Catherine DehollainShe got the Master Degree in Electrical Engineering in 1982 from EPFL. Then, she worked in Geneva up to 1990 as a Senior Design Engineer in telecommunications at the European research center of Motorola. From 1990 up to 1995, she did her PhD thesis at the Chaire des Circuits et Systemes at EPFL in the domain of impedance broadband matching circuits. Since 1995, she is responsible at EPFL for the RFIC group. She has participated to different Swiss research projects as well as European projects dedicated to data communication of sensors nodes (e.g. MuMoR, Minami European projects) as well as remote powering of sensor nodes. Her main domains of interest are telecom applications (e.g. Impulse radio Ultra-Wide Band, super-regenerative receivers, RFIDs)as well as biomedical applications. She has been the coordinator of European projects (e.g. FP6 SUPREGE, FP7 Ultrasponder)and of Swiss projects (e.g. CAPED CTI project, NEURO-IC SNF project).
Nico de RooijNico de Rooij is Professor Emeritus of EPFL and previous Vice-President of CSEM SA. He was Professor of Microengineering at EPFL and Head of the Sensors, Actuators and Microsystems Laboratory (
SAMLAB
) from 2009 to 2016. At
CSEM SA
he was responsible for the EPFL CSEM coordination from 2012 to 2016. His research activities include the design, micro fabrication and application of miniaturized silicon based sensors, actuators, and microsystems. He authored and coauthored over 400 published
journal papers
in these areas.
He was Professor at the University of Neuchatel and Head of the Sensors, Actuators and Microsystems Laboratory (SAMLAB) from 1982 to 2008. Since October 1990 till October 1996 and again from October 2002 until June 2008, he has been the director of the Institute of Microtechnology of the University of Neuchatel (IMT UniNE). He lectured at the Swiss Federal Institute of Technology, Zurich (ETHZ), and since 1989, he has been a part-time professor at the Swiss Federal Institute of Technology, Lausanne (EPFL). He has been appointed Vice-President of the CSEM SA in February 2008 and headed the newly created Microsystems Technology Division of CSEM SA, from 2008 until 2012. He was Director of EPFL's Institute of Microengineering (EPFL STI IMT) from 2009 to 2012, following the transfer of IMT Uni-NE to EPFL.
Dr. de Rooij is a Fellow of the IEEE and Fellow of the Institute of Physics (UK). He recieved the IEEE
Jun-Ichi Nishizawa Gold Medal
, the Schlumberger Prize as well as the
MNE Fellow Award 2016
. He was awarded a Visiting Investigatorship Program (VIP) in MEMS/NEMS Systems by the
A*STAR Science and Engineering Council (SERC)
, Singapore, hosted by
SIMTech
, for the period 2005-2008.
Prof. de Rooij is Corresponding Member of the
Royal Netherlands Academy of Arts and Sciences
and Individual Member of the
Swiss Academy of Engineering Sciences
.
He has been serving on the Editorial Boards of the
IEEE/ASME Journal of Microelectromechanical Systems (IEEE JMEMS)
,
the IEEE proceedings
,
the Journal of Micromechanics and Microengineering, JM & M,
,
the Sensors and Actuators
,and
Sensors and Materials
. He was Member of the Information and Communication technology jury of the BBVA Foundation Frontiers of Knowledge Awards from 2009 to 2012.
Dr. de Rooij is (or was) Member of numerous international steering committees of conference series as well as
technical paper review panels including the steering committee of the International Conference on Solid-State
Sensors and Actuators and of Eurosensors. He acted as European Program Chairman of Transducers '87 and General Chairman of Transducers '89, Montreux, Switzerland.
He has supervised more than 70 Ph.D. students, who have successfully completed their
Ph.D. thesis.
He received his M.Sc. degree in physical chemistry from the State University of Utrecht, The Netherlands, in 1975, and a Ph.D. degree from Twente University of Technology, The Netherlands, in 1978. From 1978 to 1982, he worked at the Research and Development Department of Cordis Europa N.V., The Netherlands.
