Publication

Preliminary safety analysis of the TRANSMUTEX sub-critical reactor using the GeN-Foam multi-physics solver

Publications associées (30)

High brightness neutron source optimized for very high pulsed magnetic field experiments

Conducting neutron scattering experiments in the presence of high pulsed magnetic fields, namely above 40 T, provides valuable information about the magnetic structures of materials. However, these experiments are challenging and time-consuming because the ...

EPFL2024

HighNESS conceptual design report: Volume I

Mina Akhyani, Xiaoxue Han, Davide Campi, Sheng Xu

The European Spallation Source, currently under construction in Lund, Sweden, is a multidisciplinary international laboratory. Once completed to full specifications, it will operate the world's most powerful pulsed neutron source. Supported by a 3 million ...

Ios Press2023

Gamma-Blind Fast Neutron Detection for Spent Nuclear Fuel Characterization

Alexander Wolfertz

In this thesis, the development and testing of a system for measuring the axial distribution of fast neutron emission of spent nuclear fuel rods is presented. Emphasis is placed on the novel fast neutron detector used which can reliably work in extremely h ...

EPFL2023

HighNESS conceptual design report: Volume II. The NNBAR experiment

Mina Akhyani, Xiaoxue Han, Davide Campi, Sheng Xu

A key aim of the HighNESS project for the European Spallation Source is to enable cutting-edge particle physics experiments. This volume presents a conceptual design report for the NNBAR experiment. NNBAR would exploit a new cold lower moderator to make th ...

Ios Press2023

Delayed Hydride Cracking in Irradiated and Unirradiated Zircaloy-2 Cladding

Aaron William Colldeweih

Zirconium alloys used in the nuclear industry are exposed to extreme conditions undergoing high levels of irradiation damage and corrosion. Zircaloy-2 is used as nuclear fuel cladding in boiling water reactors and for the encapsulation of the spallation ta ...

EPFL2022

Design, prototyping, and thermo-mechanical modelling of a neutron spallation target impacted by high-energy proton-beam pulses in the n_TOF facility at CERN

Raffaele Esposito

This manuscript describes the design work and the R&D activities carried out for the third-generation neutron production target in the neutron Time-Of-Flight (n_TOF) facility at the European Laboratory for Particle Physics (CERN). The facility is composed ...

EPFL2022

Data-Driven Predictive Models: Calculational Bias in Characterization of Spent Nuclear Fuel

Characteristics of the spent nuclear fuel (SNF) are typically calculated, requiring validation a priori. The validation process relies on the difference between calculations and measurements, namely the bias. Usually, predicting the bias based on benchmark ...

EPFL2022

Development of a Novel Finite Volume Methodology for Multi-Dimensional Fuel Performance Applications

Alessandro Scolaro

Fuel performance codes are an essential tool for ensuring the safe and economic opera-tion of nuclear reactors. Traditionally, these codes have been developed following a simple 1.5-D modelling approach, where the fuel behavior is simplified by assuming ax ...

EPFL2021

Investigation on the effect of eccentricity for fuel disc irradiation tests

Andreas Pautz, Carlo Fiorina, Alessandro Scolaro

A varying degree of eccentricity always exists in the initial configuration of a nuclear fuel rod. Its impact on traditional LWR fuel is limited as the radial gap closes relatively early during irradiation. However, the effect of misalignment is expected t ...

2021

Interface Tracking Investigation of the Sliding Bubbles Effects on Heat Transfer in the Laminar Regime

Konstantin Mikityuk, Lubomír Bures

Helium gases are utilized to remove fission products from the molten salt fast reactor (MSFR) core during operation. Helium gases and other volatile fission products may be introduced into the intermediate heat exchanger channels. The effect of these gases ...

2022