Optimization of ZnO Front Electrodes for High-Efficiency Micromorph Thin-Film Si Solar Cells

The quest for increased performances in thin film silicon Micromorph tandem devices nowadays requires an increase of current density. This can be achieved with thin cells by combining both a robust cell design and efficient light management schemes. In this work we identify three key requirements for the transparent conductive oxide electrodes. Firstly, strong light scattering into large angles is needed on the entire useful wavelength range: a front electrode texture with large enough features is shown to grant a high total current (typically >26 mA/cm2 with a 2.4 μm thick absorber material) while sharp features are reported to allow for high top cell current (>13 mA/cm2) and reduced reflection at the ZnO/Si interface. Secondly, sufficiently smooth substrate features are needed to guarantee a high quality of the silicon active material, ensuring good and stable electrical properties (typically Voc around 1.4 V). Thirdly, conduction and transparency of electrodes must be cleverly balanced, requiring high TCO mobility (~50 cm2/V/s) to maintain the sheet resistance below 30 Omega/sq while keeping absorption as low as possible. Optimization of these three key requirements using ZnO electrodes allowed us to realize high efficiency Micromorph devices with 13.5% initial and 11.5% stabilized efficiency.

L'oxyde de zinc par dépôt chimique en phase vapeur comme contact électrique transparent et diffuseur de lumière pour les cellules solaires

Sylvie Faÿ

Zinc oxide (ZnO) is a material that belongs to the family of Transparent Conductives Oxides (TCO). Its non-toxicity and the abundant availability in the Earth's crust of its components make it an ideal candidate as electrical transparent contact for thin-film amorphous and/or microcrystalline silicon solar cells. The Low-Pressure Chemical Vapour Deposition (LP-CVD) method allows one to obtain rough ZnO layers, which can effectively scatter the light that passes through them. This high scattering capacity increases the path of the light within the solar cell and therefore enhances its probability to be absorbed by the solar cell, and consequently the photogenerated current. This thesis work studies in detail the LP-CVD technology used for deposition of ZnO layers, which are employed as TCO layers for amorphous, microcrystalline and "micromorph" (microcrystalline/amorphous tandem) solar cells developped at the Institute of Microtechnology of the University of Neuchâtel. The chapter 3 is a detailed study of the growth of ZnO layers on a glass substrate. This study reveals a columnar microstructure of the ZnO layers, which are composed of large conical monocrystals. The tops of these monocrystals emerge at the surface of the ZnO layers as pyramids, which give to such layers their rough aspect and therefore their capacity of scattering the light. The two following chapters represent a study of the effect of variations in deposition parameters on the optical properties (transparency and scattering power), electrical properties (conductivity), and structural properties of ZnO layers. The deposition parameters varied thereby are the various gas flows, the substrate temperature, and the process pressure. In particular, a strong influence of the substrate temperature on the microstructure of the ZnO layers is observed. A variation of ten degrees of this deposition temperature leads to abrupt variations of the optical and electrical properties of the layers. From these various studies, a strong correlation is established, between the scattering power, the electrical properties, and the microstructure of the ZnO layers deposited by LP-CVD: The higher the pyramidal grains at the surface of the layers, the higher the scattering capacity of these layers. The larger the monocrystals within the bulk of the layers, the higher the mobility of the free electrons. This enhanced mobility leads to an increase of the conductivity of the layers. Finally, the chapter 6 of this thesis work describes the various situations where LP-CVD ZnO layers are used as transparent electrical contacts and light scattering layers in thin-film silicon solar cells. It is schown that, by incorporating ZnO layers developped in this work in the photovoltaic devices, an increase of 8% in the photogenerated current is obtained, compared to the performances of solar cells using standard commercially available TCO.

