Summary
Co-fired ceramic devices are monolithic, ceramic microelectronic devices where the entire ceramic support structure and any conductive, resistive, and dielectric materials are fired in a kiln at the same time. Typical devices include capacitors, inductors, resistors, transformers, and hybrid circuits. The technology is also used for robust assembly and packaging of electronic components multi-layer packaging in the electronics industry, such as military electronics, MEMS, microprocessor and RF applications. Co-fired ceramic devices are fabricated using a multilayer approach. The starting material is composite green tapes, consisting of ceramic particles mixed with polymer binders. The tapes are flexible and can be machined, for example, using cutting, milling, punching and embossing. Metal structures can be added to the layers, commonly using filling and screen printing. Individual tapes are then bonded together in a lamination procedure before the devices are fired in a kiln, where the polymer part of the tape is combusted and the ceramic particles sinter together, forming a hard and dense ceramic component. Co-firing can be divided into low-temperature (LTCC) and high-temperature (HTCC) applications: low temperature means that the sintering temperature is below , while high temperature is around . The lower sintering temperature for LTCC materials is made possible through the addition of a glassy phase to the ceramic, which lowers its melting temperature. Due to a multilayer approach based on glass-ceramics sheets, this technology offers the possibility to integrate into the LTCC body passive electrical components and conductor lines typically manufactured in thick-film technology. This differs from semiconductor device fabrication, where layers are processed serially, and each new layer is fabricated on top of previous layers. Co-fired ceramics were first developed in the late 1950s and early 1960s to make more robust capacitors. The technology was later expanded in the 1960s to include multilayer structures similar to printed circuit boards.
About this result
This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.
Related courses (1)
MICRO-618: Soft Microsystems Processing and Devices
Amongst others, following topics will be covered during the course:
  • Soft Microsystems and Electronics
  • Electroactive polymers
  • Printed electronics and microsystems
  • Inkjet printing of polymers
Related lectures (2)
Micromixers: Lamination and Serial Mechanisms
Explores micromixers' design, operation, and serial mechanisms for efficient mixing in microreactors.
Low-power Radio Design: Introduction and Passive RF Circuits
Covers the basics of IoT wireless communication, passive RF circuits, energy efficiency, and impedance matching for low-power radio design.
Related publications (62)

3D Printing of Customizable Transient Bioelectronics and Sensors

Danick Briand, Nicolas Francis Fumeaux

Transient electronics have emerged as a new category of devices that can degrade after their functional lifetime, offering tremendous potential as disposable sensors, actuators, wearables, and implants. Additive manufacturing methods represent a promising ...
2024

First developments towards producing inductive magnetic sensors using state-of-the-art photolithography techniques

Duccio Testa, Ambrine Douhane, Marcus Cemes

Inductive magnetic sensors are needed for tokamak operation to provide the low-frequency (LF) measurements leading to the equilibrium reconstruction and to monitor the higher frequency (HF) instabilities; the HF magnetic sensors are often also used as a ba ...
2023

A 3D-Printed Functional Mems Accelerometer

Luis Guillermo Villanueva Torrijo, Damien Maillard, Göran Stemme, Simone Pagliano

3D printing of MEMS devices could enable the cost-efficient production of custom-designed and complex 3D MEMS for prototyping and for low-volume applications. In this work, we present the first micro 3D-printed functional MEMS accelerometers using two-phot ...
IEEE2023
Show more