Nanomechanical Modeling of the Bending Response of Silicon Nanowires
Graph Chatbot
Chattez avec Graph Search
Posez n’importe quelle question sur les cours, conférences, exercices, recherches, actualités, etc. de l’EPFL ou essayez les exemples de questions ci-dessous.
AVERTISSEMENT : Le chatbot Graph n'est pas programmé pour fournir des réponses explicites ou catégoriques à vos questions. Il transforme plutôt vos questions en demandes API qui sont distribuées aux différents services informatiques officiellement administrés par l'EPFL. Son but est uniquement de collecter et de recommander des références pertinentes à des contenus que vous pouvez explorer pour vous aider à répondre à vos questions.
During casting, thermally induced deformations give birth to ingot distortions and residual stresses. For some high strength alloys, ingot cracking can happen during casting per se or during cooling down. Ingot distortions such as rolling face pull-in, but ...
Aim: To study the specificity of cellular MRI based on superparamagnetic iron oxide particles (SPIOs), especially within the CNS. Materials & methods: A microglial cell line was engineered for the expression of a suicide gene, the receptor of diphtheria to ...
Molecular nanoelectronics is attracting much attention, because of the possibility to add functionalities to silicon-based electronics by means of intrinsically nanoscale biological or organic materials. The contact point between active molecules and elect ...
Thermally-induced residual stresses, generated during the industrial Direct Chill casting process of aluminum alloys, can cause both significant safety concerns as well as the formation of defects during down-stream processing. Although these thermally ind ...
In this paper, we report for the first time making multi-gate buckled self-aligned dual Si nanowires including two sub-100 nm cross-section cores on bulk Si substrate using optical lithography, hard mask/spacer technology and local oxidation. 0.8 GPa uniax ...
Institute of Electrical and Electronics Engineers2012
Polycrystalline materials with crystallite diameters below hundred nanometer exhibit extraordinary strength which goes along with a decrease in ductility. In order to tailor tough materials, which combine strength and ductility, the underlying deformation ...
Punching shear reinforcement is an efficient method to increase not only the strength but also the deformation capacity of flat slabs supported by columns. Especially, the increase in deformation capacity is desired so that the load can be distributed to o ...
Seeking light and transparent bridge designs, engineers and architects have found an efficient and artistic way to fulfill their requirements: steel tubular bridges. In these modern tubular truss bridges, welded K-joints have been shown to be critically su ...
Fatigue crack growth observed in tubular K-joint specimens, typical of tubular bridge structures, always initiates at the chord crown toe locations whether the applied stress range is tensile or compressive. Even though other locations around the weld have ...
We derive a three-dimensional constitutive theory accounting for length-scale dependent internal residual stresses in crystalline materials that develop due to a non-homogeneous spatial distribution of the excess dislocation (edge and screw) density. The s ...