Jeremy Luterbacher
- Masters degree in Chemical Engineering obtained in 2007 at the Swiss Federal Institute of Technology, Lausanne (EPFL) (enrolled fall 2005, currently in 3rd semester). Relevant courses: Advanced Separation Processes, Advanced Chemical Reaction Engineering, Process Development and Polymer Chemistry and Macromolecular Engineering. - Bachelors degree in Chemistry and Chemical Engineering obtained in 2005 at the Swiss Federal Institute of Technology, Lausanne (EPFL). Relevant courses: Transport phenomena, Separation processes, Process command, Applied Energetics, Chemical Reaction Engineering, Chemical Kinetics, Quantum chemistry and Thermodynamics. - High school Maturity completed at the Nyon High School, 2002 (major subjects: biology-chemistry, advanced math, and Latin). Maturity essay completed 12-2001 with distinction - Secondary School certificate obtained in 1999 at the Gland secondary School, Latin-Greek section
François AvellanProf. François Avellan, director of the EPFL Laboratory for Hydraulic Machines, graduated in Hydraulic Engineering from Ecole nationale supérieure d'hydraulique, Institut national polytechnique de Grenoble, France, in 1977 and, in 1980, got his doctoral degree in engineering from University of Aix-Marseille II, France. Research associate at EPFL in 1980, he is director of the EPFL Laboratory for Hydraulic Machines since 1994 and, in 2003, was appointed Ordinary Professor in Hydraulic Machinery. Supervising 37 EPFL doctoral theses, he was distinguished by SHF, Société hydrotechnique de France, awarding him the "Grand Prix 2010 de l'hydrotechnique". His main research domains of interests are hydrodynamics of turbine, pump and pump-turbines including cavitation, hydro-acoustics, design, performance and operation assessments of hydraulic machines. Prof. Avellan was Chairman of the IAHR Section on Hydraulic Machinery and Systems from 2002 to 2012. He has conducted successfully several Swiss and international collaborative research projects, involving key hydropower operators and suppliers, such as:
-
Coordination for the FP7 European project n° 608532 "HYPERBOLE: HYdropower plants PERformance and flexiBle Operation towards Lean integration of new renewable Energies" (2013-2017);
-
Deputy Head of the Swiss Competence Center for Energy Research – Supply of Electricity (SCCER-SoE) to carry out innovative and sustainable research in the areas of geo-energy and hydropower for phase I (2013-2016) and Phase II (2017, 2010) to be approved.
-
EUREKA European research projects: N° 4150 and N° 3246, "HYDRODYNA, Harnessing the dynamic behavior of pump-turbines", (2003-2011), N° 1605, "FLINDT, Flow Investigation in Draft Tubes", http://flindt.epfl.ch/, (1997-2002). N° 2418, "SCAPIN, Stability of Operation of Francis turbines, prediction and modeling";
-
Swiss KTI/CTI research projects with GE Renewable Energy (anc. ALSTOM Hydro), Birr, ANDRITZ Hydro, Kriens, FMV, Sion, Groupe E, Granges-Paccot, Power Vision engineering, Ecublens and SULZER Pumps, Winterthur.
-
ETH Domain, HYDRONET Project for the Competence Center Energy and Mobility, PSI Villingen.
Furthermore, he is involved in scientific expertise and independent contractual experimental validations of turbines and pump turbines performances for the main hydropower plants in the world. In recognition for his work as Convenor of the TC4 working group of experts in editing the IEC 60193 standard he received the "IEC 1906 Award" from the International Electrotechnical Commission. Harry GuggerHarry Gugger started his professional career as a toolmakers apprentice from 1973 to 1977. From 1984 to 1989 he studied architecture at the Swiss Federal Institute of Technology in Zurich (ETHZ) with Flora Ruchat and at Columbia University, New York with Tadao Ando. He received his degree in architecture at ETH Zurich in 1990. In the same year he began his collaboration with Herzog & de Meuron (HdeM) when he was their assistant at the summer school in Karlsruhe. From 1991 to 2009 he was a partner of the firm. During his partnership Harry Gugger was, among many other projects, in charge of Tate Modern in London (1995-2000); the Headquaters for Prada USA in New York (2000-2002) and the Schaulager Basel for the Laurenz Foundation (1998-2003). His last projects at HdeM included CaixaForum, Madrid (20012008), Tate Modern Extension, London (2004- ) and KMOMA, The Kolkata Museum of Modern Art, Kolkata (2008- ). The Laban Dance Centre in London (1998-2003) was awarded the RIBA Stirling Prize 2003. In 2004 Harry Gugger received the Swiss Art Award Prix Meret Oppenheim.
His academic career started as visiting professor at the Hochschule für Architektur und Bauwesen in Weimar in 1994. From 2000-2006 he was an External Examiner at the AA School of Architecture in London. In 2001 he was a visiting professor at the Swiss Federal Institute of Technology in Lausanne (EPFL). 2005 Harry Gugger became full professor for architectural design at the EPFL, where he founded the Laboratory for Architectural Production (lapa). His laboratory was in charge of the National Participation of Bahrain Reclaim at the Venice Architecture Biennale 2010 winning the Golden Lion award. In 2011 Harry Gugger transformed his laboratory into Laboratoire Bâle (laba) a satellite laboratory of the EPFL situated in Basel and dedicated to urban and architectural design.
From 1999-2007 Harry Gugger was a member of the cityscape commission in Basel and was on the board of trustees of the Swiss Architecture Museum from 2004-2007. 2010 he became a member of the board of trustees of the Holcim Foundation for Sustainable Construction. The same year he founded his new practice Harry Gugger Studio.
Martinus GijsMartin A.M. Gijs received his degree in physics in 1981 from the Katholieke Universiteit Leuven, Belgium and his Ph.D. degree in physics at the same university in 1986. He joined the Philips Research Laboratories in Eindhoven, The Netherlands, in 1987. Subsequently, he has worked there on micro-and nano-fabrication processes of high critical temperature superconducting Josephson and tunnel junctions, the microfabrication of microstructures in magnetic multilayers showing the giant magnetoresistance effect, the design and realisation of miniaturised motors for hard disk applications and the design and realisation of planar transformers for miniaturised power applications. He joined EPFL in 1997. His present interests are in developing technologies for novel magnetic devices, new microfabrication technologies for microsystems fabrication in general and the development and use of microsystems technologies for microfluidic and biomedical applications in particular.
