Electrical properties and microstructural evolution of porous Pb1-xCaxTiO3 pyroelectric thin films
Graph Chatbot
Chattez avec Graph Search
Posez n’importe quelle question sur les cours, conférences, exercices, recherches, actualités, etc. de l’EPFL ou essayez les exemples de questions ci-dessous.
AVERTISSEMENT : Le chatbot Graph n'est pas programmé pour fournir des réponses explicites ou catégoriques à vos questions. Il transforme plutôt vos questions en demandes API qui sont distribuées aux différents services informatiques officiellement administrés par l'EPFL. Son but est uniquement de collecter et de recommander des références pertinentes à des contenus que vous pouvez explorer pour vous aider à répondre à vos questions.
We report here on an integrated mini-lamp module (15x26x4 mm3) with a microfabricated rf-powered Rb dielectric barrier discharge (DBD) lamp (10x10x3 mm3) positioned on top of a 0.6 mm thick (thickness adjustable) 4-layer LTCC (Low Temperature Co-fired Cera ...
Minority ion cyclotron resonance heating is studied using the self-consistent numerical model SCENIC. This model includes 3D geometries with full shaping and anisotropic pressure effects, warm contributions to the dielectric tensor and full orbit effects. ...
Brookite titanium dioxide (TiO2) nanorods, synthesized by a surfactant-assisted aminolysis route, were used as precursors for the fabrication of thin films by using the matrix-assisted pulsed-laser deposition (MAPLE) technique. Thin films with controllable ...
The optimization of powders preparation and consolidation process leads to the achievement of a high thermoelectric figure of merit (ZT=1.25 at 800°C) in an n-type silicon-germanium (SiGe) alloy hot pressed at low heating rate. It has been experimentally o ...
Master sintering curve (MSC) was used as a practical approach to analyse the sintering behavior of an ultrafine alumina powder. Non-isothermal sintering was carried out at three heating rates. The concept of the MSC has been used to investigate the effect ...
The densification and grain growth of bodies made from a commercial ultrafine alumina powder was investigated. The primary powder was initially subjected to dry (uniaxial cold pressing) and wet shaping (slip casting), followed by conventional (CS)-, two st ...
Dynamic Mechanical Analysis was conducted on a polyurethane adhesive at different constant heating rates up to 100°C, covering the glass transition range. Different storage modulus degradation curves were obtained from different heating rates. The differen ...
A decomposition model for resin in glass fiber-reinforced polymer composites (GFRP) under elevated and high temperature was derived from chemical kinetics. Kinetic parameters were determined by four different methods using thermal gravimetric data at diffe ...
Radio frequency (RF) heating experiments have recently been conducted in JET (He-3)-H plasmas. This type of plasmas will be used in ITER's non-activated operation phase. Whereas a companion paper in this same PPCF issue will discuss the RF heating scenario ...
In the present study, the sintering behavior of a commercial nano alumina powder with an initial particle size of 100 nm was investigated. The shrinkage response of the powder formed by pressure filtration (PF) during non-isothermal sintering was measured ...