Are you an EPFL student looking for a semester project?
Work with us on data science and visualisation projects, and deploy your project as an app on top of Graph Search.
Concept
Laser drilling
Summary
Laser drilling is the process of creating thru-holes, referred to as “popped” holes or “percussion drilled” holes, by repeatedly pulsing focused laser energy on a material. The diameter of these holes can be as small as 0.002” (~50 μm). If larger holes are required, the laser is moved around the circumference of the “popped” hole until the desired diameter is created.
Laser drilling is one of the few techniques for producing high-aspect-ratio holes—holes with a depth-to-diameter ratio much greater than 10:1.
Laser-drilled high-aspect-ratio holes are used in many applications,
including the oil gallery of some engine blocks, aerospace turbine-engine cooling holes,
laser fusion components, and printed circuit board micro-vias.
Manufacturers of turbine engines for aircraft propulsion and for power generation have benefited from the productivity of lasers for drilling small (0.3–1 mm diameter typical) cylindrical holes at 15–90° to the surface in cast, sheet metal and machined components. Their ability to drill holes at shallow angles to the surface at rates of between 0.3 and 3 holes per second has enabled new designs incorporating film-cooling holes for improved fuel efficiency, reduced noise, and lower NOx and CO emissions.
Incremental improvements in laser process and control technologies have led to substantial increases in the number of cooling holes used in turbine engines. Fundamental to these improvements and increased use of laser drilled holes is an understanding of the relationship between process parameters and hole quality and drilling speed.
Following is a summary of technical insights about the laser drilling process and the relationship between process parameters and hole quality and drilling speed.
Laser drilling of cylindrical holes generally occurs through melting and vaporization (also referred to as "ablation") of the workpiece material through absorption of energy from a focused laser beam.
The energy required to remove material by melting is about 25% of that needed to vaporize the same volume, so a process that removes material by melting is often favored.
Official source
About this result
This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.
Related people (5)
Related units (1)