In telecommunications, triple play service is a marketing term for the provisioning, over a single broadband connection, of two bandwidth-intensive services, broadband Internet access and television, and the latency-sensitive telephone. Triple play focuses on a supplier convergence rather than solving technical issues or a common standard. However, standards like G.hn might deliver all these services on a common technology. Quadruple play A so-called quadruple play (or quad play) service integrates mobility as well, often by supporting dual mode mobile plus hotspot-based phones that shift from GSM to Wi-Fi when they come in range of a home wired for triple-play service. Typical Generic Access Network services of this kind, such as Rogers Home Calling Zone (Rogers is an incumbent in the Canadian market), allow the caller to enter and leave the range of their home Wi-Fi network, and only pay GSM rates for the time they spend outside the range. Calls at home are routed over the IP network and paid at a flat rate per month. No interruption or authorization for the shift is required—soft handoff takes place automatically as many times as the caller enters or leaves the range. By about 2000, cable TV companies were in a technical position to offer triple play over one physical medium to a large number of their customers, as their networks already had sufficient bandwidth to carry hundreds of video channels. Cable's main competition for television in North America came from satellites, which could not compete for voice and interactive broadband due to the latency imposed by physical laws on a geosynchronous satellite—sometimes up to one full second of delay between speaking and being heard. Cable's main competition for voice and Internet access came from telcos, which were not yet able to compete for television in most markets because DSL over most local loops could not provide enough bandwidth.

About this result
This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.
Related lectures (1)
Related publications (4)

PerfIso: Performance Isolation for Commercial Latency-Sensitive Services

Sameh Mohamed Elnikety, Calin Iorgulescu

Large commercial latency-sensitive services, such as web search, run on dedicated clusters provisioned for peak load to ensure responsiveness and tolerate data center outages. As a result, the average load is far lower than the peak load used for provision ...
The USENIX Association2018

PerfIso: Performance Isolation for Commercial Latency-Sensitive Services

Sameh Mohamed Elnikety, Calin Iorgulescu

Large commercial latency-sensitive services, such as web search, run on dedicated clusters provisioned for peak load to ensure responsiveness and tolerate data center outages. As a result, the average load is far lower than the peak load used for provision ...
USENIX ASSOC2018

Raman-based distributed optical fiber temperature sensors: industrial applications and future developments

Marcelo Alfonso Soto Hernandez

This book chapter describes Raman Based Distributed Optical Fiber Sensors and their main industrial applications. In particular, after a brief introduction on the basic physical mechanisms, and a theoretical description of distributed optical fiber sensors ...
World Scientific Publishing Co. Pte. Ltd2014
Show more
Related concepts (16)
Modem
A modulator-demodulator or modem is a computer hardware device that converts data from a digital format into a format suitable for an analog transmission medium such as telephone or radio. A modem transmits data by modulating one or more carrier wave signals to encode digital information, while the receiver demodulates the signal to recreate the original digital information. The goal is to produce a signal that can be transmitted easily and decoded reliably.
G.hn
G.hn is a specification for home networking with data rates up to 2 Gbit/s and operation over four types of legacy wires: telephone wiring, coaxial cables, power lines and plastic optical fiber. A single G.hn semiconductor device is able to network over any of the supported home wire types. Some benefits of a multi-wire standard are lower equipment development costs and lower deployment costs for service providers (by allowing customer self-install). G.
DOCSIS
Data Over Cable Service Interface Specification (DOCSIS) is an international telecommunications standard that permits the addition of high-bandwidth data transfer to an existing cable television (CATV) system. It is used by many cable television operators to provide cable Internet access over their existing hybrid fiber-coaxial (HFC) infrastructure. DOCSIS was originally developed by CableLabs and contributing companies, including Arris, BigBand Networks, Broadcom, Cisco, Comcast, Conexant, Correlant, Cox, Harmonic, Intel, Motorola, Netgear, Terayon, Time Warner Cable, and Texas Instruments.
Show more

Graph Chatbot

Chat with Graph Search

Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.

DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.