Concept

Cathode-ray tube

Related publications (236)

Spectral prediction model for variable dot-size printers

By printing a variable number of droplets onto the same pixel location, ink jet printers produce pixels at variable dot-sizes yielding several darkness levels. Varying the number of printed droplets affects the ink volume deposited onto the substrate. In t ...

2008

Acrylated Hyperbranched Polymer Photoresist for Ultra-Thick and Low-Stress High Aspect Ratio Micropatterns

Yves Leterrier, Lars Schmidt

Different photocurable acrylates, including two hyperbranched monomers, are compared with an epoxy negative-tone photoresist (SU-8) with respect to their suitability for the fabrication of ultra-thick polymer microstructures in a photolithographic process. ...

Institute of Physics2008

Diffusion of electron-hole pairs in disordered quantum wires

Elyahou Kapon, Alok Rudra, Benjamin Dwir, Daniel Oberli, Nicolas Moret

The diffusivity of photogenerated electron-hole pairs in weakly disordered GaAs/AlGaAs V-groove quantum wires was measured using a photoluminescence (PL) time-of-flight technique. It is shown that the electron-hole pair diffusion is thermally activated abo ...

American Institute of Physics2008

Impact of Lateral Nonuniform Doping and Hot Carrier Injection on Capacitance Behavior of High Voltage MOSFETs

Mihai Adrian Ionescu, Michel Declercq, Yogesh Singh Chauhan

A detailed analysis of capacitance behavior of high-voltage MOSFET (HV-MOS), for example, LDMOS, using device simulation is made. The impact of lateral nonuniform doping and drift region are separately analyzed. It is shown that the peaks in C-GD and C-GS ...

2008

Modification of Conductivity and of Mechanical Properties of Electroactive Polymer (EAP) Thin Films by Titanium Ion Implantation

Herbert Shea, Samuel Rosset, Muhamed Niklaus

We present a study of the influence on Youngs modulus, stress and electrical conductivity of poly-dimethylsiloxane membranes implanted with titanium ions at energies from 5 to 35 keV, with doses up to 8x10^16 ions/cm2. The motivation for this study was to ...

Materials Research Society2008

Colloidal strategies for preparing oxide-based hybrid nanocrystals

Raffaella Buonsanti

A review. Recent progress of colloidal chem. in the prepn. of multimaterial nanostructures incorporating transition-metal oxides is reviewed. Attention is focused on the emerging class of hybrid nanocrystals (HNCs), in which domains of different materials ...

2008

Local current measurement in a solid oxide fuel cell repeat element

Daniel Favrat, Jan Van Herle, Nordahl Autissier, Diego Larrain

A planar solid oxide fuel cell repeating unit, 50 cm2 in total active electrode size, consisting of an anode supported electrolyte cell bearing two 7 mm holes for fuel and air injection, and contacted to two dense metal current collector plates ...

2007

Flow pattern based two-phase frictional pressure drop model for horizontal tubes, Part II: New phenomenological model

John Richard Thome, Jesus Moreno Quiben

This work presents an analytical investigation of two-phase pressure drops during evaporation in horizontal tubes. Based on a comprehensive state-of-the-art review and comparison with two-phase frictional pressure drop prediction methods, it is proven that ...

2007

Falling Films on Horizontal Tubes with R-134a, Part II: Flow Visualization, Onset of Dryout and Heat Transfer Predictions

John Richard Thome, Jean-François Roques

In tune with the falling film evaporation heat transfer test results described in Part 1, flow visualization of the boiling process and intertube flow mode transitions from droplet to column and sheet flows have been observed, and the onset of dryout resul ...

2007

Effect of particle size on LiMnPO4 cathodes

Paul Bowen, Nam Hee Kwon

LiMnPO4 was synthesized using a sol–gel method and tested as a cathode material for lithium ion batteries. After calcination at temperatures between 520 and 600 ◦C, primary particle sizes in the range of 140–220 nm were achieved. Subsequent dry ball millin ...

2007

Graph Chatbot

Chat with Graph Search

Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.

DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.