Category 5 cable

Related publications (11)

About
Privacy
Disclaimer

Graph Chatbot

Experimental Characterization of the Response of an Electrical and Communication Raceway to IEMI

Farhad Rachidi-Haeri, Marcos Rubinstein, Nicolas Mora Parra

This paper reports the results of two experimental campaigns aimed at studying the high-frequency response of a raceway containing low voltage power, telephone, and Ethernet cables, to external electromagnetic field illumination. The raceway was tested aga ...

Institute of Electrical and Electronics Engineers2016

Bipolar Lightning Flashes Observed at the Säntis Tower: Do We Need to Modify the Traditional Classification?

Mario Paolone, Marcos Rubinstein, Mohammad Azadifar, Farhad Rachidi-Haeri, Davide Pavanello

We present and discuss current waveforms associated with 13 bipolar lightning flashes recorded at the Santis Tower during the period from June 2010 to January 2015. During this period, a total of 427 flashes were recorded, of which 13 (3%) were classified ...

American Geophysical Union2016

Test of the MF-CICC Conductor Designed for the 12-T Outsert Coil of the HFML 45-T Hybrid Magnet

Pierluigi Bruzzone, Kamil Sedlák, Boris Stepanov

A 45-T hybrid magnet is being built at the High Field Magnet Laboratory of the Radboud University in Nijmegen, The Netherlands. The hybrid magnet consists of a 12-T cable-in- conduit-conductor (CICC) Nb 3Sn superconducting outsert and a 33-T resistive inse ...

IEEE Institute of Electrical and Electronics Engineers2016

Numerical Simulation of the Overall Transfer Impedance of Shielded Spacecraft Harness Cable Assemblies

Farhad Rachidi-Haeri, Nicolas Mora Parra

In this paper, we present general considerations for the application of the multiconductor transmission-line theory for simulating shielded spacecraft harness cable assemblies. Some of the practical issues that occur in the modeling process of various comp ...

Institute of Electrical and Electronics Engineers2015

Impact of Cable Twist Pitch on T-cs-Degradation and AC Loss in Nb3Sn Conductors for ITER Central Solenoids

Pierluigi Bruzzone, Kamil Sedlák, Boris Stepanov

The performance of tour Nb3Sn conductors for the ITER central solenoids was tested. The current sharing temperatures (T-cs) were measured over approximately 9000 electromagnetic cycles, including two or three thermal cycles between 4.2 K and room temperatu ...

IEEE Institute of Electrical and Electronics Engineers2014

Design and Strand Tests of a Fusion Cable Composed of Coated Conductor Tapes

Pierluigi Bruzzone, Davide Uglietti, Rainer Wesche

The design of a flat cable suitable for future fusion reactors has been carried out. The cable consists of twisted round strands, which are composed of tapes stacked between copper profiles. According to calculations, the strand twist pitch and the cable t ...

IEEE Institute of Electrical and Electronics Engineers2014

Manufacture of ITER feeder sample conductors

Pierluigi Bruzzone, Bo Liu, Hongwei Li

The ITER feeders are the components that connect the ITER magnet systems located inside the main cryostat to the cryogenics, power-supply and control system interfaces outside the cryostat. The feeder busbars rely on the Cable-In-Conduit Conductor (CICC) d ...

Elsevier Science Sa2013

Test of ITER conductors in SULTAN: an update

Pierluigi Bruzzone, Boris Stepanov, Rainer Wesche, Martin Vogel, Ciro Calzolaio

The ITER Toroidal Field (TF) conductor qualification phase has been carried out by testing short sample prototype conductors in the SULTAN test facility. This phase, started in 2007, has been substantially completed after minor adjustment of the conductor ...

2011

Review of design aspects for high current Nb3Sn conductors

Pierluigi Bruzzone

Cabled conductors based on Nb3Sn technology with operating current in the range of 20 kA and above are mainly restricted to fusion magnets and high field facilities. The experience of last decade has dramatically shown that, opposite to the NbTi conductors ...

2011

Successful performances of the EU-AltTF sample, a large size Nb3Sn cable-in-conduit conductor with rectangular geometry

Pierluigi Bruzzone

One of the design features which yet offers interesting margins for performance optimization of cable-in-conduit conductors (CICCs), is their geometry. For relatively small size Nb3Sn CICCs, operating at high electromagnetic pressure, such as those for the ...

2010

Page 1 of 2