Advancing towards well-controlled full-wafer nanostencil lithography
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
A method is described to control the thickness of single-crystal silicon membranes, fabricated by wet anisotropic etching. The technique of an electrochemical etch-stop on an epitaxial layer is used to yield better thickness control over the silicon membra ...
This paper describes the design, fabrication and experimental results of a new, low cost, high-performance silicon micropump developed for a disposable drug delivery system. The pump chip demonstrates linear and accurate (+/-5%) pumping characteristics for ...
We compare three different approaches to high-resolution contact lithography with special emphasis on contrast mechanisms for subwavelength structures. Masks with protruding metal absorbers, masks with absorbers embedded in the transparent background, and ...
A carbon-based interdigitated electrode array (IDA) was fabricated by photolithographic patterning of RF sputtered thin-film carbon layers. The IDAs consisted of 125 pairs having the finger width of 2.5 μm and 1.5 μm gap. The electrochemical behavior of th ...
A new approach for the realization Of true 3D polymer structures is presented in this paper. It consists in adding, in a post-processing microstereolithography step, 3D polymer microstructures on top of a micropart patterned by means of planar processes su ...
This paper presents the fabrication of a microchemical chip for the detection of fluorescence species in microfluidics. The microfluidic network is wet-etched in a Borofloat 33 (Pyrex) glass wafer and sealed by means of a second wafer. Unlike other similar ...
A new approach for the realization of true 3D polymer structures is presented in this paper. It consists in adding, in a post-processing microstereolithography step, 3D polymer microstructures on top of a micropart patterned by means of planar processes su ...
This paper describes single and two layer processes to realize thick resist moulds (40 and 80 μm) with a good reproducibility. The patterning of a thick AZ 4562 photoresist layer is performed with standard photolithography equipment. Different problems rel ...
Selective Ga + ion implantation and miring by focused ion beam exposure and subsequent wet chemical etching is used to fabricate micro/nanomechanical elements in Si. Freestanding elements with a ~ 30 nm membrane thickness are made by controlled selective u ...
A method for on-wafer fabrication of free-chlorine sensors is described. The sensor structure consists of a planar three-electrode electrochemical cell covered with a poly(hydroxyethyl methacrylate) hydrogel membrane. This membrane is photolithographically ...
