Infiltration is the process by which water on the ground surface enters the soil. It is commonly used in both hydrology and soil sciences. The infiltration capacity is defined as the maximum rate of infiltration. It is most often measured in meters per day but can also be measured in other units of distance over time if necessary. The infiltration capacity decreases as the soil moisture content of soils surface layers increases. If the precipitation rate exceeds the infiltration rate, runoff will usually occur unless there is some physical barrier.
Infiltrometers, parameters and rainfall simulators are all devices that can be used to measure infiltration rates.
Infiltration is caused by multiple factors including; gravity, capillary forces, adsorption, and osmosis. Many soil characteristics can also play a role in determining the rate at which infiltration occurs.
Precipitation can impact infiltration in many ways. The amount, type, and duration of precipitation all have an impact. Rainfall leads to faster infiltration rates than any other precipitation event, such as snow or sleet. In terms of amount, the more precipitation that occurs, the more infiltration will occur until the ground reaches saturation, at which point the infiltration capacity is reached. The duration of rainfall impacts the infiltration capacity as well. Initially when the precipitation event first starts the infiltration is occurring rapidly as the soil is unsaturated, but as time continues the infiltration rate slows as the soil becomes more saturated. This relationship between rainfall and infiltration capacity also determines how much runoff will occur. If rainfall occurs at a rate faster than the infiltration capacity runoff will occur.
The porosity of soils is critical in determining the infiltration capacity. Soils that have smaller pore sizes, such as clay, have lower infiltration capacity and slower infiltration rates than soils that have large pore sizes, such as sands. One exception to this rule is when the clay is present in dry conditions.
This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.
Le cours est une introduction aux Sciences du sol. Il a pour but de présenter les principales caractéristiques, propriétés et fonctions des sols. Il fait appel à des notions théoriques mais également
"Hydrology for Engineers" is an introduction to the study of floods, droughts and a fair distribution of water. The course will introduce basic hydrologic concepts and methods: probability and statist
Sustainable freshwater and urban drainage system are considered.
For fresh water, the capture, reservoir and net are discussed.
For the drainage, hydrology as well as the individual conduit and manh
Water content or moisture content is the quantity of water contained in a material, such as soil (called soil moisture), rock, ceramics, crops, or wood. Water content is used in a wide range of scientific and technical areas, and is expressed as a ratio, which can range from 0 (completely dry) to the value of the materials' porosity at saturation. It can be given on a volumetric or mass (gravimetric) basis. Volumetric water content, θ, is defined mathematically as: where is the volume of water and is equal to the total volume of the wet material, i.
Surface runoff (also known as overland flow or terrestrial runoff) is the unconfined flow of water over the ground surface, in contrast to channel runoff (or stream flow). It occurs when excess rainwater, stormwater, meltwater, or other sources, can no longer sufficiently rapidly infiltrate in the soil. This can occur when the soil is saturated by water to its full capacity, and the rain arrives more quickly than the soil can absorb it. Surface runoff often occurs because impervious areas (such as roofs and pavement) do not allow water to soak into the ground.
Groundwater recharge or deep drainage or deep percolation is a hydrologic process, where water moves downward from surface water to groundwater. Recharge is the primary method through which water enters an aquifer. This process usually occurs in the vadose zone below plant roots and is often expressed as a flux to the water table surface. Groundwater recharge also encompasses water moving away from the water table farther into the saturated zone. Recharge occurs both naturally (through the water cycle) and through anthropogenic processes (i.
Connectivity between the hyporheic zone and the flow is essential for the development of benthos and the reproductive success of spawning fish. The infiltration of fine sediment leads to clogging of the riverbed, reducing porosity and vertical water exchan ...
2023
, , , ,
Stream periphytons are candidate ecosystem engineers in proglacial margins. Here, we quantify the extent to which they are engineers for the case of hillslope-fed tributaries in the terrace zones of proglacial margin alluvial plains. Candidate ecosystem en ...
WILEY2023
,
The ecological effects of dams on sediment and river flow have been subject to an increasing attention, leading to the implementation of mitigation measures such as environmental flow release and sediment replenishment. However, fine sediment dynamics have ...