EPFL2003

Micromorph thin-film silicon solar cells with transparent high-mobility hydrogenated indium oxide front electrodes

Christophe Ballif, Loris Barraud, Corsin Battaglia, Adrian Billet, Mathieu Gérard Boccard, Grégory Bugnon, Stefaan De Wolf, Matthieu Despeisse, Laura Ding, Jordi Escarre Palou, Franz-Josef Haug, Karin Söderström

We investigate the performance of hydrogenated indium oxide as a transparent front electrode for micromorph thin-film silicon solar cells on glass. Light trapping is achieved by replicating the morphology of state-of-the-art zinc oxide electrodes, known for their outstanding light trapping properties, via ultraviolet nanoimprint lithography. As a result of the high electron mobility and excellent near-infrared transparency of hydrogenated indium oxide, the short-circuit current density of the cells is improved with respect to indium tin oxide and zinc oxide electrodes. We assess the potential for further current gains by identifying remaining sources of parasitic absorption and evaluate the light trapping capacity of each electrode. We further present a method, based on nonabsorbing insulating silicon nitride electrodes, allowing one to directly relate the optical reflectance to the external quantum efficiency. Our method provides a useful experimental tool to evaluate the light trapping potential of novel photonic nanostructures by a simple optical reflectance measurement, avoiding complications with electrical cell performance.

American Institute of Physics2011

Low-Pressure Chemical Vapor Deposited Zinc Oxide Films

Laura Ding

Polycrystalline zinc oxide (ZnO) films, prepared by low-pressure chemical vapor deposition are investigated in this thesis. ZnO belongs to the class of transparent conductive oxide materials, as it is transparent to light from the visible to the near-infrared range and is simultaneously electrically conductive. These two properties allow ZnO films to be integrated in thin-film silicon solar cells, as well as other opto-electronic devices. In particular, thin-film solar cells require a contact layer covering the whole active layer in order to efficiently collect the photogenerated electrical current, and therefore, the film electrode at the front of the cell has to be a window to the sunlight, in addition to being able to transport current. ZnO’s electrical conductivity is usually improved by doping with impurities like boron, but the film transparency is reduced, and consequently, the current that the solar cell can produce decreases. Thus, the first point investigated in this thesis is to find ways to relax the trade-off between transparency and conductivity. Instead of doping, which increases the electron concentration, the electron mobility has to be improved. To do so, the electron transport is first studied and modeled for standard films, in order to better define and understand its limitations. Then, a new way of preparing ZnO bilayer films is shown to lead to enhanced transparency and light scattering, for a maintained conductivity compared to uniformly doped films. Alternatively, various treatments (hydrogen plasma, vacuum annealing and ultraviolet exposure) are tested, all of which reduce the density of defects that cause electron scattering in the ZnO; treated films present an improved conductivity and very high mobilities close to 60 cm2V−1s−1, which corresponds to the mobility value in single crystals of equivalent doping. In addition, these films absorb less than 2% of the visible-to-infrared light, which makes them very promising ultra-transparent electrodes, for solar cells or other applications. For use in thin-film silicon solar cells, two additional criteria have to be met besides trans- parency and conductivity. First, because the front electrode is also the substrate for the deposition of the rest of the cell layers, its surface morphology has to be favorable to the growth of silicon. Moreover, this surface has to present a rough texture capable of diffusing and trapping the light into the cell, and increasing its chance of being absorbed. These charac- teristics can be incompatible, but are nevertheless necessary to reach thin-film solar cells with high efficiencies. So, the second point of interest of this thesis is to adapt the surface of ZnO layers by investigating their preparation method. Combinations of different growth regimes in multilayers are proposed to enable a smoother controllable of the surface without resort to additional etching treatments, leading to improved solar cell electrical performance. Finally, the stability of ZnO films exposed to various conditions that modify their electrical and optical properties is investigated. First, ZnO is exposed to different oxidizing conditions (storage and annealing in air, exposure to moisture, plasma of carbon dioxide). The loss in conductivity from the interaction of the oxygen species with ZnO is characterized by a new infrared spectroscopic method and a hydrogen plasma treatment is investigated as a means to reverse or partially prevent the degradation in conductivity. Then, the effect of simulated sunlight exposure on ZnO film properties in solar cells is investigated. The resistivity of the front ZnO electrode decreases due to ultraviolet light absorption, and the resistivity of the back electrode increases due to the chemisorption of oxygen species, in absence of ultraviolet light. The front electrode transparency is also degraded; this effect is more pronounced for doped ZnO and its impact on the current photogeneration of solar cells is demonstrated. Therefore, a specific optimization of the front and back electrodes appears necessary. This thesis contributes on the one side to an in-depth understanding of the opto-electrical properties of ZnO films prepared by low-pressure chemical vapor deposition. On the other side, the different proposed approaches enable more flexibility in the development of more efficient and stable electrodes, not only for solar cells, but for many other applications such as electroluminescent diodes, flat-panel displays, touch-screens or transparent transistors.