidth. Modeling and experiments have undoubtedly demonstrated that the effective gain linewidth can easily experience a two-fold increase in standard conditions when the pulse intensity profile is Gaussian. We showed that the problem can be practically circumvented by using a clean rectangular pulse with very sharp rising and falling edges. The theoretical and experimental analysis of the undesirable effects of MI and forward RS in distributed BOTDA sensors systems gives a simplified expression to predict the critical power for a given distance range. MI turns out to be the dominant nonlinear limitation since it shows the lowest critical power, but it is less critical since it can be avoided to a wide extent by using the fibre in the normal dispersion spectral region such as a DSF in the C-band. On the other hand Raman scattering can be avoided only by limiting the optical pump power and therefore is the ultimate nonlinear limitation in a distributed sensing system. Under similar conditions RS shows a critical power ∼5 times larger than MI. In the second part, we present the new approach Brillouin echo distributed sensing (BEDS) which has proved to be a powerful solution to realize sub-metric spatial resolutions in Brillouin distributed measurements. We have demonstrated both theoretically and experimentally that an optimized configuration is reached when the optical wave is π-phase shifted. The experimental tests have shown a spatial resolution down to 5 cm, with a clear margin for further improvement down to a real centimetric spatial resolution. This optimized configuration produce the best contrast independently of the pulse intensity, with a factor 2 of improvement compared to other techniques based on the same approach (dark pulse, bright pulse). This extends the dynamic range by 3 dB, which corresponds in standard loss conditions to a 5 km extension of the sensing range. An analytical developed model has proved to be an excellent tool not only for optimizing the pumping scheme but also in post-processing the measured data. Finally the potentialities of BEDS technology provide solutions in real contexts. Using the BEDS technology in landslide monitoring at laboratory scale, for the first time it became possible to observe the failure propagation in laboratory scale with an accurate precision. Furthermore, using BEDS we have proposed and demonstrated the possibility of mapping geometrical structure fluctuations along a photonic crystal fibre (PCF). Both long- and short-scale longitudinal fluctuations in the Brillouin frequency shift have been identify and quantify. Observation of Brillouin linewidth broadening in PCF fibre through distributed measurement of the Brillouin gain spectrum using BEDS has allowed fundamental understanding of SBS in PCF fibre and in their design in view of applications to optical-strain/temperature sensing.

EPFL2011

Opto-acoustic coupling and Brillouin phenomena in microstructure optical fibers

Stella Foaleng Mafang, Duc Minh Nguyen, Luc Thévenaz

Like photonic crystals have revolutionized the way of manipulating optical waves at the sub-micron scale, phononic crystals have more recently played similar decisive role for sound waves, or more generally elastic waves. Then, the idea of coupling light and sound in purposely designed microstructures is now emerging. In this respect, the periodic, wavelength-scale (for both optic and high-frequency acoustic waves) transverse air-hole microstructure of photonic crystal fibers (PCFs) provides additional degrees of freedom for light-sound interactions. PCFs can indeed exhibit photonic and phononic bandgap effects, allowing for tight confinement and joint waveguiding of both types of waves [1]. Electrostriction-driven Brillouin phenomena, namely backward Stimulated Brillouin Scattering (SBS) and forward Guided Acoustic Wave Brillouin Scattering (GAWBS), constitute an important category of such opto-acoustic coupling. The geometry of PCFs can dramatically modify the Brillouin spectrum, the gain and the stimulated Brillouin threshold, globally yielding much richer opto-acoustic dynamics and spectral features than in conventional fibers [2-11]. Specific transverse or longitudinal guided acoustics modes in the 100 MHz-10 GHz range can thus be selectively excited, resonantly enhanced and tightly confined within the microstructure, with an intimate dependence on its μm or sub-μm geometry. All these specific features have great potential for developing novel PCF-based distributed Brillouin sensors [6,7,12-14], for high-resolution longitudinal mapping of the intrinsic fluctuations of the fiber microstructure [15], and more generally for developing original tools of optical signal processing [1-4,9,16,17]. This talk will give a comprehensive overview of these original behaviors in a range of PCFs.

IEEE2012

Brillouin Echoes for Advanced Distributed Sensing in Optical Fibres

Stella Foaleng Mafang

EPFL2011